Design of piping systems for the food processing industry

... Guideline no 5: Design of piping systems for the food processing industry – with focus on hygiene Guideline no 6: Installation of components in closed processing plants for the food processing industry ... replacement of New Page of 29 Guideline no Introduction This guideline provides general advice on the design of piping systems in the food...

Ngày tải lên: 11/11/2016, 17:21

Ngày tải lên: 14/03/2014, 19:33

... Chapter 7: Hydraulic systems for boom-type trucks 201 Hydraulic circuit for boom lift, extend and fork tilt 202 Hydraulic lift & lower circuit for telescopic boom 203 Hydraulic circuit ... illustrate design principles and methods for designing and calculating hydraulic systems for industrial lift trucks Determining the main parameters of these systems is bas...

Ngày tải lên: 23/03/2014, 11:37

... DESIGN OF PROTEIN LINKERS FOR THE CONTROLLED ASSEMBLY OF NANOPARTICLES CHEN HAIBIN (B ENG, XI’AN JIAOTONG UNIVERSITY, P R CHINA) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY ... protein forms, was investigated Chapter 1.3 Outline of the thesis This thesis is composed of eight chapters Chapter describes the motivation and defines the objecti...

Ngày tải lên: 14/09/2015, 14:08

... Rotor resistance: Stator leakage inductance: Rotor leakage inductance: Magnetizing inductance: The fundamental current on rotor side is a little larger than that of the converter side because the ... filter, the constraints on designing the parameters of the LCL filter are provided Based on the constraints, two LCL filters, one in Y connection and one in delta c...

Ngày tải lên: 25/08/2016, 19:15

... explanation without intent to infringe Library of Congress Cataloging -in- Publication Data Waste treatment in the food processing industry / edited by Lawrence K Wang … [et al.] p cm Includes bibliographical ... 263 – 12 65 – 550 410 380 8.6– 15 5.5 – 14 0 12 5 16 0 1. 4 – 58.5 – 30 70 95 6.5– 46.3 – 35 12 14 16 13 15 15 17 Milk Milk/cream bottling plant – 20 –50 5...

Ngày tải lên: 11/08/2014, 17:22

... 950 – 34 90 900 –4620 944 – 2992 1950 975 33 30 31 00 8 833 – 11,244 Suspended solids (SS) (mg/L) 36 77 633 – 717 35 74 900 – 32 00 30 0 – 4200 457 – 929 200 – 1000 137 5 38 1 – 38 69 12 15 30 22 23 24 26 ... Meat processing and rendering In Pollution Prevention and Abatement Handbook; World Bank: Washington DC, 1988: 33 6 – 34 0 Johns, M.R Developments in wastewater treatm...

Ngày tải lên: 11/08/2014, 17:22

... by excavating the earth Hence, the ponding system is widely favored by the palm oil industry due to its marginal cost In constructing the ponds, the depth is crucial for determining the type of ... is then reintroduced to the purification stage The process will prevent excessive scum formation during the primary treatment and increase oil production The MRE is then pu...

Ngày tải lên: 11/08/2014, 17:22

... 0: 15  250 0  1:4 ¼ (51 0 þ 52 5) À ½ (51 0 þ 52 5)2 À (4  52 5  0:8  51 0)Š1=2  52 5 ¼ 10 35 À 463 ¼ 0 :54 5 1 050 The oxygen required is: O2 =day ¼ (a0 Sr þ 1:4bXd Xv t)Q ¼ ½(0 :55 Â1020) þ (1:4Â0: 15 0 :54 5 250 0 ... experiment aimed at gaining better insight into the degradation of the main compounds contained in the OME, in particular, the interaction between...

Ngày tải lên: 11/08/2014, 17:22

... present in the waste [24] As for potato processing wastewater in general, the water from the balancing tank (buffer tank) is pumped into a conditioning tank where the pH and temperature of the wastewater ... alcohol The quantities and qualities of the wastewaters resulting from the mentioned potato processing plants are discussed in the next section 6. 3 6. 3.1...

Ngày tải lên: 11/08/2014, 17:22

... performed on the soft drinks or their components in the laboratories of the bottling plants After the soft drinks leave the manufacturing factory, they may be subjected to further testing by external ... unpacking machines remove the caps from the bottles, then cleaning machines wash the bottles repeatedly until they are thoroughly clean The cleaned bottles are examined by...

Ngày tải lên: 11/08/2014, 18:20

... 10 in common food industry, much higher than that of in the chemical industry and in the paper and textiles industry [3,6] Normally, half of the water is used in the process, while the remainder ... 100.00 N/A 644 3, 583 6,1 38 16, 186 17,103 18, 872 45,432 43,251 45, 184 8, 820 7,295 11,077 223, 585 N/A 487 505.5 753 1,2 08. 1 1,5 78. 7 23,51.7 10 ,82 0.5 6,909.1 3...

Ngày tải lên: 11/08/2014, 18:20

... 292 Ukita et al Figure 9. 1 Nitrogen cycle relating to food in Japan The rate of Japan’s self supply of domestic food was 41% in 197 0, 32% in 199 0, and 29% in 199 8 for N, and 33% ( 197 0), 29% ... enforced 9. 3 9. 3.1 LIQUID WASTES FROM FOOD INDUSTRIES Wastewater Treatment Systems for Food Processing Different sources contribute to the generation of wastewater i...

Ngày tải lên: 11/08/2014, 18:20

... with the Same Capacity Productivity Approach for Resource Allocation with the Same Capacity Comparison of Two Approaches in the Same Capacity System Parameters and Strategic Approaches New Allocation ... standardized service allow service firm in this quadrant to operate similar to factories that can take advantage of economy of scale The lower right quadrant is for a...

Ngày tải lên: 22/05/2016, 11:25

... with the system Ranking of Redesign Alternatives Another area requiring research attention in the context of generation of redesign solutions (design advisor) is the ranking of the generated redesign ... Evaluation Typically, the designer designs a product with minimal knowledge about the capabilities and limitations of the manufacturing technology The designer th...

Ngày tải lên: 19/01/2014, 18:20