Access Lists Lab Scenario

... connection to the Internet: access- list 102 deny icmp any any 3 9 access- list 102 deny icmp any any 3 10 access- list 102 permit ip any any Apply access list 102 as an outbound access control list to ... list to allow administrators full access to the Las Vegas site. 3. Configure an access list to restrict all other access to the Las Vegas site. 4. Configure access control fo...

Ngày tải lên: 27/10/2013, 03:15

... Issue: 08-01-2000 Dynamic Access List Lab Scenario by Katherine Tallis Introduction Required Equipment Lab Objectives Equipment Configuration Solution Testing the Dynamic Access List Introduction Dynamic, ... telnet to it: access- list 100 dynamic fred timeout 30 permit icmp any any 4. Add a final access list statement that blocks all other traffic: access- list 100 deny ip a...

Ngày tải lên: 24/01/2014, 19:20

... Apply access list to the proper router interface a. First remove the old access list application by typing no ip access- group 1 in at the interface configuration mode. b. Apply the new access ... Step 9 Create a new access list a. Now create an access list that will prevent the even numbered hosts from pinging but permit the odd numbered one. b. What will that access list...

Ngày tải lên: 21/12/2013, 19:15

... Apply access list to the proper router interface a. First remove the old access list application by typing no ip access- group 1 in at the interface configuration mode. b. Apply the new access ... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 11.2.1a Copyright  2003, Cisco Systems, Inc. Lab 11.2.1a Configuring Standard Access Lists Objective • Configure, a...

Ngày tải lên: 21/12/2013, 19:15

... 3 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 11.2.2 Copyright  2003, Cisco Systems, Inc. Lab 11.2.2 Configuring Extended Access Lists Router Designation Router Name FA0/0 ... the chart at the end of the lab to correctly identify the interface identifiers to be used based on the equipment in the lab. The configuration output used in this lab is produced fr...

Ngày tải lên: 18/01/2014, 05:20

... 1 - 5 CCNA 2: Routers and Routing Basics v 3.0 - Lab 11.2.2a Copyright  2003, Cisco Systems, Inc. Lab 11.2.2a Configuring Extended Access Lists Objective • Configure, and apply an ... server function is active. Step 6 Prevent access to HTTP (port 80) from the Ethernet interface hosts a. Create an access list that will prevent Web browsing access to FastEthernet 0 f...

Ngày tải lên: 18/01/2014, 05:20

... Access Lists v 3.0 - Lab 11.2.2b Copyright  2003, Cisco Systems, Inc. Lab 11.2.2b Simple Extended Access Lists 6 - 7 CCNA 2: Simple Extended Access Lists v 3.0 - Lab 11.2.2b Copyright ... 2 - 7 CCNA 2: Simple Extended Access Lists v 3.0 - Lab 11.2.2b Copyright  2003, Cisco Systems, Inc. Objective In this lab, configuring extended access lists to fi...

Ngày tải lên: 18/01/2014, 05:20

... the syntax of the access lists with the show -access- lists command. The output should be similar to the following: GAD#show access- lists GAD#show access- lists Extended IP access list 101 ... features such as Network Address Translation and advanced access lists options such as Reflexive access lists, Content Based Access Lists (CBAC), are strongly recomme...

Ngày tải lên: 18/01/2014, 05:20

... session on one of the routers with access lists, display the access lists with the Boaz#show ip access- lists command. Record the information about one of the access lists. _____________________________________________________________________________________ ... 3.0 - Lab 11.2.3d Copyright  2003, Cisco Systems, Inc. Step 10 Verify the Access Lists a. Now that the acce...

Ngày tải lên: 18/01/2014, 05:20

... switches involved in this lab may interfere with the expected outcome from each section of this lab. Therefore, it is recommended you begin working through these labs only after resetting the ... VLAN 3. 6. Disconnect the cable plugged into SwitchA's port labeled "10x." Connect it to SwitchB's Ethernet port labeled 1x. 7. From either PC, attempt to ping the correspo...

Ngày tải lên: 19/10/2013, 02:15