Bơm ECD-V - P - Speed Sensor
Bơm ECD-V - P - Speed Sensor
... SensorConnectorSpeed SensorToothless SectionRoller RingMagnetPulsarCoilPulsarSpeed Sensor0 +-TimeOutputVoltageSensor Output Signal22Throttle Position SensorThrottle Position Sensor 10SERVICE TECH Vol.467 0 3-8 ... engine speed. The speed sensor, along with the throttle position sensor and the acceleratorsensor, is one of the main sensors used for calculating the basic injectionvolu...
Ngày tải lên: 23/10/2012, 09:09
Bơm ECD-V - P - Composition and Construction of ECD-V3 Pump System
... actuator, which performs the function of the spill ring of theprevious distributor type pump, controls the injection quantity.• NE Sensor (NE) - - - - - - - - - - - - - - - - - - - - - - This sensor, ... Vol.465 0 3-4 This session describes the construction and operation of the ECD-V3 pump with respect to the pumping and...
Ngày tải lên: 23/10/2012, 09:09
Bơm ECD-V - P - Determining the Injection Timing
... speed. • Engine speed is lower than target speed - - - - - - - - - - - - - - - - - -Injection volume is increased• Engine speed is higher than target speed - - - - - - - - - - - - - - - - - -Injection ... determinesthe appropriate target value.44Idling Speed Control (ISC) 4-1 C...
Ngày tải lên: 23/10/2012, 09:09
Bơm ECD-V - P -ECD-V Series
... (mm3/st)(MPa)15013011090705 0ECD-V4 ECD-V 5ECD-V3 (ROM)50 100Transition of ECD-V SeriesTotal number of units produced≈Injection Pressure≈ModelECD-V3(ROM )ECD-V4 ECD-V5 - 14 - - ... sensors.PR0063<Sensors><Computer><Actuators> ;Speed SensorAcceleration SensorCrankshaft Position SensorWater Temperature SensorIntake Air Temperature SensorFuel Temperature SensorInta...
Ngày tải lên: 23/10/2012, 09:09
Bơm ECD-V - P - ECD-V4 Outline
... injection pressure. In response, the ECD-V4 is a high-pressure injectionpump with improved features such as fuel pumping and distribution.(Compared with 60MPa for the ECD-V3 , the ECD-V4 has an ... “IJT signal” output is halted.44Solenoid Spill Valve SPV (High Response Type)Pump ChamberOFF ONRotorPassage ClosedPassage OpenPump ChamberRotorEngine ECUEngine ECUON (Approx. 150V) 4-1 Actuati...
Ngày tải lên: 23/10/2012, 09:09
Bơm ECD-V - P - Intake Restriction Control
... Switching Valve)Air PortE PortF PortChamber A or Chamber B Diaphragm PortToFromVacuumPort 1-4 Intake Restriction Position and Driving ConditionsSub Valve PositionFully OpenHalf OpenFully ClosedActuatorVSVVSV1OFFOFFAir ... OutlineInjection PumpVacuum Pump(Vacuum)Exhaust ManifoldEngine Speed SignalAccelerator Position SignalThrottle Position SensorDiaphragm ChamberAirEGR ValveCoolant Temper...
Ngày tải lên: 23/10/2012, 09:09
Bơm ECD-V - P - Outline of Injection Timing Control
... Operation of Components 3-1 Crankshaft Position SensorProjectionCrankshaft Position SensorRelationship between the crankshaft position sensor signal and the engine speed sensor signalEngine Speed ... completes 1/2 a revolution (180° PA), and if the engine has 4cylinders a pulse equivalent to 2 cylinders is output by the engine speed sensor. (The position of the engine speedsensor...
Ngày tải lên: 23/10/2012, 09:09
Bơm ECD-V - P - Outline of Injection Volume Control
... Injection)ONOFFCam LiftPlunger 10SERVICE TECH Vol.468 0 3-1 0 The engine ECU counts the pulses outputted from the speed sensor. The ECU opens (OFF) the solenoid spillvalve at a position corresponding to the ... from the engine speedsensor. The engine speed sensor generates a pulse when its position aligns with the tooth of the pulsar (gear)attached to the drive shaft. The pulsar and...
Ngày tải lên: 23/10/2012, 09:09
Bơm ECD-V - P - Types of Systems in ECD-V Series
... Systems in ECD-V Series 1-1 ECD-V Series 1-2 Injection Pump for ECD-V3 10SERVICE TECH Vol.465 0 3-4 The ECD-V4 , which is based on the ECD-V3 , is an electronically controlled distribution type pump that ... cylinder-by-cylinder basis. Depending on the type of final injection volumecorrection and the solenoid spill valve that are used,three types of ECD-V3 are available: ECD-V...
Ngày tải lên: 23/10/2012, 09:09
Cấu tạo, nguyên lý hoạt động, quy trình bảo dưỡng và sửa chữa tổ hợp máy bơm trám xi măng UNB1R-400(XA400)
... IAM 3-2 38 23 8-1 700010 MSP-4 No-1 UNB1R- 400(XA-400) 11 B 2-5 00AC3 4KPM-500 No-2 UN 1- 630x700(4AN- 700) 4R-700 B 2-8 00TK- C3 3KPM- 0001000 No-3 UN 1- 630x700(4AN- 700) 4R-700 B 2-8 00TK- C3 3KPM- 0001000 ... MSP-5 No-1 UNB1R- 400x40(XA- 400) 14 B 2-5 00TK -C4T2 4KPM.00.000 -0 02 No-2 UNB1R- 400x40(XA- 400) 14 B 2-5 00TK -C4U2 4KPM.00.000 -0 02 No-3 UNB1R-400 (XA...
Ngày tải lên: 28/04/2013, 22:46