AN0761 LDO thermal considerations
Báo cáo y học: "Special considerations in the treatment of patients with bipolar disorder and medical co-morbidities"
... of patients with bipolar disorder were obese Pharmacotherapy and affective episodes both influence appetite and physical activity, thereby increasing the risk for obesity Obesity in bipolar patients ... metabolite syndrome), including carbamazepine, phenytoin, phenobarbital, and lamotrigine The triad of hypersensitivity includes fever, rash and internal organ inv...
Ngày tải lên: 25/10/2012, 10:51
Báo cáo y học: "Technical Considerations in Decompressive Craniectomy in the Treatment of Traumatic Brain Injury"
... and in most reports the involved patient populations are small, these experiences are valuable At present, in the absence of definite proof of the efficacy of decompressive craniectomy in the treatment ... enough for the enlargement of dura in during decompressive craniectomy, and forms a pedicle of temporal fascia that maintains the blood supply Brain...
Ngày tải lên: 25/10/2012, 11:40
Ethical Considerations Outline
... Outline Ethics Defined Ethical Negotiation Negotiation Tactics Ethics and Emotion Responding to Unethical Negotiators Ethics Behaving in moral ways ... Persuasion based on reason alone may be more ethical Reasoning alone may be insufficient to convince or persuade others Use of emotion in persuasion may be unethical if the negotiators intent is ... unethical if the neg...
Ngày tải lên: 29/10/2012, 15:28
A CFD study of hygro-thermal stresses distribution in tubular-shaped ambient air-breathing PEM micro fuel cell during regular cell operation
... operating system Figure Computational mesh of a tubular-shaped ambient air-breathing PEM micro fuel cell (quadratic) The values of the electrochemical transport parameters and the material properties ... fuel cell performance 2.1 Computational domain A schematic description of a tubular-shaped air-breathing PEM micro fuel cell is shown in Figure 1a...
Ngày tải lên: 05/09/2013, 14:58
A CFD analysis on the effect of ambient conditions on the hygro-thermal stresses distribution in a planar ambient airbreathing PEM fuel cell
... Maher A. R Sadiq Al-Baghdadi A CFD study of hygro-thermal stresses distribution in tubularshaped ambient air-breathing PEM micro fuel cell during regular cell operation International Journal of Energy ... differential between the fuel cell stack and the operating environment make thermal management a challenging problem in PEM fuel cells As the am...
Ngày tải lên: 05/09/2013, 14:58
Prediction of deformation and hygro-thermal stresses distribution in PEM fuel cell vehicle using threedimensional CFD model
... effect of hygro-thermal stresses into actual three-dimensional fuel cell model This model is used to investigate the hygro and thermal stresses in PEM fuel cell, which developed during the cell ... model of a PEM fuel cell has been developed to simulate the hygro and thermal stresses in PEM fuel cell, which are occurring during the cell operat...
Ngày tải lên: 05/09/2013, 14:58
Simulation of the thermal borehole resistance in groundwater filled borehole heat exchanger using CFD technique
... temperatures in the middle of the borehole, while constant temperature results in a more even spread of the heat in the borehole Using constant heat flux at the pipe wall (cq"pw) thus results in higher thermal ... the bedrock and steady-state inside the borehole using the borehole thermal resistance to describe the heat transfer through th...
Ngày tải lên: 05/09/2013, 14:58
Thermal properties of the vernacular buildings envelopes: the case of the "Sassi di Matera" and "Trulli di Alberobello
... rocky church crypt [3], the energetic behavior and the microclimate of different hypogeous structures in the site of the "Sassi of Matera" [4, 5], and the thermal behavior of different opaque envelopes ... namely, “Tufo of Matera” for the structures of the "Sassi of Matera," and “Stone of Fasano” for the structures of the "Trulli of...
Ngày tải lên: 05/09/2013, 14:58
An experimental study on the thermal valorization of municipal and animal wastes
... expresses the effect of ambient gas composition and f describes the change of surface reactivity as a function of the fractional burn off: As the function g(Po2) represented the partial pressure of ... can be found in a previous study [11] Results and discussion 4.1 Characterization of the fuels A comparison of the proximate and ultimate analysis results, as...
Ngày tải lên: 05/09/2013, 15:28
Investigation of thermal effect on exterior wall surface of building material at urban city area
... discussions 3.1 Analysis of existing exterior building based on different materials This part discusses the four locations of the monitored area with different types of exterior wall building materials: ... heat/solar radiation) of each material was calculated and analyzed (Figure 10) Figure 10 Normalized heat (total heat/solar radiation) using average heat of convec...
Ngày tải lên: 05/09/2013, 15:28
Building thermal performance in Saharan climate
... Comfort in the Saharan regions In the desert climates, providing indoor thermal comfort constitutes a main objective Among solutions contributing to the improvement of the thermal comfort in these ... Building s geometry and orientation play a major role in determining building s thermal efficiency The ∆t m method presented here allows a good opportunity to evaluate influenc...
Ngày tải lên: 05/09/2013, 16:11
Thermal evaluation of a sun tracking solar cooker
... double-glazed solar cooker, Kumar [7] One of the earliest mathematical models to test the thermal performance of a Solar Cooker was presented by Garg et al [8] and Vaishya et al [9] Also, Jubran and Alsaad ... concentrating/oven type solar cooker, and the parameters that characterize the performance of the solar cooker Evaluation of solar cooker thermal perfo...
Ngày tải lên: 05/09/2013, 17:03
Experimental study of passive cooling of building facade using phase change materials to increase thermal comfort in buildings in hot humid areas
... the buildings It is the new way to design the smart buildings with light weight by incorporating the PCMs inside the hollow cavity of brick Environment Friendly Cooling of building using phase change ... benefits remain uncertain, especially for the residential sector This study investigates the potential of using PCM for thermal heat storage in building facade...
Ngày tải lên: 05/09/2013, 17:03