Practical feedback loop design considerations for switched mode power supplies

... LWAPP Design Considerations for Cisco PanGo Asset Tracking OL-13268-01 13 PanGo Locator and Cisco WCS PanGo Locator and Cisco WCS As has just been described, both the Cisco WCS as well as PanGo ... document For more information about these capabilities, contact your PanGo representative Design Considerations for Cisco PanGo Asset Tracking 10 OL-1326...

Ngày tải lên: 10/12/2013, 16:16

... relationship (using tube diameters: 4", 3", 2", and 1. 5", 1" and 0.7 5") , and 2) evaluation of measurement repeatability (using the 3" diameter tube) A physical guide was placed on each tube to ... behavior that we will refer to as Type A behavior, and it appears in Figure as line "AG" The sensor reached a peak resistance value just as it was wrapped around the cal...

Ngày tải lên: 19/06/2014, 10:20

... of processing (e.g., two identical systems, one for each side of the sheet, considering the print inspection system described in Section 1) 2.2 Pipeline processing For the particular inspection ... “SIS-Stamp: an integrated inspection system for sheet prints in stamp printing application,” Computers in Industry, vol 56, no 8-9, pp 958–974, 2005 [2] E R Davies, Machine Vi...

Ngày tải lên: 22/06/2014, 22:20

... of steel elevations across a floor It is common in mid- and high-rise construc- DESIGN GUIDE 3, 2ND EDITION / SERVICEABILITY DESIGN CONSIDERATIONS FOR STEEL BUILDINGS / 23 tion to obtain an as-erected ... This Design Guide is the second edition of AISC Design Guide 3, which was originally titled Serviceability Design Considerations for Low-Rise Bu...

Ngày tải lên: 24/10/2014, 17:01

... covers steel fibers for use in fiber reinforced concrete The design procedures discussed in this report are based on fibers meeting that specification Additional sources of information on design ... of Reinforced Fibrous Concrete Columns,” Fiber Reinforced Concrete- International Symposium, SP81, American Concrete Institute, Detroit, pp 69-105 Criswell, M E., Aug 1976...

Ngày tải lên: 24/10/2014, 22:11

... a ROM application using an EPROM, or if trying to port a EPROM product to ROM to realize a cost reduction OSCILLATOR PERFORMANCE Oscillator performance is a key parameter that may vary relatively ... AN721 SUMMARY When developing a new ROM application using an EPROM-based MCU, or when attempting to move an established EPROM-based design to ROM to reduce costs, there are...

Ngày tải lên: 11/01/2016, 11:34

... minimising the overlap between the current and voltage waveforms In the other part of the period, the active device is turned off acting as an open circuit Therefore, the current is theoretically ... not play any role in the www.intechopen.com The Switched Mode Power Ampliiers 363 solution of the system As a consequence, the current flowing into the output branch o...

Ngày tải lên: 27/07/2014, 23:55

... INVESTIGATIONS INTO DESIGN AND CONTROL OF POWER ELECTRONIC SYSTEMS FOR FUTURE MICROPROCESSOR POWER SUPPLIES Ravinder Pal Singh (B.Tech(Hons), IIT Kharagpur, India) A THESIS SUBMITTED FOR ... requirements, the design of next generation VRMs need a thorough understanding of the performance and design trade-os The supply voltage of the microprocessor w...

Ngày tải lên: 11/09/2015, 10:06

... describing function (DF) analysis [14] The DF of the relay function and the equivalent gain can be given as follows: Analysis of Closed-Loop Performance for Sliding Mode Control Systems N (a) = kn(DF ... with the presence of parasitic dynamics Analysis of Closed-Loop Performance for Sliding Mode Control Systems 59 or switching imperfections, and t...

Ngày tải lên: 01/07/2015, 09:37

... framing information for A/C/E p/g a method for generating aesthetic measures an aesthetic measure for process or product a method for generating concepts a concept a method for generating expressions ... develop its own aesthetic measures for the design process, strengthening its performance creatively Conclusion We have introduced a new set of capabilities for the auto...

Ngày tải lên: 19/02/2014, 17:20

Ngày tải lên: 14/03/2014, 19:33

... Is the primary root valve available and accessible to shut off the line? Could water be FIRE-PROTECTION CONSIDERATIONS FOR THE DESIGN AND OPERATION OF LIQUIFIED PETROLEUM GAS (LPG) STORAGE FACILITIES ... Institute FOREWORD This publication covers aspects of the design, operation, and maintenance of liqueÞed petroleum gas (LPG) storage fac...

Ngày tải lên: 27/03/2014, 14:07

... CREB Adipogenesis COX-2 PGF2α AKR1B3 PGE2 Fig Schematic representation of a novel suppression mechanism operating in the early phase of adipogenesis through a positive feedback loop by enhancement ... molecular mechanism of this Fluprostenol -mediated increase in PGF2a production in adipocytes, at first we investigated the expression of genes invo...

Ngày tải lên: 28/03/2014, 22:20

... Population level risk assessment: practical considerations for evaluation of population models from a risk assessor's perspective Magnus Wang*1 and Robert Luttik2 RIFCON ... used data (especially if samples sizes are available) A qualitative analysis of uncertainty can be sufficient; see for instance the approach in chapter 6.8 of the Guidance document for...

Ngày tải lên: 20/06/2014, 20:20

... Population level risk assessment: practical considerations for evaluation of population models from a risk assessor's perspective Magnus Wang*1 and Robert Luttik2 RIFCON ... used data (especially if samples sizes are available) A qualitative analysis of uncertainty can be sufficient; see for instance the approach in chapter 6.8 of the Guidance document for...

Ngày tải lên: 20/06/2014, 20:20