Tài liệu Lab 1 1 4c Configuring Static NAT Addresses docx

Tài liệu Lab 1.1.4c Configuring Static NAT Addresses docx

Tài liệu Lab 1.1.4c Configuring Static NAT Addresses docx

... Technologies v 3.0 - Lab 1. 1 .4c Copyright  2003, Cisco Systems, Inc. Lab 1. 1 .4c Configuring Static NAT Addresses Objective • Configure a router to use network address translation (NAT) to convert ... interfaces with respect to NAT. To do this, use the ip nat inside or ip nat outside command. Step 11 Configuring Static Mapping a. Workstation #1, 10 ....
Ngày tải lên : 11/12/2013, 13:15
  • 7
  • 359
  • 0
Tài liệu Lab 6.2.4 Configuring Static MAC Addresses pdf

Tài liệu Lab 6.2.4 Configuring Static MAC Addresses pdf

... ALSwitch(config)#mac-address-table static 00e0.2 917 .18 84 interface fastethernet 0/4 vlan 1 2900: ALSwitch(config)#mac-address-table static 00e0.2 917 .18 84 fastethernet 0/4 vlan 1 19 00: ... fastethernet 0/4 vlan 1 2900: ALSwitch(config)#no mac-address-table static 00e0.2 917 .18 84 fastEthernet 0/4 vlan 1 19 00: ALSwitch(config)#no mac-address-table pe...
Ngày tải lên : 18/01/2014, 04:20
  • 5
  • 394
  • 0
Tài liệu Lab 8.2.3 Configuring Static VLANs docx

Tài liệu Lab 8.2.3 Configuring Static VLANs docx

... Switch_A(config-if)#end 19 00: Switch_A#config terminal Switch_A(config)#interface Ethernet 0/3 Switch_A(config)#vlan static 3 Switch_A(config)#end Step 11 Look at the VLAN interface ... static and dynamic addresses will be removed. Reset system with factory defaults, [Y]es or [N]o? Enter y and press Enter . 3 - 7 CCNA 3: Switching Basics and Intermediate Routing v 3.0 -...
Ngày tải lên : 18/01/2014, 04:20
  • 7
  • 336
  • 0
Tài liệu Lab 8.2.3 Configuring Static VLANs doc

Tài liệu Lab 8.2.3 Configuring Static VLANs doc

... is always VLAN 1. The Network Administrator's workstation must have access to a port in the VLAN 1 Management Domain. All ports are assigned to VLAN 1 by default. This lab will also help ... instructions at the end of this lab. Perform those steps on all switches in this lab assignment before continuing. 1 - 5 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab...
Ngày tải lên : 18/01/2014, 04:20
  • 5
  • 398
  • 1
Tài liệu Lab 11.2.1a Configuring Standard Access Lists docx

Tài liệu Lab 11.2.1a Configuring Standard Access Lists docx

... (FA1) Serial 0 (S0) Serial 1 (S1) 2500 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 2600 FastEthernet 0/0 (FA0/0) FastEthernet 0 /1 (FA0 /1) Serial 0/0 (S0/0) Serial 0 /1 (S0 /1) ... #1 Serial Interface #2 Interface #5 800 (806) Ethernet 0 (E0) Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0)...
Ngày tải lên : 21/12/2013, 19:15
  • 5
  • 330
  • 0
Tài liệu Lab 6.1.6 Configuring Static Routes doc

Tài liệu Lab 6.1.6 Configuring Static Routes doc

... Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 2500 Ethernet 0 (E0) Ethernet 1 (E1) Serial ... C:\>ping 19 2 .16 8 .16 .2 Pinging 19 2 .16 8 .16 .2 with 32 bytes of data: Request timed out. Request timed out. Request timed out. Request timed out. Ping stati...
Ngày tải lên : 21/12/2013, 19:15
  • 6
  • 455
  • 0
Tài liệu Lab 6.1.6 Configuring Static Routes docx

Tài liệu Lab 6.1.6 Configuring Static Routes docx

... Interface type Serial 1 Serial 1 address Subnet mask all addresses Router 1 GAD 19 2 .16 8 .14 .1 DCE 19 2 .16 8 .15 .1 NA No address 255.255.255.0 Router 2 BHM 19 2 .16 8 .16 .1 DTE 19 2 .16 8 .15 .2 NA No address ... (FA1) Serial 0 (S0) Serial 1 (S1) 2500 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 2600 FastEthernet 0/0 (FA0/0) FastEtherne...
Ngày tải lên : 21/12/2013, 19:15
  • 7
  • 450
  • 0
Tài liệu Lab 3.1.5 Configuring a Serial Interface pptx

Tài liệu Lab 3.1.5 Configuring a Serial Interface pptx

... (FA1) Serial 0 (S0) Serial 1 (S1) 2500 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 2600 FastEthernet 0/0 (FA0/0) FastEthernet 0 /1 (FA0 /1) Serial 0/0 (S0/0) Serial 0 /1 (S0 /1) ... #1 Serial Interface #2 Interface #5 800 (806) Ethernet 0 (E0) Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0)...
Ngày tải lên : 11/12/2013, 13:15
  • 5
  • 535
  • 0
Tài liệu Lab 3.1.7 Configuring an Ethernet Interface docx

Tài liệu Lab 3.1.7 Configuring an Ethernet Interface docx

... Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 2500 Ethernet 0 (E0) Ethernet 1 (E1) Serial ... router is ready for the assigned lab to be performed. 1 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 7 Copyright  2003, Cisco Systems, Inc. Lab 3 .1...
Ngày tải lên : 11/12/2013, 13:15
  • 4
  • 395
  • 0
Tài liệu Lab 3.1.7 Configuring an Ethernet Interface pptx

Tài liệu Lab 3.1.7 Configuring an Ethernet Interface pptx

... Ethernet 1 (E1) 16 00 Ethernet 0 (E0) Ethernet 1 (E1) Serial 0 (S0) Serial 1 (S1) 17 00 FastEthernet 0 (FA0) FastEthernet 1 (FA1) Serial 0 (S0) Serial 1 (S1) 2500 Ethernet 0 (E0) Ethernet 1 (E1) Serial ... interface. 1 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 3 .1. 7 Copyright  2003, Cisco Systems, Inc. Lab 3 .1. 7 Configuring an Ethernet Interfa...
Ngày tải lên : 11/12/2013, 13:15
  • 4
  • 430
  • 0

Xem thêm