... 46 -
www .nve. com phone: 952-829-9217 fax: 952-829-9189
GT Sensors
Precision Gear Tooth and Encoder Sensors
NVE s GT Sensor products are based on a Low Hysteresis GMR sensor material ... microns, in order to manufacture the GMR sensor elements used in NVE s
products.
The following diagrams show how the GMR effect works in an NVE sensor using multilayer GMR...
... position sensor and the accelerator
sensor, is one of the main sensors used for calculating the basic injection
volume.
1
1
Speed Sensor
Speed Sensor
Connector
Speed Sensor
Toothless Section
Roller ... Ring
Magnet
Pulsar
Coil
Pulsar
Speed Sensor
0
+
-
Time
Output
Voltage
Sensor Output Signal
2
2
Throttle Position Sensor
Throttle Position
Sensor
10
SERVICE TECH Vol.467 03-8
T...
... Side-Dump Buckets. Permit loaders
to operate in congested worksites
and can also dump forward like a
conventional bucket (3rd valve required).
5 Forks. Pallet forks are ideal work
tools for material ... color-coded
S
•
O
•
S sampling ports are accessible
from ground level. Remote grease lines
culminate in two convenient central
lube banks in the right hitch area.
Sight Gauges. For the transmi...
... are not listed in this catalogRubber molded bearingsSL-type cylindrical roller bearingsCrossed roller thrust bearingsSpecial application bearings are not listed in this catalog. Fig. 1.9 Classification ... Corporation. 2001Although care has been taken to assure the accuracy of the data compiled in this catalog, NTN does notassume any liability to any company or person for errors or omission...