Tài liệu Configuring Advanced Routing Protocols pdf

... updates and saving a neighbor’s routing table locally). ■ EIGRP has less network overhead, since it uses incremental updates. 24 Chapter 11: Configuring Advanced Routing Protocols CertPrs8 / CCNA Cisco ... in routing updates, and even terminate IP connections on them, like telnet. Here are some reasons you might want to create a loopback interface: 12 Chapter 11: Configuring Ad...

Ngày tải lên: 18/01/2014, 04:20

... back: ■ Update Contains a routing update ■ Query Asks a neighboring router to validate routing information ■ Reply Responds to a query message 26 Chapter 11: Configuring Advanced Routing Protocols CertPrs8 ... packet The following sections cover these commands. The show ip protocols Command The show ip protocols command displays all of the IP routing protocols that you hav...

Ngày tải lên: 18/01/2014, 04:20

... route to the 192.168.72.0 network. 1 - 3 Semester 5: Advanced Routing v2.0 - Lab 6.7.2 Copyright  2001, Cisco Systems, Inc. 6.7.2 Configuring EIGRP Fault Tolerance Fa0/0 192.168.72.1 ... 3 - 3 Semester 5: Advanced Routing v2.0 - Lab 6.7.2 Copyright  2001, Cisco Systems, Inc. Examine the debug eigrp fsm ... the event of link failure. Step 1 Build and configure the...

Ngày tải lên: 11/12/2013, 15:15

... Contents Configuring Exchange 2000 417 Configuring Front-end Exchange 2000 Servers 417 Configuring Recipient Policies 417 Configuring SMTP Connectors 420 Configuring Address Lists 421 Configuring ... Policies on Exchange 2000 191 Administering System Policies 192 Configuring Server Policy 192 Configuring Mailbox Store Policy 194 Configuring Public Store Policy 197 Administer...

Ngày tải lên: 21/12/2013, 05:17

Ngày tải lên: 24/12/2013, 10:18

... Phần 2 SQL Advanced (bài 12) SQL GROUP BY and HAVING Tập hợp functions (giống như lệnh SUM) thường cần

Ngày tải lên: 24/12/2013, 10:18

... show ip protocols command displays all of the IP routing protocols that you have configured and are running on your router. Here’s an example of this command: Router# show ip protocols Routing ... will have two routing tables: one for each. However, if you are running two routing protocols for a single routed protocol, such as IP RIPv1 and IGRP, your router will have only one...

Ngày tải lên: 18/01/2014, 04:20

... CCNA 4: WAN Technologies v 3.0 - Lab 5.2.2 Copyright  2003, Cisco Systems, Inc. Lab 5.2.2 Configuring Frame Relay PVC Objective • Configure two routers back-to-back as a Frame Relay

Ngày tải lên: 18/01/2014, 05:20

... Berlin(config-if)#frame-relay interface-dlci 302 Step 6 Configure IGRP routing To configure the routing protocol Interior Gateway Routing Protocol (IGRP) 100, use the following configuration syntax: ... Step 10 Check routing protocol a. Use the show ip route command to verify that the PVCs are up and active: Amsterdam#show ip route b. Is the routing protocol working? _...

Ngày tải lên: 18/01/2014, 05:20