Lab 9 2 6 Troubleshooting Using Ping and Telnet

... 2: Routers and Routing Basics v 3.0 - Lab 9. 2. 6 Copyright  20 03, Cisco Systems, Inc. Lab 9. 2. 6 Troubleshooting Using Ping and Telnet Objective • Use knowledge of OSI Layers 1, 2 and ... continuing. 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 2. 6 Copyright  20 03, Cisco Systems, Inc. Step 1 Configure the routers a. On th...

Ngày tải lên: 19/10/2013, 02:15

... - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1 .2. 6 Copyright  20 03, Cisco Systems, Inc. Lab 1 .2. 6 Troubleshooting RIP v2 using Debug Objective • Configure RIP v2 ... log off by typing exit, and turn the router off. Then remove and store the cables and adapter. 5 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1...

Ngày tải lên: 21/12/2013, 19:15

... log off by typing exit and turn the router off. Then remove and store the cables and adapter. 4 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 1 .2. 6 Copyright  20 03, Cisco ... Lab 1 .2. 6 Troubleshooting RIP Version 2 using Debug Objective • Configure RIPv2 on both routers • Use debug commands to verify proper rip operation and analyze d...

Ngày tải lên: 21/12/2013, 19:15

... 2: Routers and Routing Basics v 3.0 - Lab 9. 3.4 Copyright  20 03, Cisco Systems, Inc. Lab 9. 3.4 Troubleshooting using Traceroute 2 - 3 CCNA 2: Routers and Routing Basics v 3.0 - Lab ... HyperTerminal session lab. Erase and reload all routers in this lab assignment before continuing. If there are problems in accomplishing this, go to lab 4 .2. 6 an...

Ngày tải lên: 23/10/2013, 00:15

... Lab 7 .2. 6 Troubleshooting RIP Objective • Set up an IP addressing scheme using class B networks. • Configure RIP on routers. • Observe routing activity using the debug ip rip command. ... possible to ping the GAD router FastEthernet interface? __________________________________________________________________________ 2 - 5 CCNA 2: Routers and Routing Basics v 3.0...

Ngày tải lên: 11/12/2013, 14:15

... Router 1 GAD 1 72. 16. 0.1 DCE 1 72. 17.0.1 25 5 .25 5.0.0 class cisco Router 2 BHM 1 72. 18.0.1 DTE 1 72. 17.0 .2 255 .25 5.0.0 class cisco Objective • Set up an IP addressing scheme using class B networks. ... previous steps, log off by typing exit and turn the router off. 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 7 .2. 6 Copyright  20 03, Cisco Systems...

Ngày tải lên: 11/12/2013, 14:15

... gateway 1 92 . 168 .14 .2 b. The configuration for the host connected to the Birmingham Router is: IP Address 1 92 . 168 . 16 .2 IP subnet mask 25 5 .25 5 .25 5.0 Default gateway 1 92 . 168 . 16. 1 Step 3 ping from ... - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab 4 .2. 6 Copyright  20 03, Cisco Systems, Inc. Lab 4 .2. 6 Troubleshooting IP Address Issues...

Ngày tải lên: 21/12/2013, 19:15

... GAD 1 92 . 168 .14.1 DCE 1 92 . 168 .15.1 NA No address 25 5 .25 5 .25 5.0 Router 2 BHM 1 92 . 168 . 16. 1 DTE 1 92 . 168 .15 .2 NA No address 25 5 .25 5 .25 5.0 2 - 4 CCNA 2: Routers and Routing Basics v 3.0 - Lab ... gateway 1 92 . 168 .14 .2 b. The configuration for the host connected to the Birmingham Router is: IP Address 1 92 . 168 . 16 .2 IP subnet mask 25 5 .25...

Ngày tải lên: 21/12/2013, 19:15

... logoff, by typing exit, and turn all the devices off. Then remove and store the cables and adapter. 5 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 2. 5 Copyright  20 03, Cisco ... vlan 10 Switch_A(config-if)#interface fastethernet 0 /6 2 - 6 CCNA 3: Switching Basics and Intermediate Routing v 3.0 - Lab 9. 2. 5 Copyright  20 03, Cisco System...

Ngày tải lên: 16/10/2013, 21:15

... 1 - 6 CCNA 2: Routers and Routing Basics v 3.0 - Lab 9. 3.5 Copyright  20 03, Cisco Systems, Inc. Lab 9. 3.5 Troubleshooting Routing Issues with show ip route and show ip protocols ... router a. Go to the proper command mode and enter the following: GAD(config)#router rip GAD(config-router)#network 1 92 . 168 .1.0 GAD(config-router)#network 1 92 . 168 .2. 0 GAD(...

Ngày tải lên: 23/10/2013, 00:15