Tài liệu Show frame-relay pvc Command Field Descriptions doc

... show ipx traffic Command Field Descriptions Field Description Time since last clear Elapsed time since last clear command issued. Rcvd: Description ... requests, and replies. This field applies to Cisco IOS Release 11.2 and later. SAP Get Nearest Server, requests, replies Number of GNS requests and replies. This field applies to Cisco IOS ... SAP Nearest Name...

Ngày tải lên: 21/12/2013, 19:15

... Show frame-relay pvc Command Field Descriptions Field Description DLCI One of the DLCI numbers for the PVC DLCI USAGE Lists SWITCHED when the router ... broadcast bytes PVC Create Time Time the PVC was created Last Time PVC Status Changed Time the PVC changed status (active to inactive) Service Type Type of service performed by this PVC; can be ... PVC...

Ngày tải lên: 11/12/2013, 14:15

... Lab 2.5.4: show tech-support Command SanJose1 SanJose2 #2#1 S0/0 S0/0 192.168.1.10 192.168.2.10 Objective This lab you will look at the output of one command the show tech- support command that ... HyperTerminal and designate a document called ShowTech-Support.TXT on either a floppy disk or the computer’s desktop. Once it is started, rerun the show tech-support command. Wh...

Ngày tải lên: 11/12/2013, 14:15

... show ipx interface e0 Command Field Descriptions Field Description Ethernet0 is up, line protocol is up Type of interface ... Value of the Ticks field (configured with the ipx delay command) Throughput Throughput of the interface (configured with the ipx spx-idle-time interface configuration command) Link Delay ... link-delay interface configuration command) IPXWAN...

Ngày tải lên: 21/12/2013, 19:15

... show interfaces bri Field Descriptions Field Description BRI Is {up | down | administratively down} Indicates whether ... long; when the number of hours in any of the "last" fields exceeds 24 hours, the number of days and hours is printed; if that field overflows, asterisks (**) are printed Output Queue,

Ngày tải lên: 11/12/2013, 14:15

... debug isdn q931 Command Call Setup Procedure Field Descriptions Field Description TX -> Indicates that this message is being transmitted ... Number Identifies the called party; this field is present only in outgoing SETUP messages; note that it can be replaced by the Keypad Facility field; this field uses the IA5 character set Calling ... identifier; the value depe...

Ngày tải lên: 11/12/2013, 14:15

... show ip bgp neighbors Command Field Descriptions Field Description BGP Neighbor IP address of the BGP neighbor and its ... to the remote host; the value in this field gradually increases until it is larger than a full- sized packet, at which point it is applied to the rcvwnd field SRTT A calculated smoothed round-trip ... to be sent to this neighbor Community Att...

Ngày tải lên: 27/10/2013, 07:15

... certmgr.msc Character Map charmap Check Disk Utility chkdsk Clipboard Viewer clipbrd Command Prompt cmd Component Services dcomcnfg Computer Management compmgmt.msc Date ... Re-Registers DNS) ipconfig /registerdns IP Configuration (Display DHCP Class ID) ipconfig /showclassid IP Configuration (Modifies DHCP Class ID) ipconfig /setclassid ava Control

Ngày tải lên: 09/12/2013, 22:15

... Reference Setting is default method  Item 10 Field Calibration Cord, Launch & Tail Cords shall all have Reference Connectors  Item 11 Method of Removal of Field Calibration Cord Adaptors for Link ... cladding and more consistent readings. 10 Test Cords and Field Calibration Cords (for both 3 & 1-Test Cord Methods) All Test Cords & Field Calibration cords shall be Qu...

Ngày tải lên: 10/12/2013, 02:15

... Physics 211: Lecture 1, Pg 15 § § 2. Electric field and electric field vector: 2. Electric field and electric field vector: 2.1 The concept of electric field: z Why two electric charges A and B in ... electric field is the negative gradient of the electric potential, E = - grad V. At every point in an electric field the electric field vector is perpendicular to the equipote...

Ngày tải lên: 10/12/2013, 12:15