Tài liệu Automatic Transmissions P5 pdf

... POWER FLOW Automatic Transmissions - Course 262 77 PROCEDURE Drive Pinion Preload Perform the following procedures. ... it. Preload: In Lbs. Preload (at Starting) New Bearing Reused Bearing Spec. Measured POWER FLOW Automatic Transmissions - Course 262 51 Multiplate clutches and brakes were discussed in detail earlier, ... Clutch ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ Á ÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁÁ ÁÁÁÁÁÁÁÁÁÁÁÁÁÁ...

Ngày tải lên: 22/12/2013, 11:15

... design is basic to most all automatic transmissions in production today. Reverse Direction Direct Drive - (One-To-One Ratio) SIMPSON PLANETARY GEAR UNIT Automatic Transmissions - Course 262 The ... Ring Gear TorqueSpeed Rotational SIMPSON PLANETARY GEAR UNIT Automatic Transmissions - Course 262 SIMPSON PLANETARY GEAR UNIT Automatic Transmissions - Course 262 external gears are...

Ngày tải lên: 22/12/2013, 11:15

... Non-ECT transmissions. 4. Describe the effect of the pattern select switch on the upshift pattern. 5. Explain the effect of the neutral start switch in maintaining manual select positions in ECT transmissions. 6. ... the vehicle to operate. Section 10 ELECTRICAL CONTROL Lesson Objectives: ELECTRICAL CONTROL Automatic Transmissions - Course 262 151 This throttle position sensor convert...

Ngày tải lên: 22/12/2013, 11:15

Ngày tải lên: 12/12/2013, 06:15

... holding devices used in Toyota automatic transmissions. Section 1 FUNDAMENTALS OF AUTOMATIC TRANSMISSIONS Lesson Objectives Section 1 2 TOYOTA Technical Training Automatic transmissions can be basically ... drive automatics are the same. They share the same planetary gear train design which is used in all Toyota automatic transmissions and the majority of automatics in product...

Ngày tải lên: 12/12/2013, 11:15

... the converter is appropriate. Section 2 TORQUE CONVERTER Lesson Objectives TORQUE CONVERTER Automatic Transmissions - Course 262 15 There are two ways to test a torque converter. The first method ... specification, replace the converter. Stall Testing CAUTION Converter Installation TORQUE CONVERTER Automatic Transmissions - Course 262 17 When replacing a converter or installing a rema...

Ngày tải lên: 12/12/2013, 11:15

... turning machines which allow automatic chucking, indexing, feeding, spindle speed changes, and other work that has to be done by the operator on the engine lathe. These automatic lath- es represent ... Both single- and multiple-spin- dle automatics may be made up with vertical as well as horizontal spindle alignment. As far as the machining processes on an automatic lathe are concerned...

Ngày tải lên: 17/12/2013, 11:15

... the driver. The automatic transmission cannot select these positions automatically on its own. The next selector position is the only position from which the transmission is fully automatic. In ... vehicle speed and will downshift to second gear; however, in Electronic Control Transmissions and on A40 and A340 series transmissions with a D−2 Downshift Timing Valve, the transmission do...

Ngày tải lên: 22/12/2013, 11:15

... Toyota automatic transmissions. 3. Identify automatic transmission fluid conditions and their cause. Section 6 AUTOMATIC TRANSMISSION FLUID Lesson Objectives: AUTOMATIC TRANSMISSION FLUID Automatic ... have been used in Toyota automatic transmissions. Type T is the latest type to be used and is found in All−Trac transaxles (A241H and A540H). Type F was used in early Toyota aut...

Ngày tải lên: 22/12/2013, 11:15