Tài liệu OU – DELEGATE CONTROL ppt

... chuột OU Nhansu  New  Group Lưu ý : Quan sát ta thấy ns1 có quyền tạo User và Group  Trong cửa sổ New Object – Group tạo group Nhansu  trong Group ... Computers  click phải chuột OU THUCHANH  New  User  tạo user u1 BS Hệ Thống Mạng Trang 1 Lê Xuân Tùng OU – DELEGATE CONTROL I. Tạo...

Ngày tải lên: 14/12/2013, 22:15

... your router (not recommended), you can use TACACS+ for HTTP authentication. Assuming that TACACS+ is already set up on your router, you can enable HTTP authentication through TACACS+ by: Router#config ... MyTACACSkey Router(config)#aaa authentication login default group tacacs+ local Router(config)#line aux 0 Router(config-line)#login authentication default Router(config-line)#exit Router(con...

Ngày tải lên: 11/12/2013, 13:15

Ngày tải lên: 25/12/2013, 05:17

Ngày tải lên: 26/12/2013, 01:18

... phải trên OU Ketoan → New → Group Lưu ý: NS1 có quyền tạo User và Group Trong cửa sổ New Object – Group tạo group “Nhansu” → trong Group scope chọn Global → trong Group type chọn Security → OK ... các users accounts các groups trong OU “Nhansu” B1: Logon Administrator → Start → Programs → Administrative Tools → AD → Click chuột phải trên OU Nhansu → chọn Delegate Cont...

Ngày tải lên: 20/12/2013, 20:16

... bytes Memory backup 50 hours typical 50 hours typical 190 hours typical 190 hours typical 190 hours typical Local on-board I/O 6In/4Out 8In/6Out 14 In/10 Out 24 In/16 Out 24 In/16 Out Expansion modules ... Micro PLC. See Figure 1-1. After you have downloaded your program, the S7-200 contains the logic required to monitor and control the input and output devices in your application. I/OLEDs...

Ngày tải lên: 13/12/2013, 00:15

Ngày tải lên: 17/12/2013, 14:15

... spaghetti code that could be created by random goto statements throughout a program. In the next lesson, I'll show you a better way to create loops in your program. By now you know how to make ... "goto" statement. In the last couple of lessons, every program you saw contained a limited amount of sequential steps and then stopped. There were no decisions you could make w...

Ngày tải lên: 21/12/2013, 06:16

... only legal way to have automatic fall through between cases. If you were to place any statements between two cases, you would not be able to fall through. Another point is that we used the "default:" ... you that this is not the best way to perform loops in C#. The information in this lesson will teach you the proper way to execute iterative logic with the various C# looping st...

Ngày tải lên: 21/12/2013, 06:16

... flowing out under control of the level controller. The flow in is independent and can be considered a load to the level control. The flow out is driven by a pump and is proportional to the output ... temperature controller will drive its output up to 100% (or other limit). This is known as reset windup. If, in our example in the previous section, the temperature controller does not h...

Ngày tải lên: 22/12/2013, 21:15