Applying The Finite Element Method To Drill Design Based On Drill Deormations
Applying The Finite Element Method To Drill Design Based On Drill Deormations
... cross-section shape of the conventional twist drill based upon the torsional rigidity of the drill This allows the torsional rigidity of the drill to be improved through changing the cross-sectional ... and the torsional strength of the drill The design of the twist drill with special cross-sectional shape based upon drill deformations and how the dr...
Ngày tải lên: 25/11/2016, 21:51
Lecture Notes: Introduction to the Finite Element Method
... Lecture Notes: Introduction to the Finite Element Method Preface These online lecture notes (in the form of an e-book) are intended to serve as an introduction to the finite element method (FEM) ... University of Cincinnati v Lecture Notes: Introduction to Finite Element Method Chapter Introduction Chapter Introduction I Basic Concepts The...
Ngày tải lên: 23/10/2013, 15:46
Process design in flashless forging of rib web-shaped plane-strain components by the finite element method
... closure of dies, shown in Fig 14(b), is typical of the closed-die forging process The load is normalized by dividing it by the initial yield strength of the workpiece The final loads during the finish ... the finishing operation with finisher die III The flashless filling in the final product is achieved, which is one of the design conditions The...
Ngày tải lên: 24/11/2016, 18:08
