Feedback and control system

Ngày tải lên: 31/03/2014, 14:20

... systems A complete C2 system is described by its control architecture and the underlying software architecture 2.1 Command and Control Architecture Command and Control system architecture generally ... develop a command and control system that can be deployed in modular AUVs and in the future, allows natural extension and simple modification for multi-AUV sce...

Ngày tải lên: 04/10/2015, 10:26

... important and may in fact be the over riding reason for the use of fuzzy logic Byte Craft Limited i Fuzzy Logic in Embedded Microcomputers and Control Systems Appendix The appendix contains, in addition ... Limited Fuzzy Logic in Embedded Microcomputers and Control Systems Fuzzy Proportional Contoller Set Point Manipulated Variable Process Process E...

Ngày tải lên: 08/03/2016, 11:34

... depends on the error term E(t) Conclusion This paper proposes a combination of the identification algorithm and the modal superposition method for feedback active control of incomplete measured systems ... original identification algorithm is the requirement of the knowledge of entire state vector x(t) Combination of the identificatio...

Ngày tải lên: 28/03/2014, 13:20

... original identification algorithm is the requirement of the knowledge of entire state vector x(t) Combination of the identification algorithm and the modal superposition method The incomplete measurement ... depends on the error term E(t) Conclusion This paper proposes a combination of the identification algorithm and the modal superpos...

Ngày tải lên: 28/03/2014, 13:20

... PC and controls, control devices remotely We use Yahoo server to connect Center PC to Remote PC Center PC send commands to Remote PC via Yahoo Messenger After receiving command of Center PC, Remote ... (storage and graph) 1.4 Model connection for collecting data from remote sensor using internet Home PC Internet RS232 RS232 Remote PC Remote Center Sensor RS232 Extended...

Ngày tải lên: 25/04/2013, 11:25

... function does go here % MATLAB command 1; MATLAB command 2; MATLAB command 3; The name of the m-file for this function is functionname.m and it is called from the MATLAB command line or from another ... e.g., ‘ls’, ‘pwd’, and ‘cd’ These are handy for listing MATLAB s working directory, checking the path to the working directory, and changing the working directory MATLAB ch...

Ngày tải lên: 12/12/2013, 07:15

... dellortnoc eb ot metsys eht htiw gnikrow yltcerid ot srefer ”smetsys ngiseD no sdnaH“ “Hands-on” Design of Control Systems metsys redro dnoces fo esnopseR petS :5 erugiF 0 20 40 60 time (secs) 80 100 ... hcihw maeb a no sedils m ssam fo llab A :4 giF ni nwohs metsys maeB-dna-llaB eht redisnoC Ball -and- Beam deniatbo stluser eht no tnemmoC 1x ssam tsrfi eht fo noitisop eht fo daetsni derus...

Ngày tải lên: 12/12/2013, 07:15

... of the model with some laws of physics OBJECTIVE AND CONTENTS OF THE BOOK Relationship between the model parameters and the hysteresis loop Identification of the model parameters Control of systems ... parameter ¯ values = and n = with the Figure 4.8 Variation of x with the parameter ¯ values = and n = with the 81 83 Figure 4.9 Variation of x with...

Ngày tải lên: 12/12/2013, 22:41

Ngày tải lên: 13/12/2013, 01:16

Ngày tải lên: 14/12/2013, 12:15