Design and investigation of reflectivity based optofluidic devices

... Chapter Reflectivity based optofluidic switch based on cascading prisms Chapter Reflectivity based optofluidic switch based on cascading prisms 3.1 Conceptual design and optical principle for the optofluidic ... [1][3-8] Optofluidic technology also enables the mass implementation of the optics compartments in current state -of- the-art optofluidic devices In the...

Ngày tải lên: 30/09/2015, 06:05

... Res Lett (2008) 3:416–420 design can be employed as memory cells We also develop a continuum model in this paper to analyze the proposed NEMS memory cell design Design of Memory Cells Figure illustrates ... used as a random access memory (RAM) cell It should be noted that Kang and Hwang [16] proposed the similar NEMS design, called ‘Carbon nanotube shuttle’ memory device Ho...

Ngày tải lên: 22/06/2014, 01:20

... attempts to develop a new network management and data collection framework for heterogeneous wireless sensor networks called as Heterogeneous Wireless Sensor Networks Management System (H-WSNMS), which ... WSNs Wireless Sensor Networks XML Extensible Mark-up Language xi ABSTRACT Yu, Qun M.S., Purdue University, August, 2010 Design and Implementation...

Ngày tải lên: 24/08/2014, 10:50

Ngày tải lên: 14/11/2014, 06:22

... DESIGN AND FABRICATION OF SUPERJUNCTION POWER MOSFET DEVICES CHEN YU (M.Eng., Xi’an Jiaotong University, P.R.China) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF PHILOSOPHY DEPARTMENT OF ... structures of Polysilicon Flanked superjunction, Oxide-bypassed (OB) superjunction and Graded oxide by-passed (GOB) superjunction were designed to overcome the fabrication...

Ngày tải lên: 14/09/2015, 14:12

... percentages and results of the assay 3-4 Chapter Design of Bead- based Microfluidic Device CHAPTER 4 DESIGN OF BEAD- BASED MICROFLUIDIC DEVICE 4.1 Introduction A microfluidic device offers numerous ... Applications of microfluidic devices and focus of research in this thesis 2) Advantages of microfluidic devices and aim to improve multiplexing capab...

Ngày tải lên: 30/09/2015, 06:04

... iii Abstract Interactions between laser and carbon nanotubes (CNTs) were investigated with a focused laser beam system Phenomena of sustained laser- induced incandescence (LII) and laser- induced ... single-walled CNTs [17,18], etching [19] and filling [20] of CNTs, magnetic measurements [21,22], purification of CNTs [23] and etc Recent developments and potential app...

Ngày tải lên: 11/09/2015, 10:05

... results of dielectric properties of these two varactors and thin films prove the feasibility of application of Bi1.5 Zn1.0 Nb1.5 O7 thin film into microwave tunable devices vii List of Figures ... 29 Lift-off method for fabrication of patterned Ba 0.5 Sr0.5TiO thin films…………………………………………………………… 29 2.3.1 Chapter3 Fabrication of patterned Ba 0.5 Sr0.5TiO thin...

Ngày tải lên: 04/10/2015, 10:26

... DESIGN AND DEVELOPMENT OF MEDICAL ELECTRONIC INSTRUMENTATION DESIGN AND DEVELOPMENT OF MEDICAL ELECTRONIC INSTRUMENTATION A Practical Perspective of the Design, Construction, and Test of Medical ... synchronize the inflation and deflation of pressure suits adaptively to gain an increase in the level of gravitational accelerations that...

Ngày tải lên: 29/03/2014, 11:20

... potentially accelerate decision-making with regard to extubation; and to assess the safety and feasibility of our approach Materials and method The intervention was carried out in a 14-bed medical/surgical ... evidence-based medicine into the setting of the ICU by promoting a multidisciplinary approach to extubation, and to design a protocol that was acceptab...

Ngày tải lên: 12/08/2014, 18:21

... ABSTRACT IDENTIFICATION, DESIGN AND SYNTHESIS OF OXYGENATED HYDROCARBON-BASED CO2-SOLUBLE POLYMERS FOR CHEMICAL AND PETROLEUM ENGINEERING APPLICATIONS Lei Hong, Ph.D University of Pittsburgh, 2006 ... defended on March 29, 2006 and approved by Dr Eric J Beckman, Professor, Chemical and Petroleum Engineering Department Dr J Karl Johnson, Professor, Chem...

Ngày tải lên: 13/11/2014, 10:49

... SIMULINK/MODELSIM CO -SIMULATION OF SENSORLESS SPEED CONTROL FOR PMSM DRIVE In Fig.1, it shows the sensorless speed control block diagram for PMSM drive and its Simulink/ModelSim cosimulation architecture ... work-3 of ModelSim in Fig.4 respectively performs the function of speed estimation and speed loop adaptive PI controller, the function of curre...

Ngày tải lên: 02/08/2015, 13:21

... ANALYSIS, DESIGN AND IMPLEMENTATION OF HIGH PERFORMANCE CONTROL SCHEMES IN RENEWABLE ENERGY SOURCE BASED DC/ AC INVERTER FOR MICRO- GRID APPLICATION SOUVIK DASGUPTA (M.Engg., Bengal Engineering ... injected into the grid Pgrid Average power injected into the grid PL , QL Active and reactive power consumption of load Pinv , Qinv Active and reac...

Ngày tải lên: 09/09/2015, 18:56

... of stimuli- responsive polymers are temperature -responsive polymers and pH -responsive polymers Other types of stimuli- responsive polymers, such as light -responsive polymers, field -responsive polymers ... methodologies for synthesis of stimuli- responsive polymers and the techniques for preparation of smart polymer based nanoparticles In Chapter 3, well-de...

Ngày tải lên: 10/09/2015, 08:43

... Improvement in the Design and Operation of Bio- reactors and Bio- separators Based on SMB Technology Zhang Yan (M Eng., Tianjin University, P R C) A THESIS SUBMITTED FOR THE DEGREE OF DOCTOR OF ... stimulates the application of SMB technology in this field Therefore, this section will focus on the developments and applications of SMB in...

Ngày tải lên: 15/09/2015, 17:10