Tài liệu Lab 11 2 4 Protocol Inspector, TCP and HTTP doc

... Lab 11. 2. 4 Protocol Inspector, TCP and HTTP Objective The objective of this lab is to use Protocol Inspector, or equivalent software, to view dynamic Transmission Control Protocol (TCP) ... • TCP handshakes • TCP acknowledgments • TCP segmentation and segment size • TCP sequence numbers • TCP sliding windows • HTTP protocol 1 - 2 CCNA...

Ngày tải lên: 18/01/2014, 05:20

... address 1 92. 168. 14 .2 Subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92. 168. 14. 1 b. Host 2 IP address 1 92. 168. 14. 3 Subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92. 168. 14. 1 Step 3 Save the configuration ... 1 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 11. 2. 3 Copyright  20 03, Cisco Systems, Inc. Step 2 Configure the hosts on the Ethernet...

Ngày tải lên: 18/01/2014, 05:20

... to the Basic Switch Configuration lab. 1 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7 .2. 4 Copyright  20 03, Cisco Systems, Inc. Step 2 Configure the hosts attached to ... version 12. 0 or version 12. 1. Once the steps are complete, logoff, by typing exit, and turn all the devices off. Then remove and store the cables and adapter. 4 - 5 CCNA 3...

Ngày tải lên: 11/12/2013, 14:15

... 1 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1 .2. 4 Copyright  20 03, Cisco Systems, Inc. Lab 1 .2. 4 Converting RIP v1 to RIP v2 Objective • Configure ... proper command mode and configure RIP routing on the Gadsden router according to the chart. 2 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1 .2. 4 Copyright ...

Ngày tải lên: 21/12/2013, 19:15

... BHM(config-router)#version 2 BHM(config-router)#exit BHM(config)#exit 2 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1 .2. 4 Copyright  20 03, Cisco Systems, Inc. Step ... 1700, 25 00 and 26 00 or any such combination can be used. Please refer to the chart at the end of the lab to correctly identify the interface identifiers to be used based o...

Ngày tải lên: 21/12/2013, 19:15

... address 1 92. 168. 14 .2 Subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92. 168. 14. 1 b. Host 2 IP address 1 92. 168. 14. 3 Subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92. 168. 14. 1 Step 3 Save the configuration ... 2: Routers and Routing Basics v 3.0 - Lab 11. 2. 1 Copyright  20 03, Cisco Systems, Inc. Step 2 Configure the hosts on the Ethernet segment a....

Ngày tải lên: 21/12/2013, 19:15

... address 1 92. 168. 14 .2 Subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92. 168. 14. 1 b. Host 2 IP address 1 92. 168. 14. 3 Subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92. 168. 14. 1 Step 3 Save the configuration ... CCNA 2: Routers and Routing Basics v 3.0 - Lab 11. 2. 1a Copyright  20 03, Cisco Systems, Inc. Lab 11. 2. 1a Configuring Standard Access Lis...

Ngày tải lên: 21/12/2013, 19:15

... 1 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 11. 2. 1b Copyright  20 03, Cisco Systems, Inc. Lab 11. 2. 1b Standard ACLs Objective Plan, configure, and apply a standard ACL ... security and performance concerns. Standard ACL need to be implemented as a simple and effective tool to control traffic 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 -...

Ngày tải lên: 21/12/2013, 19:15

... off. Then remove and store the cables and adapter. 4 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 6 .2. 4 Copyright  20 03, Cisco Systems, Inc. Erasing and Reloading the ... static 00e0 .29 17.18 84 interface fastethernet 0 /4 vlan 1 29 00: ALSwitch(config)#mac-address-table static 00e0 .29 17.18 84 fastethernet 0 /4 vlan 1 1900: 3 - 5...

Ngày tải lên: 18/01/2014, 04:20

... Basics and Intermediate Routing v 3.0 - Lab 8 .2. 4 Copyright  20 03, Cisco Systems, Inc. Lab 8 .2. 4 Verifying VLAN Configurations Objective • Create a basic switch configuration and verify ... to the Basic Switch Configuration lab. 2 - 7 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 8 .2. 4 Copyright  20 03, Cisco Systems, Inc. Step 2 Config...

Ngày tải lên: 18/01/2014, 05:20