Lab Excercise - Cisco IDS Appliance Configuration

... Cisco Security Setup & Configuration: Part – Network & Host-Based IPS Isaac A Valdez, Global Knowledge Instructor, CCSI, CCSP, CCNP, CCDP Introduction This paper is the third in a three -part ... not be enough That is where we install, configure, and use Network- and Host-based Intrusion Prevention Systems (IPS) IPS/ HIPS IPS/ HIPS provide for an increased le...

Ngày tải lên: 09/12/2013, 17:15

... be an 802.1x authenticator using RADIUS as the authentication protocol: AccSw 01( config)#aaa new-model AccSw 01( config)#radius-server host 10 .1. 1 .1 AccSw 01( config)#radius-server key RADk3y 01 AccSw 01( config)#aaa ... proper software can be used as a firewall just the same as a dedicated firewall Device Hardening:Taking a Layered Approach When it comes to securing your net...

Ngày tải lên: 10/12/2013, 14:15

... Step Save the configuration a Save the running configuration to the startup configuration at the privileged EXEC mode GAD#copy running-config startup-config Note: Save the running configuration ... shutdown The running configuration will be lost if the running configuration is not saved The router uses the startup configuration when the router is started Step Verify the configu...

Ngày tải lên: 11/12/2013, 13:15

... Step Save the configuration a Save the running configuration to the startup configuration at the privileged exec mode GAD#copy running-config startup-config Note: Save the running configuration ... shutdown The running configuration will be lost if the running configuration is not saved The router uses the startup configuration when the router is started Step Verify the configu...

Ngày tải lên: 11/12/2013, 13:15

... Cisco TFTP Server a Check with the instructor as to where the Cisco TFTP server is installed on the student workstation b Start the TFTP server If the computer is properly connected, there is no configuration ... running-config to TFTP server a Before copying the files, verify that the TFTP server is running b Record the IP address of the TFTP server c 2-5 Issue the command...

Ngày tải lên: 11/12/2013, 14:15

... Cisco Security Setup & Configuration: Part – Network & Host-Based IPS Isaac A Valdez, Global Knowledge Instructor, CCSI, CCSP, CCNP, CCDP Introduction This paper is the third in a three -part ... not be enough That is where we install, configure, and use Network- and Host-based Intrusion Prevention Systems (IPS) IPS/ HIPS IPS/ HIPS provide for an increased le...

Ngày tải lên: 21/12/2013, 04:18

... Access to MARS on the Security Appliance Cisco Security Appliance Command Line Configuration Guide OL-12172-01 37 Contents Adding a Security Appliance to Monitor Adding Security Contexts Adding ... Features GLOSSARY INDEX Cisco Security Appliance Command Line Configuration Guide 38 OL-12172-01 About This Guide This preface introduce the Cisco Security Applia...

Ngày tải lên: 21/12/2013, 05:18

... cisco Enter setup at the router prompt to start the system configuration dialog Option If the router was previously configured, it is possible to simulate a new router by removing the configuration ... configuration file from NVRAM using the erase startup-config command in privileged mode Use the reload command to restart the router and enter setup mode Step Continue with...

Ngày tải lên: 21/12/2013, 19:15

... Cisco TFTP Server a Check with the instructor as to where the Cisco TFTP server is installed on the student workstation b Start the TFTP server If the computer is properly connected, there is no configuration ... running-config to TFTP server a Before copying the files, verify that the TFTP server is running b Record the IP address of the TFTP server c Issue the command copy...

Ngày tải lên: 21/12/2013, 19:15

... Copyright Cisco LAN Switching Configuration Handbook Steve McQuerry, David Jansen, David Hucaby Copyright © 2009 Cisco Systems, Inc Published by: Cisco Press 800 East 96th Street ... The Netherlands Cisco has more than 200 offices worldwide Addresses, phone numbers, and fax numbers are listed on the Cisco Website at www .cisco. com/go/offices CCDE, CCENT, Cisco Eos, Cisco...

Ngày tải lên: 15/01/2014, 16:37

... log-input deny ip any host 25 5 .25 5 .25 5 .25 5 log-input deny ip host 25 5 .25 5 .25 5 .25 5 any log-input deny ip 22 4.0.0.0 15 .25 5 .25 5 .25 5 any log-input deny ip any 22 4.0.0.0 15 .25 5 .25 5 .25 5 log-input deny tcp ... your “nat” & “static” commands nat (inside) 10.1.0.0 25 5 .25 5.0.0 500 50 nat (dmz) 1 72. 16.0.0 25 5 .25 5 .25 2.0 500 50 static (dmz,outside) 20 0 .20...

Ngày tải lên: 24/01/2014, 10:20

... sensor(config-Host-tim-sum)# recurringparams sensor(config-Host-tim-sum-rec)# summertimezonename PDT sensor(config-Host-tim-sum-rec)# exit sensor(config-Host-tim-sum)# exit ... (Release) 200 3-0 1-2 3T02:00:2 5-0 600 2003_Jan_23_02.00 (Release) 200 3-0 1-2 3T02:00:2 5-0 600 2003_Jan_23_02.00 (Release) 200 3-0 1-2 3T02:00:2 5-0 600 2003_Jan_23_02.00 (Release) 200 3-0 1-...

Ngày tải lên: 23/10/2015, 18:05

... click on the Cisco IDS Event Viewer icon on the desktop to launch the IEV OR choose Start>Programs >Cisco Systems >Cisco IDS Event Viewer >Cisco IDS Event Viewer The Cisco IDS Event Viewer application ... other IDS appliance events that have been generated You have successfully completed this Lab when you have updated the IDS appliance system software...

Ngày tải lên: 23/10/2015, 18:05

... Configuration of the IDS Appliance To this lab, the IDS appliance should be configured as per Lab (Cisco Intrusion Detection System (IDS) Appliance Initial Configuration) and Lab (Cisco IDS Appliance Software ... identifier of the IDS appliance IP address 10.0.0.1 The IP address of the IDS appliance Netmask 255.255.255.0 The subnet mask of the IDS appliance...

Ngày tải lên: 23/10/2015, 18:05