Tài liệu Lab 7 2 7 Preventing Routing Updates Through an Interface pptx

... and Routing Basics v 3.0 - Lab 7. 2 .7 Copyright  20 03, Cisco Systems, Inc. Lab 7. 2 .7 Preventing Routing Updates Through an Interface Objective • Prevent routing updates through an interface ... 03: 12: 17. 555: network 1 92. 168.14.0 metric 1 *Mar 1 03: 12: 22. 671 : RIP: received v1 update from 1 92. 168.15 .2 on Serial0 *Mar 1 03: 12: 22...

Ngày tải lên: 11/12/2013, 14:15

... 2 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 1 .2 .7 Copyright  20 03, Cisco Systems, Inc. d. How many serial ports are there on each router ... appropriate box. Router DTE DCE Router 1 Router 2 3 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 1 .2 .7 Copyright  20 03, Cisco Systems, Inc. c. After having indicated the ... Serial...

Ngày tải lên: 21/12/2013, 19:15

... both hands to advance each thumbscrew at the same rate until the cable is fully inserted. Do not over-tighten these connectors. 2 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 1 .2 .7 Copyright ... 3 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 1 .2 .7 Copyright  20 03, Cisco Systems, Inc. sockets on the female cable and gently couple them. Very little effort ....

Ngày tải lên: 21/12/2013, 19:15

... 2 - 6 CCNA 1: Networking Basics v 3.0 - Lab 5 .2 .7 Copyright  20 03, Cisco Systems, Inc. Step 1 Identify the Router/Switch console connectors a. Examine the router or switch and locate ... and locate the RJ-45 connector labeled “Console”. Step 2 Identify the computer serial interface, which is COM 1 or 2 a. It should be a 9 or 25 -pin male connector labeled serial or COM...

Ngày tải lên: 21/12/2013, 19:15

... 2 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 5 .2 .7 Copyright  20 03, Cisco Systems, Inc. a. Make the necessary console connections and establish a HyperTerminal ... 0x21 42 Step 6 Restart Router a. From the ROM Monitor mode, type reset or power cycle the router. rommon 2 > reset 1 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab 5 .2 .7 Copyright  20...

Ngày tải lên: 21/12/2013, 19:15

... can be used in IOS command to represent the interface. 2 - 6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .2 .7 Copyright  20 03, Cisco Systems, Inc. Step 1 Configure the hostname and ... BHM(config-if)#ip address 1 72 . 17. 0 .2 255 .25 5.0.0 BHM(config-if)#no shutdown BHM(config-if)#exit BHM(config)#router rip BHM(config-router)#network 1 72 . 17. 0.0 BHM(confi...

Ngày tải lên: 24/01/2014, 19:20

... for both interfaces Enable secret password Enable/VTY/Console passwords Router 1 GAD 1 72 .16.0.1 DCE 1 72 . 17. 0.1 25 5 .25 5.0.0 class cisco Router 2 BHM 1 72 .18.0.1 DTE 1 72 . 17. 0 .2 255 .25 5.0.0 ... 2: Routers and Routing Basics v 3.0 - Lab 3 .2 .7 Copyright  20 03, Cisco Systems, Inc. Lab 3 .2 .7 Configuring Host Tables Router Designation Router...

Ngày tải lên: 24/01/2014, 19:20

... 0/0 .2 Router(config-subif)#ip address 10 .2. 1 .25 4 25 5 .25 5 .25 5.0 Router(config-subif)#encapsulation isl 2 Router(config-subif)#int fa 0/0.3 Router(config-subif)#ip address 10.3.1 .25 4 25 5 .25 5 .25 5.0 Router(config-subif)#encapsulation ... vtp-domain, and mls rp ip management -interface commands to configure MLS. Make the VLAN 1 interface the management interface. 3. Pin...

Ngày tải lên: 18/01/2014, 04:20

... Basics v 3.0 - Lab 4 .2. 9a Copyright  20 03, Cisco Systems, Inc. Lab 4 .2. 9a Fluke 620 Cable Tester – Wire Map Objective • Learn the wire mapping features of the Fluke 620 LAN CableMeter ... end. Prior to starting the lab, the teacher or lab assistant should have several correctly wired CAT 5 cables to test. The cables should be both straight -through and crossover. T...

Ngày tải lên: 21/12/2013, 19:15

... CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .2. 5 Copyright  20 03, Cisco Systems, Inc. Router Interface Summary Router Model Ethernet Interface #1 Ethernet Interface #2 Serial Interface ... abbreviation that can be used in IOS command to represent the interface. 3 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .2. 5 Copyright  20 03, Cisco Sys...

Ngày tải lên: 24/01/2014, 19:20