Tài liệu Lab 9 1 1 Using Show IP Route to Examine Routing Tables ppt

... passwords Router 1 GAD 17 2 .16 .0 .1 DCE 17 2 .17 .0 .1 255.255.0.0 class cisco Router 2 BHM 17 2 .18 .0 .1 DTE 17 2 .17 .0.2 255.255.0.0 class cisco Objective • Setup IP an addressing scheme using class ... Lab 9. 1. 1 Using Show IP Route to Examine Routing Tables Router Designation Router Name FastEthernet 0 Address Interface type ......

Ngày tải lên: 18/01/2014, 05:20

... 1 - 6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 1 Copyright  2003, Cisco Systems, Inc. Lab 9. 1. 1 Using Show IP Route to Examine Routing Tables Objective • Setup IP an addressing ... _________________________________________________ d. Stop the debug with no debug ip rip. Step 5 Show the routing tables for each router a. Examine t...

Ngày tải lên: 18/01/2014, 05:20

... 1 - 2 CCNA 2: Routers and Routing Basics v 3.0 - Lab 2.2 .1 Copyright  2003, Cisco Systems, Inc. Lab 2.2 .1 Router Configuration Using Setup Objective • Use ... the router has already been established. The following resources will be required: • PC with HyperTerminal configured • Console or rollover cable and DB -9 to RJ-45 adapter • Router Step 1 ... have to b...

Ngày tải lên: 21/12/2013, 19:15

... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 1. 2 Copyright  2003, Cisco Systems, Inc. Lab 9. 1. 2 Gateway of Last Resort Objective • Configure RIP routing and add default routes ... d. Type undebug all to turn off debugging. Step 5 Show the routing tables for each router a. Examine the routing table entries, by using show ip route comman...

Ngày tải lên: 18/01/2014, 05:20

... passwords Router 1 GAD 17 2 .16 .0 .1 DCE 17 2 .17 .0 .1 255.255.0.0 class cisco Router 2 BHM 17 2 .18 .0 .1 DTE 17 2 .17 .0.2 255.255.0.0 class cisco Objective • Configure RIP routing and add default routes ... d. Type undebug all to turn off debugging. Step 5 Show the routing tables for each router a. Examine the routing table entries, by using show ip...

Ngày tải lên: 18/01/2014, 05:20

... __________________________________________________________________ Ping from the host in Switch_A port 0 /12 to the switch IP 19 2 .16 8 .1. 2. 4 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5a Copyright  2003, Cisco Systems, Inc. c. ... 0/3 to the switch IP 19 2 .16 8 .1. 3. e. Was the ping successful? __________________________________________...

Ngày tải lên: 24/01/2014, 19:20

... Switch_A #show vlan b. Are prots 0 /10 through 0 /12 assigned to VLAN 30? _______________________________________ Step 11 Test the VLANs Ping from the host in Switch_A port 0 /12 to the host ... Intermediate Routing v 3.0 - Lab 9. 1. 5a Copyright  2003, Cisco Systems, Inc. Step 17 Move host Move the host in Switch_B from port 0 /12 to port 0/7. Wait until the port LED g...

Ngày tải lên: 24/01/2014, 19:20

... 0 /12 to the switch IP 19 2 .16 8 .1. 2. c. Was the ping successful? ___________________________________________________ 4 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5b ... 1 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 1. 5b Copyright  2003, Cisco Systems, Inc. Lab 9. 1. 5b Trunking with 802.1q Objective •...

Ngày tải lên: 24/01/2014, 19:20

... and Intermediate Routing v 3.0 - Lab 9. 1. 5b Copyright  2003, Cisco Systems, Inc. to VLAN 1 by default. This lab will also help demonstrate how VLANs can be used to separate traffic and reduce ... __________________________________________________________________ Ping from the host in Switch_A port 0 /12 to the switch IP 19 2 .16 8 .1. 2. a. Was the ping successful? _...

Ngày tải lên: 24/01/2014, 19:20

... Step 5 Show the routing tables for each router a. Examine the routing table entries, using command show ip route command on each router. Step 6 Check the routing table for a specific route (IOS ... Routers and Routing Basics v 3.0 - Lab 9. 1. 8 Copyright  2003, Cisco Systems, Inc. Step 8 Configure IGRP using AS number 10 1 on all routers. Leave RIP on all r...

Ngày tải lên: 24/01/2014, 19:20