Fundamentals of AC machines

... interaction between the stator and rotor flux vectors Field oriented control (FOC) and direct torque control (DTC) methods are the two main approaches of achieving torque control of AC machines ... STATOR FLUX VECTOR BASED MODULATION AND CONSTANT SWITCHING FREQUENCY DIRECT TORQUE CONTROL OF AC MACHINES ANSHUMAN TRIPATHI (M Tech., IIT Kanp...

Ngày tải lên: 16/09/2015, 17:13

... showing at the end of your picture Start with the outline The colour could be ultramarine but a fairly watery mix Then define all the blocks of architecture and the line of the base of the buildings ... or lying on the ground) with all the vertical poles diminishing in size as they proceed along the limiting lines of perspective towards a central vanishing po...

Ngày tải lên: 13/09/2012, 14:19

Ngày tải lên: 18/09/2012, 10:11

... capabilities of the Linux system Think Beyond What features of the Linux UNIX environment set it apart from a typical standalone PC environment? What would some of the benefits of these features ... Linux Computing Environment Objectives Upon completion of this module, you should be able to: • • • • List the four main components of a computer Describe the three main componen...

Ngày tải lên: 18/09/2012, 10:11

... (Electronic) FUNDAMENTALS OF RF CIRCUIT DESIGN with Low Noise Oscillators FUNDAMENTALS OF RF CIRCUIT DESIGN with Low Noise Oscillators Jeremy Everard University of York, UK JOHN WILEY & SONS, ... Fundamentals of RF Circuit Design with Low Noise Oscillators Jeremy Everard Copyright © 2001 John Wiley & Sons Ltd ISBNs: 0-471-49793-2 (Hardba...

Ngày tải lên: 08/04/2013, 10:50

... sizeof 8.4 Operator Functions As Class Members Vs As Friend Functions • aa@bb • @aa • aa@ aa .operator@ (bb) operator@ (aa,bb) aa .operator@ ( ) operator@ (aa) aa .operator@ (int) operator@ (aa,int) • Operator ... toán tử • Overloading operators – Tạo hàm lớp – Đặt tên hàm operator ký hiệu • Operator+ dành cho phép cộng + © 2003 Prentice Hall, Inc All rights reserved 4 8.2 Funda...

Ngày tải lên: 29/09/2013, 07:20

... that depends on the nature of joints Some representative values of C’s are tabulated in Table below Table Values of C for various types of joints Type of joint Value of C Metal to metal joint ... adequate load of variable magnitude Design of two important mechanical joints is discussed below, namely, bolted and welded joints Bolted joints with variable loading: Consider des...

Ngày tải lên: 18/10/2013, 09:15

... operation of the T-flip-flop on clocking © National Instruments Corporation 6-1 Fundamentals of Digital Electronics Lab JK Master-Slave Flip-Flop Figure 6-2 LabVIEW Simulation of a Divide-by-Two Counter ... value of 255 Fundamentals of Digital Electronics 7-4 © National Instruments Corporation Lab Digital- to-Analog Converter Figure 7-5 LabVIEW Simulation o...

Ngày tải lên: 19/10/2013, 11:15

... an inefficient utilization of the available degrees of freedom in the system: bits 47 are packed into smaller number of dimensions instead of spreading into larger number of dimensions as in the ... diversity is achieved by averaging over the fading of the channel over time Typically, the channel coherence time is of the order of 10’s to 100’s of symbols and therefore the chan...

Ngày tải lên: 20/10/2013, 07:15