DOCUMENT FOR EXAMINATION

... 83 Document about design database table 84 Database Diagram 90 Design Detail .91 Design Detail 94 Task Sheet 182 Design ... Repair information about candidate  Delete information about candidate (A4): Teacher chooses the function “Repair information about candidate” (B3) (A5): System displays a repair information form ... Repair information about exam class  Delete information a...

Ngày tải lên: 08/08/2013, 09:25

... Module Guide for the training document Automation- and Drive Technology- SCE T I A Training document Last revision: 02/2002 Page of 54 Module Guide for the training document Automation- and Drive ... Guide for the training document Automation- and Drive Technology- SCE T I A Training document Last revision: 02/2002 Page 43 of 54 Module Guide for the...

Ngày tải lên: 25/01/2014, 09:20

... Performance of Multi-Engine Aeroplanes - definitions of terms and speeds used any new terms used for multi-engine aeroplane performance - Importance of performance calculations determination of ... carry-on luggage, useful load (traffic load + usable fuel Effects of overloading: high take-off and safety speeds, longer take-off and landing distances, lower rate -of-...

Ngày tải lên: 07/03/2014, 11:20

... for the electrical conductivity of water The concentrations of these ions are very small At −7 25°C, for pure water, there is a concentration of × 10 mole per liter of the hydronium ion and of ... concentrations of 250 mg/L are objectionable, however, would depend upon the degree of acclimation of the user to the water In Antipolo, a barrio of Cebu in the Philippine...

Ngày tải lên: 19/06/2014, 16:20

... downstream end of flume D = width of upstream end of flume E = depth of flume F = length of throat G = length of diverging section K = difference in elevation between lower end of flume and crest of floor ... size of flume (in terms of throat width) A = length of side wall of converging section 2/3A = distance back from end of crest to gage point B = axial length of conv...

Ngày tải lên: 19/06/2014, 16:20

... the pump At 20°C, Pv (vapor pressure of water) = 2.34 kN/m = 0.239 m of water Assume standard atmosphere of atm = 10.34 m of water Therefore, theoretical limit of pump cavitation = − (10.34 − 0.239) ... sectional area of pipe π ( 0.375 ) /4 Assume temperature of water = 25°C; therefore, density of water = 997 kg/m 196 ( 1000 ) 1.36 TDH = - + - = 20.13 m of water...

Ngày tải lên: 19/06/2014, 16:20

... because of formation of gases, makes solids rise resulting in inefficiency of the basin Thus, in practice, there is a practical range of values of 1.5 to 2.5 h based on the average flow for primary ... of combinations of the values of the elements of Vc[Xc] + Vu[Xc] can occur before the solids reach the critical section of the thickener This combination corresponds to the...

Ngày tải lên: 19/06/2014, 16:20

... Projected area of paddle blade Sum of projected areas of paddle blades Length of paddle blade Coefficient of drag Width of paddle blade The diameter of the impeller Diameter of vessel Distance of impeller ... length of the paddle blades of the longest compartment to that of the length of the paddle blades of the middle compartment is 2.6:2, and the ratio of the le...

Ngày tải lên: 19/06/2014, 16:20

... weight of water Specific weight of particle Specific weight of water Absolute viscosity of water Porosity PROBLEMS 7.1 A consultant decided to recommend using an effective size of 0.55 mm and a uniformity ... Proportionality constant for the inertial force Proportionality constant for the shear force Length of bed Expanded bed depth Filter yield Rate of mass inflow into b...

Ngày tải lên: 19/06/2014, 16:20

... Index of membrane and boundary layer compressibility Surficial area Time of operation Absolute velocity of bed Absolute superficial velocity of water Relative superficial velocity of flowing water ... Oxford England Bou-Hamad, S., et al (1997) Performance evaluation of three different pretreatment systems for seawater reverse osmosis technique, Desalination Int Symp Pretreatment...

Ngày tải lên: 19/06/2014, 16:20

... affinity of the solute to form into a solid An example of this operation is the making of ice from liquid water The formation of snow from water vapor in the atmosphere is also a process of crystallization ... performs an experiment for the purpose of determining the value of β of a particular wastewater The [Cos,w] of the wastewater after shaking the jar thoroughly is...

Ngày tải lên: 19/06/2014, 16:20

... Inflow to softening plant Concentration of magnesium in influent from first stage of splittreatment softening plant Concentration of magnesium in treated water Concentration of raw water to softening ... the number of reference species is moles of positive charges for each of these reactions Thus, the equivalent mass of calcium is Ca/2 and the number of equivalents of t...

Ngày tải lên: 19/06/2014, 16:20

... Physical–Chemical Treatment of Water and Wastewater Coucke, D., et al (1997) Comparison of the different methods for determining the behaviour of water to calcium carbonate Aqua (Oxford) 46, 2, 49–58 ... complex of calcium ion + CaOH Hydroxide complex of calcium ion [∆carb] Moles of carbon dioxide per unit volume of flow required to bring the pH of water to the satura...

Ngày tải lên: 19/06/2014, 16:20

... be used Therefore, we now derive the formulas for estimating the volume of sludge produced in coagulation treatment of water Two sources of solids are available for the production of sludge: the ... The amount of pure lime used per cubic meter of water coagulated is 0.016865135 kg The pH of coagulation was adjusted to 8.15 Calculate the value of the current pH of the...

Ngày tải lên: 19/06/2014, 16:20