... Figure 1. Concept of Radar Cross Section Figure 2. RCS vs Physical Geometry RADAR CROSS SECTION (RCS) Radar cross section is the measure of a target's ability to reflect radar signals in the ... are as follows: Range (radar detection): From the 2-way range equation in Section 4-4: Therefore, R % F or F % R 4 1/4 Range (radar burn-through): The crossover equati...
... to make cross- sections of metai structural members
inthe formofthe cross- sections ofFigure 8.l(c) to (e), as suchcross-sectionsare structurallymore
efficient
in
bending than cross- sections ...
8.2
Centroid
The position of the centroid
of
a cross- section is the centre of the moment of area
of
the cross-
section. If the cross- section is constructed from a homogeneous...
... 10- 1SECTION 10: FOUNDATIONSTABLE OF CONTENTS[TO BE FURNISHED WHEN SECTION IS FINALIZED]
10- 2SECTION 10FOUNDATIONS10.1 SCOPE C10.1Provisions of this section shall apply for ... field)Width of Foundation — Minimum plan dimension of a foundation element10.3 NOTATIONA = steel pile cross- sectional area (ft2) (10.7.3.8.2)A= effective footing area for determination of elastic settlement ....
... đa của trạm radar cho hai tần số lặp xung trên b. Thời gian lặp xung tương ứng c. Công suất bức xạ trung bình của trạm radar d. Năng lượng bức xạ trong 20 ms đầu tiên 2. Một trạm radar xung ... việc của trạm radar xung 3. Một trạm radar làm việc tại băng L có tần số trung tâm là 1,5 GHz và tần số lặp xung là 10 KHz. Hãy cho biết độ dịch tần Doppler tối đa của trạm radar trên. 4. ....
... không gian tự do Friis
Radar crossRadar cross- -sectionsection• Tạm dịch :Tiết diện của Radar. • Thay thế diện tích chịu ảnh hưởng (effective area) của ăngten nhận ,trong Radar ,tín hiệu ñược xác ... tiêu.
Radar crossRadar cross- -sectionsection• Nó có thể tỉ lệ hoặc không với kích thước vật lý của mục tiêu.• Nó thường ñược biểu diễn bằng m2 hoặc dBsmdBsm• Kí hiệu của RCS là :
Phương...
... tín hiệu phản xạ .
Radar cross- section
Radar cross- section
•
Tạm dịch :Tiết diện của Radar.
•
Thay thế diện tích chịu ảnh hưởng (effective
area) của ăngten nhận ,trong Radar ,tín hiệu
được ... đất.
Giới thiệu về Radar
Giới thiệu về Radar
Nguyễn Hồng Quang
Nguyễn Hồng Quang
ĐT6-K48
ĐT6-K48
Clutter Cross- section
Clutter Cross- section
•
Tiết diện của Rad...
... faster
from thin sections than from thick. When hydrogen content exceeds 0.0005%, flaking, in-
ternal cracks or bursts, may occur when the steel cools after rolling, especially in thick
sections. In ... ductility is measured by percent elongation over a given gage length or
percent reduction of cross- sectional area. The percent elongation is determined by fitting the
specimen together after f...
... complete sections are added to and removed from the assembled sections. The
sections added are always in their cambered position. There should always be at least two
previously assembled and reamed sections ... minimum length of three
abutting sections), the field connection holes are reamed. (Section, as used here and in
methods 2 and 3, means fabricated member. A chord section, or fabricate...
... are uniformly distributed over the cross
section. Typically examples of this type of member are shown in Fig. 3.20.
Since the stress is constant across the section, the equation of equilibrium ... P
ϭ
axial load
ƒ
ϭ
tensile, compressive, or bearing stress
A
ϭ
cross- sectional area of the member
Similarly, if the strain is constant across the section, the strain
corresponding to an axi...
... pl
⌬
ƒ
ϭ
(4.121)
222
H
ϩ
H
ϩ
(A ƒ
ϩ
A ƒ )16E/3l 8
iu ib u u b b
where A
u
ϭ
cross- sectional area of upper cable
A
b
ϭ
cross- sectional area of lower cable
The decrease in uniformly distributed diaphragm ... O
u
from weight of upper cable
A
Lu
ϭ
cross- sectional area of upper-cable segment on the left of O
u
l
Lu
ϭ
length of chord from O
u
to L
u
A
Ru
ϭ
cross- sectional area of upper-cabl...