Tài liệu Lab 9 1 2 Gateway of Last Resort (Default Gateway) pdf
Tài liệu Lab 9.1.2 Gateway of Last Resort ppt
... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 2 Copyright 20 03, Cisco Systems, Inc.
Lab 9. 1. 2 Gateway of Last Resort
Objective
• Configure RIP ... the privileged exec mode.
3 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 2 Copyright 20 03, Cisco Systems, Inc.
c. What is the Gateway of last resort listed? __________...
Tài liệu Lab 9.1.2 Gateway of Last Resort (Default Gateway) pdf
...
Router 1 GAD 17 2 .16 .0 .1 DCE 17 2 .17 .0 .1 25 5 .25 5.0.0 class cisco
Router 2 BHM 17 2 .18 .0 .1 DTE 17 2 .17 .0 .2 255 .25 5.0.0 class cisco
Objective
• Configure RIP routing and add default routes (gateways) ...
Lab 9. 1. 2 Gateway of Last Resort (Default Gateway)
Router
Designation
Router
Name
FastEthernet 0
Address ... ____...
Tài liệu Lab 3.1.2 Command Modes and Router Identification docx
... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 2 Copyright 20 03, Cisco Systems, Inc.
Lab 3 .1. 2 Command Modes and Router Identification ... close out of the router.
GAD(config)#exit
Upon completion of the previous steps, logoff by typing exit. Turn the router off.
4 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 2 Copyright ... 800, 16...
Tài liệu Lab 3.1.2 Voltage Measurement pdf
... 1 - 3 CCNA 1: Networking Basics v 3.0 - Lab 3 .1. 2 Copyright 20 03, Cisco Systems, Inc.
Lab 3 .1. 2 Voltage Measurement
Objective
• Demonstrate ... will be required:
• Fluke 11 0, 12 B, or equivalent multimeter
• An assortment of batteries: A cell, C cell, D cell, 9 Volts, 6 V lantern
• Duplex wall outlet, typically 12 0v
• Power supply for ... electrical a...
Tài liệu Lab 3.1.2 Command Modes and Router Identification doc
... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 2 Copyright 20 03, Cisco Systems, Inc.
Lab 3 .1. 2 Command Modes and Router Identification ... 800, 16 00,
17 00, 25 00 and 26 00 routers, or a combination. Refer to the chart at the end of the lab to correctly
identify the interface identifiers to be used based on the equipment in the lab. ... 5 CCNA 2: R...
Tài liệu Lab 9.1.1 Using Show IP Route to Examine Routing Tables doc
...
BHM(config)#interface Serial1
BHM(config-if)#ip address 17 2. 22. 0 .2 255 .25 5.0.0
BHM(config)#no shutdown
d. On the BHM router remove the IGRP network statement network 17 2 .18 .0.0 so the router
IGRP 25 should ... 1 - 6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 1 Copyright 20 03, Cisco Systems, Inc.
Lab 9. 1. 1 Using Show IP Route to Examine Rou...
Tài liệu Lab 9.1.1 Using Show IP Route to Examine Routing Tables ppt
...
password
Enable/VTY/Console
passwords
Router 1 GAD 17 2 .16 .0 .1 DCE 17 2 .17 .0 .1 25 5 .25 5.0.0 class cisco
Router 2 BHM 17 2 .18 .0 .1 DTE 17 2 .17 .0 .2 255 .25 5.0.0 class cisco
Objective
• Setup IP an ...
BHM(config)#interface Serial1
BHM(config-if)#ip address 17 2. 22. 0 .1 25 5 .25 5.0.0
BHM(config)#no shutdown
d. On the BHM router remove the...
Tài liệu Lab 9.1.5a Trunking with ISL ppt
...
Ping from the host in Switch_A port 0 / 12 to the switch IP 19 2 .16 8 .1. 2.
4 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5a Copyright 20 03, Cisco Systems, Inc.
c. Was the ... with an unconfigured switch. Instructions are provided for the 29 0 0, 29 5 0, and 19 0 0 Series
switches.
29 0 0 and 29 5 0 Series Switches
1. Enter into the privileged...
Tài liệu Lab 9.1.5a Trunking with ISL docx
...
__________________________________________________________________
Ping from the host in Switch_A port 0 / 12 to the switch IP 19 2 .16 8 .1. 2.
a. Was the ping successful? ___________________________________________________ ...
___________________________________________________________________
Ping from the host in Switch_A port 0 / 12 to the switch IP 19 2 .16 8 .1. 2.
a. Was the...
Tài liệu Lab 9.1.5b Trunking with 802.1q pptx
... 0 / 12 to the switch IP 19 2 .16 8 .1. 2.
c. Was the ping successful?
___________________________________________________
4 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5b ... with an unconfigured switch. Instructions are provided for the 29 0 0, 29 5 0, and 19 0 0 Series
switches.
29 0 0 and 29 5 0 Series Switches
1. Enter into the privileged EXEC mo...