N885 Cummins Engine Shop Manual P2

Shop manual ô tô NISSAN 2000 Xterra - P20

Shop manual ô tô NISSAN 2000 Xterra - P20

... Remove shift lever.8. Support engine by placing a jack under oil pan.¼ Do not place jack under oil pan drain plug.9. Separate transmission from engine. WARNING:Support manual transmission while removing ... (NVH)TROUBLESHOOTING.....................................................6NVH Troubleshooting Chart......................................... 6MANUAL TRANSMISSION........................

Ngày tải lên: 22/10/2012, 11:51

70 267 0
Shop manual ô tô NISSAN 2000 Xterra - P21

Shop manual ô tô NISSAN 2000 Xterra - P21

... electrical test equipment on any circuit related to the SRS unless instructed to in thisService Manual. SRS wiring harnesses are covered with yellow insulation either just before theharness connectors ... electrical test equipment on any circuit related to the SRS unless instructed to in thisService Manual. SRS wiring harnesses are covered with yellow insulation either just before theharnes...

Ngày tải lên: 22/10/2012, 11:51

58 327 0
Shop manual ô tô NISSAN 2000 Xterra - P22

Shop manual ô tô NISSAN 2000 Xterra - P22

... mounted)Standard length “L2” (2WD & 4WD VG33E models):Except P26 5/70R15 tire:26.5 mm (1.043 in)(Length before cap is mounted )P26 5/70R15 tire:30.0 mm (1.2 in)(Length before cap is mounted)FRONT ... (0.33°)Maximum 25′ (0.42°)Wheel turningangleFull turn*2InsideDegree minute(Decimal degree)Except P26 5/70R15 P26 5/70R15Minimum 32°48′ (32.80°)30°48′ (30.80°)Nominal 34°48′ (34.80°)32°48′...

Ngày tải lên: 22/10/2012, 11:51

26 261 0
Shop Manual & ETM BCM KIA Cerato 2010 - Button Engine Start System

Shop Manual & ETM BCM KIA Cerato 2010 - Button Engine Start System

... EMS to check the engine running status for starter release.The driver will be able to stop the engine by a short push on the SSB if the vehicle is already in standstill. Emergency engine stop will ... by a long press of the SSB or 3 consecutive presses in case the vehicle is in ENGINE RUNNING.If the conditions for engine cranking are not satisfied while a push on the SSB is detected...

Ngày tải lên: 22/10/2012, 15:55

20 886 0
w