... - 6 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 7. 3. 6 Copyright 20 03, Cisco Systems, Inc. Lab 7. 3. 6 Default Routing with RIP and IGRP Objective • Configure a default route and ... different method to propagate default information in IGRP. On Centre, issue the following commands: 4 - 6 CCNA 2: Routers and Routing Basics v 3. 0...
Ngày tải lên: 21/12/2013, 19:15
... Advanced Routing v2.0 - Lab 3. 6 .3 Copyright 2001, Cisco Systems, Inc. 3. 6 .3: Configuring Default Routing with RIP and IGRP Internet Vista SanJose2SanJose1 S0/1 192. 168 .2.1 /24 S0/0 192. 168 .2.2 ... 172 . 16. 0.0/ 16 in their tables. From Vista, ping 172 . 16. 1.1. This ping should be successful. 3 - 4 Semester 5: Advanced Routing v2.0 - Lab 3....
Ngày tải lên: 24/01/2014, 19:20
Tài liệu Lab 2.3.6 Propagating Default Routes in an OSPF Domain pdf
... 1 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2 .3. 6 Copyright 20 03, Cisco Systems, Inc. Lab 2 .3. 6 Propagating Default Routes in an OSPF Domain ... represents the ISP connection to the Internet. 4 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 2 .3. 6 Copyright 20 03, Cisco Systems, Inc. f. Can the loopb...
Ngày tải lên: 21/12/2013, 19:15
Tài liệu Lab 7.2.6 Troubleshooting RIP ppt
... steps, log off by typing exit and turn the router off. 3 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 7. 2 .6 Copyright 20 03, Cisco Systems, Inc. Erasing and reloading the router Enter ... this lab is produced from 172 1 series routers. Any other router used may produce a slightly different output. 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab...
Ngày tải lên: 11/12/2013, 14:15
Tài liệu Lab 7.2.6 Spanning Tree Recalculation docx
... Switch A Port # Switch B 1 2 3 4 5 6 7 8 9 10 11 3 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 7. 2 .6 Copyright 20 03, Cisco Systems, Inc. 12 Step 6 Remove a cable on the ... 1 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 7. 2 .6 Copyright 20 03, Cisco Systems, Inc. Lab 7. 2 .6 Spanning Tree Recalcul...
Ngày tải lên: 11/12/2013, 14:15
Tài liệu Lab 7.2.6 Troubleshooting RIP pdf
... steps, log off by typing exit and turn the router off. 2 - 4 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 7. 2 .6 Copyright 20 03, Cisco Systems, Inc. Erasing and reloading the router Enter ... 2 Configure the hosts with the proper IP address, subnet mask and default gateway Step 3 Make sure that routing updates are being sent a. Type the command debug ip r...
Ngày tải lên: 11/12/2013, 14:15
Tài liệu Lab 7.3.5 Configuring IGRP pptx
... 1 - 6 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 7. 3. 5 Copyright 20 03, Cisco Systems, Inc. Lab 7. 3. 5 Configuring IGRP Objective • Setup IP an addressing ... __________________________________________________________________________ 3 - 6 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 7. 3. 5 Copyright 20 03, Cisco Systems, Inc. d. What...
Ngày tải lên: 11/12/2013, 14:15
Tài liệu Lab 7.3.5 Configuring IGRP ppt
... steps, log off by typing exit and turn the router off. 4 - 6 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 7. 3. 5 Copyright 20 03, Cisco Systems, Inc. Erasing and reloading the router Enter ... show ip route for another network address on the router. 3 - 6 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 7. 3. 5 Copyright 20 03, Cisco Systems, Inc. g. Wha...
Ngày tải lên: 11/12/2013, 14:15