Tài liệu Cisco Press CCIE Practical Studies CCIE Practice Lab: “The lab, the bad, the ugly Solutions” ppt

... 255.255.255.224 encapsulation frame-relay ip ospf priority 0 Cisco Press CCIE Practical Studies CCIE Practice Lab: “Darth Reid Solutions” Solutions brought to you by K L A SS B Y ... K L A SS B Y CCIE Practical Studies Darth Reid Copyright 2002 Skyline Computer Corp. All Rights Reserved. 10 26 Feb 2002 Initial Configuration: Access Server ! Cisc...

Ngày tải lên: 18/01/2014, 05:20

... 1/0/0 connection plar 2001 ! voice-port 1/0/1 ! dial-peer cor custom ! ! ! Cisco Press CCIE Practical Studies CCIE Practice Lab: “Enchilada Solutions” Solutions brought to you by K L A SS B Y ... K L A SS B Y CCIE Practical Studies Enchilada Copyright 2002 Skyline Computer Corp. All Rights Reserved. 18 31 Jan 2002 Solution: Router3 ! ! Cisco P...

Ngày tải lên: 18/01/2014, 05:20

... K L A SS B Y CCIE Practical Studies The Lab, the Bad, the Ugly Copyright 2002 Skyline Computer Corp. All Rights Reserved. 2 31 Jan 2002 Cisco Press CCIE Practical Studies CCIE Practice Lab: The ... K L A SS B Y CCIE Practical Studies The Lab, the Bad, the Ugly Copyright 2002 Skyline Computer Corp. All Rights Reserved. 23 31...

Ngày tải lên: 18/01/2014, 05:20

... path with the lowest MED attribute. 8. If the paths have the same MED, prefer the external path over the internal path. 9. If the paths are still the same, prefer the path through the closest ... a destination: 1. If the path specifies a next hop that is inaccessible, drop the update. 2. Prefer the path with the largest weight. 3. If the weights are the same, pre...

Ngày tải lên: 21/12/2013, 19:15

... drop the update. 2 Prefer the path with the largest weight. 3 If the weights are the same, prefer the path with the largest local preference. 4 If the local preferences are the same, prefer the ... If the origin codes are the same, prefer the path with the lowest MED attribute. 8 If the paths have the same MED, prefer the external path over the internal pat...

Ngày tải lên: 24/01/2014, 19:20

... a transmit path and the other as a receive path. Therefore, the transmit fiber on one switch device should connect to the receive fiber on the other end. The remainder of the Catalyst switch families ... on the other RJ-45 connector, pin 2 goes to pin 7, and so forth. In other words, the cable remains flat while the two RJ-45 connectors point in opposite directions. To conne...

Ngày tải lên: 21/12/2013, 04:19

... with the same layer’s software or hardware on other computers. In some cases, the other computer is connected to the same media; in other cases, the other computer is on the other end of the ... for the next token. Step 3 If the token is free, mark the token as a busy token, append the data, and send the data onto the ring. Step 4 When the header with the busy t...

Ngày tải lên: 21/12/2013, 06:15

... switch in the middle of the network. If you put the root bridge in the center of the network with direct connection to the servers and routers, you generally reduce the average distance from the ... Construction features, such as trunking and EtherChannel. However, do not overlook the other ports; they, too, are significant because they connect users in the network. Figur...

Ngày tải lên: 27/01/2014, 13:20

... heading Practical study for Chapter 1: Setting Up’ should read, “These labs are for your own personal challenge when preparing for the CCIE Lab Exam, and answers are supplied on the Cisco Press ... 11-1, refer to the notes in the book. Page 675 – Regarding Figure 11-2, refer to the notes in the book. Page 691 – Delete the last sentence on the page. Page 704 – The fi...

Ngày tải lên: 18/01/2014, 04:20

... been authenticated by some other method, do not run PPP authentication. D. If the user is not configured to run PPP authentication, do not run PPP authentication. E. If the user knows the enable ... tacacs if- authenticated This lines in the config mean that the vty lines are to use tacacs first but the timeout expires and authentication then goes to the local database If-aut...

Ngày tải lên: 10/12/2013, 22:15