Tài liệu Activity 10 1: Creating and Distributing Preliminary Components pptx

... Activity 10. 1: Creating and Distributing Preliminary Components In this activity, you will place candidate components into service layers assigned in a previous activity. Objectives ... this activity: 20 minutes followed by a 10 minute discussion. THIS PAGE INTENTIONALLY LEFT BLANK Activity 10. 1: Creating and Distributing Preliminary Componen...

Ngày tải lên: 21/12/2013, 06:16

... can be used in IOS command to represent the interface. 4 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 10. 1.6 Copyright  2003, Cisco Systems, Inc. Erasing and reloading the router ... configuration mode and configure the hostname as shown in the chart. Then configure the console, virtual terminal, and enable passwords. Configure the Ethernet interface. 1 - 4 CCNA 2: R...

Ngày tải lên: 11/12/2013, 14:15

... directions and courses of actions Activity 3 .1: Identifying Data-Related Use Cases and Data Requirements In this activity, you will analyze a set of use cases derived from the Ferguson and ... Before You Begin Time to complete this activity: 20 minutes 8 Activity 3 .1: Identifying Data-Related Use Cases and Data Requirements Exercise 1: Identifying Us...

Ngày tải lên: 21/12/2013, 06:16

... Activity 10. 2: Distributing Components for Performance In this activity, you will reorganize your candidate components to take into account additional ... service layer topology created in Activity 6.3 ! The component topology created in Activity 10. 1 Time to complete this activity: 10 minutes followed by a 10 minute discussion. ... small group tasks and cla...

Ngày tải lên: 17/01/2014, 09:20

... Labfiles check box, and then select the Labfiles check box again to select the Labfiles folder and its entire contents. 10 Module 10: Backing Up and Restoring Data Performing Preliminary Tasks ... data, and then click Next to continue. 6. The Backup wizard displays the Items to Backup page, prompting you to select the local and network drives, folders, and files to be b...

Ngày tải lên: 10/12/2013, 16:15

... Use this space for creating the future-case usage scenarios. 7. THIS PAGE INTENTIONALLY LEFT BLANK Activity 4.4: Creating a Future-State Usage Scenario In this activity, you will ... group tasks and class discussion. Prerequisites There are no prerequisites for this activity. Materials ! The Ferguson and Bardell, Inc. case study. Time to complete this activity...

Ngày tải lên: 10/12/2013, 16:16

... 28 Activity 5 .1: Risks of Skipping Logical Design Exercise 1: Identifying Potential Risks of Not Doing Logical Design ! Identify

Ngày tải lên: 10/12/2013, 16:16

... Activity 6 .1: Risks of Skipping Physical Design In this activity, you will participate in a class discussion to identify the ... physical design and the risks of not completing a physical design. Before You Begin This activity is a class discussion. Prerequisites There are no prerequisites for this activity. Materials ... prerequisites for this activity. Materials There...

Ngày tải lên: 10/12/2013, 16:16

... remove and store the cables and adapter. After that, log off and turn the router off. 3 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 10. 1.6 Copyright  2003, Cisco Systems, Inc. Erasing and ... 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 10. 1.6 Copyright  2003, Cisco Systems, Inc. Step 1 Configure the hostname, passwords and interfaces on the Gadsden rout...

Ngày tải lên: 11/12/2013, 14:15

... will discuss the activity with the class. Activity 8 .1: Simulating Component Communication In this activity, you will simulate the communication between components. This activity will illustrate ... 54 Activity 8 .1: Simulating Component Communication Exercise 1: Component Communication Before COM ! Communicate with the other components 1. Participate in ... th...

Ngày tải lên: 21/12/2013, 06:16