Tài liệu Configuring Distance Vector Protocols docx

... column indicates a RIP route, while an I indicates an IGRP route. 26 Chapter 10: Configuring Distance Vector Protocols CertPrs8 / CCNA Cisco Certified Network Associate Study Guide / Deal / 222934-9 ... version Interface Send Recv Key-chain Ethernet0 1 1 2 Ethernet1 1 1 2 10 Chapter 10: Configuring Distance Vector Protocols CertPrs8 / CCNA Cisco Certified Network Associate Stu...

Ngày tải lên: 18/01/2014, 04:20

... regarding broadcasts and distance- vector protocols, you should be cautious when using RTMP in large AppleTalk network because RTMP sends out updates every 10 seconds and is a distance vector protocol. The ... means an administrator can take advantage of all the qualities of link-state protocols as opposed to distance- vector protocols. These qualities include faster convergenc...

Ngày tải lên: 21/12/2013, 19:15

... the preceding bullets. Also, classless protocols include the subnet mask value along with the route when advertising routing information: distance vector protocols do not include the subnet mask ... (not part of a routing loop). The advertised distance is the distance for a neighbor to reach a destination network, and the feasible distance is the distance for this router to re...

Ngày tải lên: 18/01/2014, 04:20

... advertised link, and the sequence number of the link. This is different from distance vector protocols. Distance vector protocols share their entire routing table with their neighbors with the exception ... each routed protocol. Advertised distance This is the distance (metric) that a neighboring router is advertising for a specific route. Feasible distance This is the dista...

Ngày tải lên: 18/01/2014, 04:20

... Guide 78-13943-01 Chapter 6 Configuring IPSec and Certification Authorities Manual Configuration of SAs Manually configuring SAs is very similar to the basic configuration described in Configuring IPSec.” The ... information that is specific for configuring IPSec in this configuration, refer to Chapter 8, Configuring VPN Client Remote Access.” Two different security protocols are in...

Ngày tải lên: 24/01/2014, 19:20

... feels, let's do a quick test. 2. Choose Control > Test Movie. < Day Day Up > Configuring Component Properties As you're well aware by now, most graphical elements used

Ngày tải lên: 14/12/2013, 22:15

... - 7 Semester 5: Advanced Routing v2.0 - Lab 7.5.1 Copyright  2001, Cisco Systems, Inc. 7.5.1 Configuring Distribute Lists and Passive Interfaces RIPv2 Full T1: 1.544 Mbps 19.2 Kbps Singapore AucklandSanJose3 Fa0/0 ... #show ip route 192.168.240.1 Routing entry for 192.168.240.0/30 Known via "connected", distance 0, metric 0 (connected, via interface) Redistributing via...

Ngày tải lên: 21/12/2013, 19:15

... ________________________________________________ c. Has the Layer 2 status changed? ______________________________________________ Step 7 Configuring ISDN SPIDs Depending on region, ISDN service profile identifiers (SPIDs) may have to

Ngày tải lên: 21/12/2013, 19:15

... Tokyo(config)#interface bri 0 Tokyo(config-if)#dialer-group 1 Tokyo(config-if)#end Step 5 Configuring DDR dialer information a. Configure the correct dialer information so that the dialer ... Tokyo(config-if)#dialer idle-timeout 120 Tokyo(config-if)#dialer map ip 192.168.3.2 name Moscow 5552000 Step 6 Configuring DDR Dialer Information Moscow#configure terminal Moscow(conf...

Ngày tải lên: 21/12/2013, 19:15