Conclusion - what is to be done

... seem to be related. In this sense, globalisa- tion, whilst having a long historical background as old as merchants and reli- gious proselytisers, appears to be a process which deserves to be recognised ... Time Axis, humans will adopt a position for the future in response to what history means for them. There will be reasons of some his- torical significance for why someone...

Ngày tải lên: 01/11/2013, 08:20

Ngày tải lên: 25/10/2013, 15:20

... sympathy for his fledgling and inconsis - 2 WILL BL YTHE There is no end to my gloom. My father is in his grave, my marriage is kaput, my girlfriend is said to be in Miami (though what she is doing ... in his naming. On the Car- olina side of the cosmos, “Assisto” Felton sounded the alarm in a car- toon bubble: “My sword turns light blue! Dorks are nearby!” 99 To Ha...

Ngày tải lên: 21/02/2014, 17:20

... thương trong vụ nổ. B (Be) supposed to Đôi khi it is supposed to … = it is said to Let’s go and see that film. It’s supposed to be very good. (=it is said to be very good) Hãy đi xem ... It is said that …. He is said (be) supposed to & Have something done Unit 44. It is said that …. He is said (be) supposed to A Khảo sát ví dụ sau: Henry is...

Ngày tải lên: 06/11/2013, 07:15

... inclined to the vertical to provide higher resistance to lateral loadsBearing Pile — A pile whose purpose is to carry axial load through friction or point bearingBent – A type of pier comprised of ... coremay be required to verify that adequate qualitybedrock is present. 1 0-1 410.4.3 Laboratory Tests10.4.3.1 SOIL TESTSLaboratory testing should be conducted toprovide the b...

Ngày tải lên: 06/09/2012, 15:57

... uplift resistance of a belled shaft, the side resistance above the bell should conservatively be neglected if the resistance of the bell is considered, and it can be assumed that the bell behaves ... nominal resistance of each shaft should be reduced by a factor η for an isolated shaft taken as:  = 0.65 for a center -to- center spacing of 2.5 diameters,   = 1.0 for a center -to- c...

Ngày tải lên: 29/09/2013, 12:20

... not be factored, but consideration should be given to the bias of the static analysis method used to predict resistance. Method bias is discussed in Article 10.7.3.3. The piles will need to be ... of load tests on steel pipe piles. 1 0-9 1 bearing resistance of the pile needed to resist the applied loads, and is used as the basis for determining the resistance to be ac...

Ngày tải lên: 29/09/2013, 12:20

... varved silt- clay-fine sand (ML, MH) Very stiff to hard Medium stiff to stiff Soft 4 to 8 2 to 6 1 to 2 6 3 1 1 0-6 4 10.6.2.6.2 Semiempirical Procedures for Bearing Resistance Bearing resistance ... dense Medium dense to dense Loose 12 to 20 8 to 14 4 to 12 14 10 6 Coarse to medium sand, and with little gravel (SW, SP) Very dense Medium dense to dense Loose 8 to 12...

Ngày tải lên: 29/09/2013, 12:20

... dense Dense 1.1 1-1 .67 1.6 7-2 .78 2.7 8-4 .17 0.25 Sand: Loose Medium dense Dense 1.3 9-4 .17 4.1 7-6 .94 6.9 4-1 1.11 0.2 0-0 .36 0.3 0-0 .40 Gravel: Loose Medium dense Dense 4.1 7-1 1.11 11.1 1-1 3.89 13.8 9-2 7.78 0.2 0-0 .35 0.3 0-0 .40 Estimating ... resistance factor used for design relative to the values provided in Table 10.5.5.2. 3-2 may be warranted...

Ngày tải lên: 29/09/2013, 12:20

... genres as story-telling, prayers, and speech-making. Long word-lists and sets of grammatical paradigms go only a short way towards captur- ing what is unique about a heritage; what is crucial is to show ... fluency to semilin- gualism. Many of the students will be members of the ‘in-between’ generation, who have learned the dominant language as a first What can be done? 137...

Ngày tải lên: 01/11/2013, 09:20