KM8 RJ45 Patch Cords Unshielded / Shielded
... Mbit/s n TP-PMD 125 Mbit/s n Cable sharing (same or different sevices) n CDDI/TPDDI (FDDI on copper) n Token Ring 4/1 6 Mbit/s n Analogue Telephony, ISDN KM8 RJ45 Patch Cords Unshielded / Shielded KRONE ... Shielded KRONE GmbH Beeskowdamm 3-11 Germany-14167 Berlin Phone +49 (30) / 8453-1422 Fax +49 (30) / 8453-1412 http :// www.krone.com/km8series vertrieb@krone....
Ngày tải lên: 27/10/2013, 07:15
... according to TIA/EIA 568 A/B n Ease of installation due to simultaneous termination KRONE GmbH Beeskowdamm 3-11 Germany-14167 Berlin Phone +49 30 8453-1422 Fax +49 30 8453-1412 http :// www.krone.com vertrieb@krone.com ... KRONE PremisNET KM8 RJ45 Modular Products STP/UTP Features n Transmission performance exeeds Category 6 requierements n Highest
Ngày tải lên: 23/10/2013, 00:15
Category 6 Specialty Patch Cords
... 9 1 Spec Sheet TrueNet ® Category 6 Specialty Patch Cords Impedance matched for use in TrueNet® structured cabling systems; these specialty patch cords exceed all performance requirements for ... Impedance matched patch cord for maximum throughput • Flexible strain relief boot maintains proper bend radius to ensure peak performance • Plug to jack cable assemblies utilizes ADC’s KM...
Ngày tải lên: 27/10/2013, 00:15
... Singlemode or Multimode Patch Cords (Simplex and Duplex) 3 Singlemode Patch Cords (Simplex and Duplex) 4 Multimode Patch Cords (Simplex and Duplex) 5 Singlemode Multifiber Patch Cords (4- to 24-fibers) ... cm/-0 cm +15 m +1 %/- 0 cm Ribbon Length Tolerance 1 to 20 m +15 cm/-0 cm +20 m +90 cm/-0 cm Assembly Length Fiber Optic Specifications Assembly Length Guide Patch...
Ngày tải lên: 27/10/2013, 01:15
Tài liệu Category 6 Ultim8™ Patch Cords ppt
... Termination Blocks, these patch cords allow direct patching capability from an Ultim8 block to an active device or an RJ45 patch panel. The patch cords are impedance matched for use in the TrueNet® ... 1863 listed and Category 6 performance verified 3 / 0 7 • 1 0 4 2 2 0 A E Category 6 Ultim8 Patch Cords TrueNet ® Category 6 Ultim8 ™ Patch Cords 2 w w w . a d c . c...
Ngày tải lên: 09/12/2013, 17:15
Tài liệu TrueNet® Multimode Fiber Optic Patch Cords pdf
... portfolio, ADC's multimode fiber optic patch cords are essential to meet the requirements of today's high-speed data networks. These patch cords can be used throughout the network in ... in the field. • Lead-free OFNP jacket and RoHS compliant • All patch cords are shipped with insertion loss tests for individual cords • Readily available in LC-LC, LC-SC, and SC-LC c...
Ngày tải lên: 10/12/2013, 20:15
Tài liệu Dual BNC Coaxial Cross-Connect Jumpers and Patch Cords doc
... Dual BNC Coaxial Cross-Connect Jumpers and Patch Cords Dual BNC Coaxial Cross-Connect Jumpers • Quick, easy installation – Technicians route ... guide provides ordering information for dual BNC coaxial cross-connect jumpers on this page and patch cords on the reverse side. Dual BNC coaxial cross-connect jumpers provide maximum cable management ... improved signal flow. To provide th...
Ngày tải lên: 21/12/2013, 07:15
Tài liệu DSX-4F Cross-Connect Jumpers and Patch Cords ppt
... They are also compatible with Avaya/Lucent Technologies cross-connect products. To provide the highest quality product, all cross-connect jumpers and patch cords manufactured by ADC pass rigorous qualification ... guide provides ordering information for the DSX-4F front cross-connect jumper on this page and patch cords on the reverse side. This miniature 0222 coaxial cable assembly is...
Ngày tải lên: 21/12/2013, 07:15
Tài liệu TrueNet® Category 6 Patch Cords pptx
... TrueNet ® Category 6 Patch Cords Impedance matched for use in TrueNet ® structured cabling systems, these patch cords exceed all performance requirements for Category ... matched patch cord for maximum throughput • Flexible strain relief boot maintains proper bend radius to ensure peak performance • Up to 32 percent smaller outer diameter than other patch cords • ... also ensure...
Ngày tải lên: 21/12/2013, 07:16
Tài liệu KRONE - Guide - Ethernet Signal Preservation - Factory Terminated patch cords ppt
... specific patch cord lengths to reduce errors has been confirmed with active network analysis of bit error generation in otherwise identical patch cords plugged into the same channel. Patch cords ... connections between the signal-generating ends (the NIC and the hub/switch). Patch cords are plugged into the station outlet, patch panels, etc. The reason that connection points...
Ngày tải lên: 16/01/2014, 21:20