Lab 9 3 5 Troubleshooting Routing Issues with show ip route and show ip protocols

Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip protocols

Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip protocols

... 1 - 6 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 9. 3. 5 Copyright  20 03, Cisco Systems, Inc. Lab 9. 3. 5 Troubleshooting Routing Issues with show ip route and show ip protocols Objective ... GAD #show ip route c. Is there a route to the Birmingham LAN? _____________________ 4 - 6 CCNA 2: Routers and Routing Basics v 3....

Ngày tải lên: 23/10/2013, 00:15

6 333 1
Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip Protocols

Lab 9.3.5 Troubleshooting Routing Issues with show ip route and show ip Protocols

... passwords Router 1 GAD 192 .168.1.1 DCE 192 .168.2.1 255 . 255 . 255 .0 class cisco Router 2 BHM 192 .168 .3. 1 DTE 192 .168.2.2 255 . 255 . 255 .0 class cisco Objective • Use the show ip route and show ip protocol ... Lab 9. 3. 5 Troubleshooting Routing Issues with show ip route and show ip Protocols Router Designation Router Name F...

Ngày tải lên: 27/10/2013, 07:15

6 419 0
Tài liệu Lab 9.3.7 Troubleshooting Routing Issues with Debug ppt

Tài liệu Lab 9.3.7 Troubleshooting Routing Issues with Debug ppt

... CCNA 2: Routers and Routing Basics v 3. 0 - Lab 9. 3. 7 Copyright  20 03, Cisco Systems, Inc. Lab 9. 3. 7 Troubleshooting Routing Issues with Debug Objective • Utilize a systematic OSI troubleshooting ... changes and back up the configuration. Upon completion of the previous steps, log off by typing exit and turn the router off. 5 - 6 CCNA 2: Routers...

Ngày tải lên: 11/12/2013, 14:15

6 368 0
Tài liệu Lab 9.3.7 Troubleshooting Routing Issues with Debug ppt

Tài liệu Lab 9.3.7 Troubleshooting Routing Issues with Debug ppt

... passwords Router 1 GAD 192 .168.1.1 DCE 192 .168.2.1 255 . 255 . 255 .0 class cisco Router 2 BHM 192 .168 .3. 1 DTE 192 .168.2.2 255 . 255 . 255 .0 class cisco Objective • Utilize a systematic OSI troubleshooting ... erase and reload instructions at the end of this lab. Perform those steps on all routers in this lab assignment before continuing. 1 - 6 CCNA 2: Routers and Ro...

Ngày tải lên: 11/12/2013, 14:15

6 283 0
Lab 9.3.4 Troubleshooting using Traceroute

Lab 9.3.4 Troubleshooting using Traceroute

... 1 - 3 CCNA 2: Routers and Routing Basics v 3. 0 - Lab 9. 3. 4 Copyright  20 03, Cisco Systems, Inc. Lab 9. 3. 4 Troubleshooting using Traceroute 2 - 3 CCNA 2: Routers and Routing Basics ... Basics v 3. 0 - Lab 9. 3. 4 Copyright  20 03, Cisco Systems, Inc. Objective Use the traceroute Cisco IOS command from source router to destination router. Use the...

Ngày tải lên: 23/10/2013, 00:15

3 344 0
Lab 9.3.5 DHCP Client Setup

Lab 9.3.5 DHCP Client Setup

... Basics v 3. 0 - Lab 9. 3. 5 Copyright  20 03, Cisco Systems, Inc. Lab 9. 3. 5 DHCP Client Setup Objective The purpose of this lab is to introduce Dynamic Host Configuration Protocol (DHCP) and ... CCNA 1: Networking Basics v 3. 0 - Lab 9. 3. 5 Copyright  20 03, Cisco Systems, Inc. Step 5 Enable DHCP To enable DHCP, select Obtain an IP address auto...

Ngày tải lên: 27/10/2013, 07:15

7 390 0
Lab 3.3.5 Troubleshooting PPP Configuration

Lab 3.3.5 Troubleshooting PPP Configuration

... Lab 3. 3 .5 Troubleshooting PPP Configuration Objective • Configure a PPP on the serial interfaces of two routers. • Use show and debug commands to troubleshoot connectivity issues. ... the equipment in the lab. The configuration output used in this lab is produced from 1721 1 - 6 CCNA 4: WAN Technologies v 3. 0 - Lab 3. 3 .5 Copyright  20 03, Cisco Systems, Inc....

Ngày tải lên: 27/10/2013, 07:15

6 417 1
Lab 9.3.6 Configuring Inter-VLAN Routing

Lab 9.3.6 Configuring Inter-VLAN Routing

... dot1q 20 Router_A(config-subif) #ip address 192 .168.7.1 255 . 255 . 255 .0 Router_A(config-subif)#end 5 - 7 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 9. 3. 6 Copyright  20 03, Cisco ... fastethernet 0/1.2 Router_A(config-subif)#encapsulation dot1q 10 Router_A(config-subif) #ip address 192 .168 .5. 1 255 . 255 . 255 .0 Router_A(config-if)#interface fas...

Ngày tải lên: 05/11/2013, 12:15

7 531 1
Tài liệu Lab 7.3.6 Default Routing with RIP and IGRP docx

Tài liệu Lab 7.3.6 Default Routing with RIP and IGRP docx

... 2: Routers and Routing Basics v 3. 0 - Lab 7 .3. 6 Copyright  20 03, Cisco Systems, Inc. Lab 7 .3. 6 Default Routing with RIP and IGRP Objective • Configure a default route and use RIP ... loopback interface with an IP address. Enter the following commands on the Centre router: Centre(config)#interface loopback0 Centre(config-if) #ip address 172.16.1.1...

Ngày tải lên: 21/12/2013, 19:15

6 529 0
Lab 9.2.5 VTP Client and Server Configurations

Lab 9.2.5 VTP Client and Server Configurations

... typing exit, and turn all the devices off. Then remove and store the cables and adapter. 5 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 9. 2 .5 Copyright  20 03, Cisco Systems, ... 1 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3. 0 - Lab 9. 2 .5 Copyright  20 03, Cisco Systems, Inc. Note: Go to the erase and reload instruct...

Ngày tải lên: 16/10/2013, 21:15

6 532 0
w