Tài liệu Datasheet - FO - HIGHLIGHT 12-24 Port Wallmount docx

... 01 0-0 0 12 Port ST . . . . . . . . . . . . . . . . . . . .6877 2 01 0-0 1 12 Port SC Duplex . . . . . . . . . . . . . .6877 2 01 0-0 2 24 Port SC . . . . . . . . . . . . . . . . . . .6877 2 01 0-0 3 24 ... 01 1-0 0 12 Port ST . . . . . . . . . . . . . . . . . . . .6877 2 01 1-0 1 12 Port SC Duplex . . . . . . . . . . . . . .6877 2 01 1-0 2 24 Port SC . . . . . . . ....

Ngày tải lên: 16/01/2014, 20:21

... KRONE HIGHLIGHT TM 12/24 Port Sliding Patch Panel

Ngày tải lên: 16/01/2014, 20:21

... KRONE HIGHLIGHT ® 24, 48 and 72 Port Patch Panels KRONE HIGHLIGHT ® 24, 48 and 72 Port Patch Panels KRONE HIGHLIGHT high density Patch Panels are suitable for installation in 19” ... density. The 24 port is one rack unit, 48 port two rack units and the 72 port three rack units in height. Designed for rear or side cable entry, the Patch Panels feature strain relief points for...

Ngày tải lên: 16/01/2014, 20:21

... KRONE HIGHLIGHT TM 12/24 Port Sliding Patch Panel

Ngày tải lên: 18/01/2014, 04:20

... HIGHLIGHT ® CSM and GP Indoor Fibre Cable See Network Performance in a New Light

Ngày tải lên: 16/01/2014, 20:21

... Resistance: EIA-FOTP-25B 50 Impacts 100 Impacts 50 Impacts 500 Impacts 500 Impacts Flexing: EIA-FOTP-104A 1000 Cycles 1000 Cycles 1000 Cycles 1000 Cycles 1000 Cycles Maximum Pulling Load: EIA-FOTP-33A ... 0°C and 70°C Cable Twist Test: EIA-FOTP-85A — — — 1000 Cycles 1000 Cycles Operating Temperature: -2 0°C to +70°C -2 0°C to +70°C 0°C to +70°C -2 0°C to +70°C (OFNR) -2 0°C to +70...

Ngày tải lên: 11/12/2013, 13:15

... PERFORMANCE AND TESTS 5.1 Temperature Range For the cables covered by this specification, the following temperature ranges apply: Operation : -2 0°C to +60°C Installation : -5 °C ... fiber breakage Temperature Cycling Test # Test method: TIA/EIA-FOTP-3 Temperature cycling schedule : 23°C → -2 0°C → 65°C → -2 0°C → 65°C Soak time at each temperature: 24hours...

Ngày tải lên: 20/12/2013, 21:16

... Outlets Fiber wall outlets for fiber to the user solutions Outlets presenting MT-RJ, ST or SC sockets for use in fiber-to-the-user applications. Fully managed double gang footprint for blown and conventional ... systems. Supplied with adapters. Simple installation for fusion splicing of pigtails or direct termination. Splice protector holders and break-out units are also ava...

Ngày tải lên: 20/12/2013, 21:16

... Fibre-optic Module Box FO- MB 12/24 KRONE GmbH Beeskowdamm 3-1 1 D-14167 Berlin Phone +49 30 845 3-1 422 Telefax +49 30 845 3-1 412 http://www.krone.com vertrieb@krone.com KRONE FiberPLUS ® ■ ... or in-house demarcation point ■ Box with double cover and two locks for seperate access of carrier and customer ■ Pre-assembled FO modules significantly reduce installation time ■ Low costs...

Ngày tải lên: 16/01/2014, 20:21

... protection in different environmental conditions. Excellent dimensional control for low splice loss. APPLICATIONS Suitable media for short distance transmission, such as local area network (Ethernet, ... (550 meter for 1000BaseSX and 1000BaseLX application) Numerical Aperture @ 0.200 ± 0.015 Optical Parameters • Attenuation (dB/km) Typical @ 850nm ≤ 3.5 @1300nm ≤ 1.0 • Bandwidth (MHz-km) Typ...

Ngày tải lên: 24/01/2014, 02:20