Tài liệu Lab 2 3 1 Configuring the OSPF Routing Process pdf

... 1 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2. 3. 1 Copyright  20 03, Cisco Systems, Inc. Lab 2. 3. 1 Configuring the OSPF Routing Process Objective ... ospf 1 3 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2. 3. 1 Copyright  20 03, Cisco Systems, Inc. Berlin(config-router)#network 1 92....

Ngày tải lên: 18/01/2014, 04:20

... 1 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2. 3. 5 Copyright  20 03, Cisco Systems, Inc. Lab 2. 3. 5 Configuring OSPF Timers Objective ... at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 2 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2. 3. 5 Copyrig...

Ngày tải lên: 21/12/2013, 19:15

... to the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in lab. The configuration output used in this lab is produced from 1 7 21 series ... at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 1 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3....

Ngày tải lên: 21/12/2013, 19:15

... 1 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2. 3. 4 Copyright  20 03, Cisco Systems, Inc. Lab 2. 3. 4 Configuring OSPF Authentication Objective ... chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in lab. The configuration output used in this lab is produced from...

Ngày tải lên: 24/01/2014, 19:20

... continuing. 1 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2. 3. 4 Copyright  20 03, Cisco Systems, Inc. Step 1 Configure the routers On the routers, enter the global configuration ... typing exit and turn the router off. Then remove and store the cables and adapter. 3 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab...

Ngày tải lên: 24/01/2014, 19:20

... address 1 92. 16 8 . 31 .33 25 5 .25 5 .25 5 .25 5 5 - 8 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2. 3 .2 Copyright  20 03, Cisco Systems, Inc. Brasilia(config-router)#end Step 12 Save the ... London(config-if)#ip address 1 92. 16 8 . 31 .11 25 5 .25 5 .25 5 .25 5 London(config-router)#end Ottawa(config)#interface loopback 0 Ottawa(config-...

Ngày tải lên: 18/01/2014, 04:20

... AS 10 1 on GAD. Go to the proper command mode and enter the following: GAD(config)#router igrp 10 1 GAD(config-router)#network 1 92. 16 8 .22 .0 GAD(config-router)#network 1 92. 16 8 .20 .0 Step 3 ... the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output us...

Ngày tải lên: 11/12/2013, 14:15

... Enable/VTY/Console passwords Router 1 GAD 1 92. 16 8 .20 .1 DCE 1 92. 16 8 .22 .1 25 5 .25 5 .25 5.0 class cisco Router 2 BHM 1 92. 16 8 .25 .1 DTE 1 92. 16 8 .22 .2 255 .25 5 .25 5.0 class cisco Objective • Setup ... AS 10 1 on GAD. Go to the proper command mode and enter the following: GAD(config)#router igrp 10 1 GAD(config-router)#network 1 92. 1...

Ngày tải lên: 11/12/2013, 14:15

... address 13 8 .25 .6 .33 25 5 .25 5 .25 5 .25 5 ISP(config-if)#exit ISP(config)#ip route 1 92. 16 8 .1. 0 25 5 .25 5 .25 5.0 20 0 .20 .20 .2 ISP(config)#ip route 1 92. 16 8.0.0 25 5 .25 5 .25 5.0 20 0 .20 .20 .2 ISP(config)#end ... the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The...

Ngày tải lên: 21/12/2013, 19:15