Tài liệu Lab 3 1 1 Safe Handling and Use of a Multimeter docx

... Lab 3. 1. 1 Safe Handling and Use of a Multimeter Objective • Learn how to use and handle a multimeter correctly. Background A multimeter is a powerful electrical testing tool that can ... media between networking devices. Prior to starting the lab, the teacher or lab assistant should have one multimeter available for each team, and various bat...

Ngày tải lên: 21/12/2013, 19:15

... Lab 3. 1. 1 Safe Handling and Use of a Multimeter Objective • Learn how to use and handle a multimeter correctly. Background A multimeter is a powerful electrical testing tool that can ... media between networking devices. Prior to starting the lab, the teacher or lab assistant should have one multimeter available for each team, and various bat...

Ngày tải lên: 18/01/2014, 04:20

... displayed on the above diagram may be used. For example, router series 800, 16 00, 17 00, 2500, and 2600 or any such combination can be used. Please refer to the chart at the end of the lab to ... remove and store the cables and adapter. 4 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 3. 2 .1 Copyright  20 03, Cisco Systems, Inc. Erasing and relo...

Ngày tải lên: 24/01/2014, 19:20

... Then remove and store the cables and adapter. 3 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 3. 2 .1 Copyright  20 03, Cisco Systems, Inc. Erasing and reloading the router ... IP address, subnet mask and default gateway a. Each workstation should be able to ping the attached router. Troubleshoot as necessary. Remember to assign a specific IP addre...

Ngày tải lên: 24/01/2014, 19:20

... > Save and exit Notepad. Step 11 Test the backup configuration a. Any form of backup that has not been tested could be a liability in a failure situation. This includes backup configurations. ... 1 - 7 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 2.9 Copyright  20 03, Cisco Systems, Inc. Lab 3. 2.9 Copying, Editing, and Pasting Configurations Objectiv...

Ngày tải lên: 24/01/2014, 19:20

... File/Save and exit Notepad. Step 11 Test the backup configuration a. Any form of backup that has not been tested could be a liability in a failure situation. This includes backup configurations. ... Name FastEthernet 0 Address Interface type Serial 0 Address Subnet mask for both interfaces Enable secret password Enable/VTY/Console passwords Router 1 GAD 17 2 .16...

Ngày tải lên: 24/01/2014, 19:20

... neoplastic cells [11 ]. Human malignant melanoma contains 9-O-acetyl-NeuAc [8 ,12 ] and in human colon carcinoma tissues N-glycolylneuraminic acid [10 , 13 ] as well as a2 ,6-linked sialic acids [11 ,14 ] were ... 434 8– 435 5 (20 03) Ó FEBS 20 03 doi :10 .10 46/j .1 432 -1 033 .20 03. 038 28.x Clostridium perfringens sialidasetypeX,protease enzymes and molecular mass standards were...

Ngày tải lên: 21/02/2014, 00:20

... with a 25-mL linear gradient of 0. 13 1. 17 M MDEA in 20% methanol at 1 mLÆmin )1 . The pNA-containing phosphopeptide I, which was traced by its absorbance at 31 5 nm, appeared as a peak at 0 .33 M MDEA ... Identification and characterization of a mammalian 14 -kDa phosphohistidine phosphatase Pia Ek 1 , Gunilla Pettersson 1 ,BoEk 2 , Feng Gong 1 , Jin-Ping Li 1 an...

Ngày tải lên: 21/02/2014, 01:21

... content). Gene AF502 AF5 01 AF499 AF5 03 AF500 Apparent/calculated molecular mass 53/ 64.4 kDa 34 /38 kDa 31 /30 .5 kDa 16 /16 .7 kDa – / 43 kDa Transmembrane helices None 5 None 1 10 Cofactor binding ... four major polypeptide bands with apparent molecular masses of 53, 34 , 31 , and 16 kDa after SDS/ PAGE (Fig. 1, lane A1 ). In the boiled sample, the 34 -kDa polypeptide w...

Ngày tải lên: 21/02/2014, 03:20

... 1 - 5 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 3. 1. 5 Copyright  20 03, Cisco Systems, Inc. Lab 3. 1. 5 Configuring a Serial Interface Objective • Configure a serial interface ... passwords Router 1 GAD DCE 19 2 .16 8 .15 .1 255.255.255.0 class cisco Router 2 BHM DTE 19 2 .16 8 .15 .2 255.255.255.0 class cisco 2 - 5 CCNA 2: Routers and...

Ngày tải lên: 11/12/2013, 13:15