Ngày tải lên: 02/04/2014, 15:50
... al Tar measurement standard for sampling and analysis of tars and particles in biomass gasification product gas In: 14th European Biomass Conference Proceedings Paris, France; 2005 Freda C, Fanelli ... case that calcium enriches in the ash layer covering bed material particles, the catalytic reforming of tar can be enhanced to a great degree The behaviour of catalytic and non...
Ngày tải lên: 01/08/2016, 09:30
Modelling and verification of single slope solar still using ANSYS-CFX
... annually cost of distillate output of Inverted absorber solar still and single slope solar still were 0.95 & 0.54 Rs A.J.N Khalifa[10] studied literature on relation between cover tilt angle and productivity ... the distillate water to an external measuring jar Whole set up of solar still is installed on stand Figure Experimental set up of solar still Flow ge...
Ngày tải lên: 05/09/2013, 15:28
Tài liệu Design and optimisation of conformal cooling channels in injection muolding tools docx
... effectiveness of conformal cooling channels and selective laser sintering material in injection moulding tools, RPD (2002) 1–5 [6] F Jacobs, High-conductivity Materials and Conformal Cooling Channels, ... paid to designing corners and the cooling system in these areas On the issue of dimensional criteria in designing cooling channels, three dimensions have t...
Ngày tải lên: 12/02/2014, 22:20
New trends on urban goods movement: modelling and simulation of e-commerce distribution docx
... settings: determination of the destinations and modelling of the O-D interactions and single trips Routes construction: their simulation is got by trip chain aggregation The combining of trips to a ... consumer behaviour in the supply chain, Russo and Comi (2004) propose a conceptual analysis of the end-consumer movements between the shops zone (d) and the consumption zone...
Ngày tải lên: 23/03/2014, 10:20
Báo cáo hóa học: " Research Article Modelling and Implementation of QoS in Wireless Sensor Networks: A Multiconstrained Traffic Engineering Model" pdf
... to a source and carry the information concurrently to the destination in order to achieve load balancing and rapid delivery of the information In a wireless sensor network, both single paths and ... reveals a gain which increases with the reduction of the play-back delay Note however that while multipath routing may result in playback delay gain, increasing the path...
Ngày tải lên: 21/06/2014, 17:20
Modelling and Control of Snake Robots
... within modelling and control of snake robots as steps toward developing snake robots capable of such operations A survey of the various mathematical models and motion patterns for snake robots ... in robots that look and move like snakes snake robots These robots most often have a high number of degrees of freedom (DOF) and they are able to move witho...
Ngày tải lên: 04/08/2014, 09:37
Báo cáo khoa học: "Synthesis and analysis of biomass and net primary productivity in Chinese forests" docx
... extant dataset on biomass and NPP of biomes, including 17 major forest types of Biomass and NPP of Chinese forests China, and their analyses and synthesis First, we introduce the existing methodologies ... forest and monsoon forest in Hainan Island and the 358 Table II Statistics of leaf area index (LAI), total biomass and annual net primary productivity...
Ngày tải lên: 08/08/2014, 14:21
Báo cáo sinh học: " Modelling and optimizing of sequential selection schemes: a poultry breeding application" ppt
... asymptotic genetic gain and lags in a multistage poultry breeding plan is described It involves selection of best pairs of mated animals with overlapping generations and BLUP evaluation of candidates ... = among all the and A male is mated with d dams The probability of selecting sire should account for all the possibilities that can arise, based of the dams it is ma...
Ngày tải lên: 09/08/2014, 18:22
Modelling and control of bioinspired robotic fish underwater vehicle and its propulsion mechanism
... Computed-Torque Control (CTM) Model of Robotic fish 158 xiv LIST OF FIGURES 5.2 Feed-forward Control (FF) Model of Robotic fish 161 5.3 Feed-forward plus Computed Torque Control (FF) Model of Robotic ... suitable to both vehicular morphology and methods of locomotion The study of underwater evolution of life and its plethora of locomotion modes has long been...
Ngày tải lên: 09/09/2015, 08:13
Modelling and classification of motor imagery EEG for BCI
... between motor imagery and executed movement [39, 40, 41] Moreover, motor imagery can even lead to performance improvements for athletes, and previous studies also suggest the effectiveness of motor imagery ... motor imagery, BCI can translate motor imagery of certain actions into commands for possible orthosis to perform predefined tasks, which is illustrated by...
Ngày tải lên: 09/09/2015, 11:22
Modelling and simulation of faceted boundary structures and dynamics in FCC crystalline materials
... most special type of faceted boundary is the twin boundary Various types of twin boundaries including deformation twins, transformation twins and growth twins with twin sizes ranging from a few ... studies indicate the ultrahigh strength of nanotwinned crystalline metals is related to nanotwin induced interface strengthening The increase in strength with decreasing grain siz...
Ngày tải lên: 11/09/2015, 10:03
Modelling and control of subsea installation
... Modeling and Control of Subsea Installation How Voon Ee (B.Eng, NATIONAL UNIVERSITY OF SINGAPORE ) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF ELECTRICAL AND COMPUTER ... writing, project planning and management, manpower recruitment, documentation and hard work in meeting deliverables of two research projects: Modelling and Control...
Ngày tải lên: 14/09/2015, 08:37
Modelling and simulation of ion implantation induced damage
... crystal structure Understanding of ion implantation induced damage is crucial as it affects device performance In addition, modeling and simulation of ion implantation induced damage is complicated ... fabrication of transistors, it is essential to understand the impact of a buried oxide interface on defect evolution and dopant diffusion 1.1.2 Modeling and Simu...
Ngày tải lên: 14/09/2015, 09:22