... RJ- 45 connector labeled Console .
Step 2 Identify the computer serial interface, which is COM 1 or 2
a. It should be a 9 or 25 - pin male connector labeled serial or COM1. It may or may not ... a name in the connection Name field and select OK.
1 - 6 CCNA 1: Networking Basics v 3.0 - Lab 5. 2. 7 Copyright 20 03, Cisco Systems, Inc.
Lab 5. 2. 7 Est...
...
help monitor builtin command help
history monitor command history
meminfo main memory information
repeat repeat a monitor command
reset system reset
set display the monitor variables
sysret ... point to be made here is that anyone with this procedure and access to a console
port on a router can change the password and take control of the router. That is why it is of cri...
... network and the packet was
forwarded through.
Step 11 Trace other IP addresses or domain names
Try tracert on other domain names or IP addresses and record the results. An example is
tracert ...
Step 12 Trace a local host name or IP address
Try using the tracert command with a local host name or IP address. It should not take long
because the trace does not pass through an...
... the router off
• Remove and store the cables and adapter
2 - 5 CCNA 4: WAN Technologies v 3.0 - Lab 5. 2. 1 Copyright 20 03, Cisco Systems, Inc.
Please refer to the chart at the end of the lab ... chart:
• The hostname
• The console
• The virtual terminal
• The enable passwords
If there is a problem completing this, refer to the Network Address Translation (NAT)...
... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 5. 2. 3 Copyright 20 03, Cisco Systems, Inc.
Lab 5. 2. 3 Managing Configuration Files with TFTP
Objective
• Backup a copy of a router ... important to keep backup copies of router
configuration files. These can be stored in a central location such as a TFTP server for reference and
retrieval if necessary....
... the router and the hub or switch will be accomplished using a Category
5 straight-through patch cable. Locate a patch cable that is long enough to reach from the router
to the hub. Be sure to ... Record the
information below. Record the AUI port numbers if a Cisco 25 0 0 series router is being used.
Router Port Port
Step 2 Identify the proper cables and con...