Tài liệu Lab 7 2 6 Troubleshooting RIP pdf

... password Enable/VTY/Console passwords Router 1 GAD 1 72 . 16. 0.1 DCE 1 72 . 17. 0.1 25 5 .25 5.0.0 class cisco Router 2 BHM 1 72 .18.0.1 DTE 1 72 . 17. 0 .2 255 .25 5.0.0 class cisco Objective • Set up an IP ... exit and turn the router off. 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7. 2. 6 Copyright  20 03, Cisco Systems, Inc. Lab 7. 2. 6 Trou...

Ngày tải lên: 11/12/2013, 14:15

... and turn the router off. 3 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7. 2. 6 Copyright  20 03, Cisco Systems, Inc. Lab 7. 2. 6 Troubleshooting RIP Objective • Set up an IP addressing ... __________________________________________________________________________ 2 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7. 2. 6 Copyright  20 03, Ci...

Ngày tải lên: 11/12/2013, 14:15

... 3.0 - Lab 1 .2. 6 Copyright  20 03, Cisco Systems, Inc. Lab 1 .2. 6 Troubleshooting RIP v2 using Debug Objective • Configure RIP v2 on both routers • Use debug commands to verify proper RIP ... 2 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1 .2. 6 Copyright  20 03, Cisco Systems, Inc. Step 2 Configure the routing protocol on ... is...

Ngày tải lên: 21/12/2013, 19:15

... Intermediate Routing v 3.0 - Lab 1 .2. 6 Copyright  20 03, Cisco Systems, Inc. Lab 1 .2. 6 Troubleshooting RIP Version 2 using Debug Objective • Configure RIPv2 on both routers • Use debug ... RIP routes if the update is from RIPv2? _____________________ d. Turn off debugging by typing either no debug ip rip or undebug all. Step 16 Enable RIP version 2 rou...

Ngày tải lên: 21/12/2013, 19:15

... 1 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7. 2. 6 Copyright  20 03, Cisco Systems, Inc. Lab 7. 2. 6 Spanning Tree Recalculation Objective • Create a basic switch ... Configuration lab. 4 - 4 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 7. 2. 6 Copyright  20 03, Cisco Systems, Inc. 3 - 4 CCNA 3: Switching Basics an...

Ngày tải lên: 11/12/2013, 14:15

... Step 2 Configure the workstations a. The configuration for the host connected to the Gadsden Router is: IP Address 1 92. 168 .14 .2 IP subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92. 168 .14 .2 b. ... the host connected to the Birmingham Router is: IP Address 1 92. 168 . 16 .2 IP subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92. 168 . 16. 1 Step 3 ping from the works...

Ngày tải lên: 21/12/2013, 19:15

... 1 92. 168 .14.1 DCE 1 92. 168 .15.1 NA No address 25 5 .25 5 .25 5.0 Router 2 BHM 1 92. 168 . 16. 1 DTE 1 92. 168 .15 .2 NA No address 25 5 .25 5 .25 5.0 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 4 .2. 6 ... passwords Routing protocol RIP network statements Router 1 GAD class cisco RIP 1 92. 168 .14.0 1 92. 168 .15.0 Router 2 BHM class cisco RIP 1 9...

Ngày tải lên: 21/12/2013, 19:15

... routes to 1 72 . 16. 0.0/ 16 in their tables. From Boaz, ping 1 72 . 16. 1.1. This ping should be successful. e. Why does the ping to 1 72 . 16. 1.1 work, even though there is no route to 1 72 . 16. 0.0/ 16 in the ... Centre(config-if)#ip address 1 72 . 16. 1.1 25 5 .25 5 .25 5 .25 5 Note: If 1 72 . 16. 1.1 is pinged from the Centre console, the loopback interface replies. b. From...

Ngày tải lên: 21/12/2013, 19:15

... 199.99.9. 32/ 27 have been allocated for Internet access outside of the company. Use the ip route command to create the static route: ISP(config)#ip route 199.99.9. 32 255 .25 5 .22 4.0 20 0 .2. 2.18 ... assigned lab to be performed. 2 - 7 CCNA 4: WAN Technologies v 3.0 - Lab 1.1 .6 Copyright  20 03, Cisco Systems, Inc. • 26 00 series routers Please refer to the chart...

Ngày tải lên: 11/12/2013, 13:15

... address 1 72 . 16. 1 .2 255 .25 5 .25 5.0 BHM(config-if)#exit BHM(config)#interface fastethernet 0 BHM(config-if)#ip address 1 72 . 16. 3.1 25 5 .25 5 .25 5.0 BHM(config-if)#exit BHM(config)#exit 2 - 7 CCNA ... GAD from a class B (25 5 .25 5.0.0) to a Class C (25 5 .25 5 .25 5.0). Use the same IP address. GAD(config)#interface fastethernet 0 GAD(config-if)#ip address 1 72 ....

Ngày tải lên: 11/12/2013, 13:15