... equipment, and store the cables 1 - 4 CCNA 1: Networking Basics v 3.0 - Lab 5. 1. 13b Copyright 2003, Cisco Systems, Inc. Lab 5. 1. 13b Building a Switch-based Network Objective • Create a simple ... and the switch will be accomplished using a cat 5 or 5e straight-through patch cable. Locate two cables that are long enough to reach from each PC to th...
Ngày tải lên: 11/12/2013, 14:15
... required on local area networks that are connected to a router. Computer IP Address Subnet mask Default Gateway PC – A 19 2 .16 8 .1. 1 255 . 255 . 255 .0 Not Required PC – B 19 2 .16 8 .1. 2 255 . 255 . 255 .0 Not ... Layer 3, so that they can communicate. Since this lab uses a switch, a basic Category 5/ 5e UTP straight-through cable is needed to connect each PC to the sw...
Ngày tải lên: 05/11/2013, 12:15
Tài liệu Lab 5.2.3 Building a Basic Routed WAN ppt
... packets between local area networks 19 2 .16 8 .1. 0 and 19 2 .16 8.2.0. Router E0 Interface IP Address Subnet mask Router – A 19 2 .16 8 .1. 1 255 . 255 . 255 .0 Router – B 19 2 .16 8.2 .1 255 . 255 . 255 .0 b. Connecting ... default Gateway is required on local area networks that are connected to a router. Computer IP Address Subnet mask Default Gateway PC – A 19 2...
Ngày tải lên: 11/12/2013, 14:15
Tài liệu Lab 5.2.3b Building a Basic Routed WAN pdf
... packets between local-area networks 19 2 .16 8 .1. 0 and 19 2 .16 8.2.0. Router E0 Interface IP Address Subnet mask Router – A 19 2 .16 8 .1. 1 255 . 255 . 255 .0 Router – B 19 2 .16 8.2 .1 255 . 255 . 255 .0 b. Connecting ... 255 . 255 . 255 .0 19 2 .16 8 .1. 1 PC – B 19 2 .16 8.2.2 255 . 255 . 255 .0 19 2 .16 8.2 .1 Step 9 Verify that PCs can communicate across the WA...
Ngày tải lên: 11/12/2013, 14:15
Lab 5.1.11 Building a Peer-to-Peer Network
... required on local area networks that are connected to a router. Computer IP Address Subnet mask Default Gateway PC – A 19 2 .16 8 .1. 1 255 . 255 . 255 .0 Not Required PC – B 19 2 .16 8 .1. 2 255 . 255 . 255 .0 Not ... equipment, and store the cables 1 - 4 CCNA 1: Networking Basics v 3.0 - Lab 5. 1. 11 Copyright 2003, Cisco Systems, Inc. Lab 5. 1. 11 Building...
Ngày tải lên: 27/10/2013, 07:15
Lab 5.1.12 Building a Peer-to-Peer Network
... default gateway is only required on local area networks that are connected to a router. Computer IP Address Subnet mask Default Gateway PC – A 19 2 .16 8 .1. 1 255 . 255 . 255 .0 Not Required PC – B 19 2 .16 8 .1. 2 ... Required PC – B 19 2 .16 8 .1. 2 255 . 255 . 255 .0 Not Required Step 5 Access the Command or MS-DOS prompt a. Use the Start menu to open the Command Prompt (M...
Ngày tải lên: 27/10/2013, 07:15
Lab 5.1.13a Building a Hub-based Network
... following IP address. 2 - 4 CCNA 1: Networking Basics v 3.0 - Lab 5. 1. 1 3a Copyright 2003, Cisco Systems, Inc. Lab 5. 1. 1 3a Building a Hub-based Network Objective • Create a simple network ... inexpensive and easy to install, but they permit collisions to occur. They are appropriate for a small LAN with light traffic. In addition to the physical and da...
Ngày tải lên: 04/11/2013, 16:15
Tài liệu Lab 3.1.7 Troubleshooting a Serial Interface doc
... Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 250 0 Ethernet 0 (E0) Ethernet 1 (E1) Serial ... router and gateway router, and a default route between the gateway router and remote router. Cable a network similar to the one in the diagram above. Any router tha...
Ngày tải lên: 11/12/2013, 13:15
Tài liệu Lab 5.2.7 Establishing a Console Connection to a Router or Switch docx
... popup enter a name in the connection Name field and select OK. 1 - 6 CCNA 1: Networking Basics v 3.0 - Lab 5. 2.7 Copyright 2003, Cisco Systems, Inc. Lab 5. 2.7 Establishing a Console Connection ... terminal is a DB- 25, an RJ- 45 to DB- 25 adapter will be needed. Both of these adapters typically come with a Cisco router or switch. Step 4 Locate or build a...
Ngày tải lên: 21/12/2013, 19:15
Tài liệu Lab 5.1.3 Using the Boot System Command pptx
... (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 250 0 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 2600 FastEthernet 0/0 (FA0/0) FastEthernet 0 /1 (FA0 /1) Serial 0/0 (S0/0) ... Serial Interface #1 Serial Interface #2 Interface #5 800 (806) Ethernet 0 (E0) Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17...
Ngày tải lên: 18/01/2014, 04:20