Supply chain modeling and simulation using agents

... for supply chain modeling framework and the advantage of agent-based modeling in supply chain studies We have done a comprehensive literature review on agent-based modeling of supply chain and ... in supply chain modeling, Tasks and Sub-Processes represent supply chain plans and activities Sequence Flows connect Activities and present the linkage of differ...

Ngày tải lên: 09/09/2015, 11:30

... 12 Modeling and Simulation of Microbial Depolymerization Processes of Xenobiotic Polymers 12.4.2 Analysis of Enzymatic PLA Depolymerization The experimental and analytical study of endogenous depolymerization ... HPLC profiles of PEG before and after the cultivation of the microbial consortium E-1 [11, 12] 289 290 12 Modeling and Simulation of Mic...

Ngày tải lên: 25/10/2013, 08:20

... watering  Maintenance:- weed control, fertilizing, pruning and thinning, fire and pest protection  Inflows:wood; commercial thinning, final harvest non-wood; flora gathering, recreation, land ... Evaluation Criteria The Land Expectation Value(LEV) model is applied in preference to the NPV model Key Parameters in Forestry Models Establishment:- land, land preparation, plant stock,...

Ngày tải lên: 23/03/2014, 04:20

... classes of uncertainty: logical ambiguity and detection uncertainty Their sources and ways to represent them are described below Event Modeling and Recognition using Markov Logic Networks Incomplete ... a weight wi and a feature fi defined as follows fi (x{i} ) = 1, if Fi (x{i} ) is true, = 0, otherwise (1) Event Modeling and Recognition using Markov Logic...

Ngày tải lên: 23/03/2014, 13:20

... Network Modeling and Simulation for the Practicing Engineer Jack Burbank, William Kasch, Jon Ward AN INTRODUCTION TO NETWORK MODELING AND SIMULATION FOR THE PRACTICING ENGINEER Jack Burbank William ... relatively constant over the transmission of the message From Table 2-3, the IEEE 802.11 b and g channel bandwidth both exceeds and is below the...

Ngày tải lên: 02/04/2014, 15:49

... Dibble Combustion J Warnatz · U Maas · R.W Dibble Combustion Physical and Chemical Fundamentals, Modeling and Simulation, Experiments, Pollutant Formation 4th Edition With 227 Figures and 22 ... ways, and storage in data banks Duplication of this publication or parts thereof is permitted only under the provisions of the German Copyright Law of September 9, 1965, in its cu...

Ngày tải lên: 02/04/2014, 15:49

... presented in Fig 11 Figures 11 a and 11 b present the calculations and the experimental data from Silva (2000), respectively Fig 11 Adsorption and desorption steps from simulation results (a) and experiments ... Fuel Cells 17 Justo Lobato, Pablo Cañizares, Manuel A Rodrigo and José J Linares Chapter Numerical Analysis of Heat and Mass Transfer in a Fin -and- Tube Air...

Ngày tải lên: 19/06/2014, 10:20

... 20 40 jOL,oxygen / mA cm -2 1,418.9 1 ,27 2.1 1, 029 .8 jOL,air / mA cm -2 9 52. 8 786.6 5 62. 2 Rmt / ohm cm2 0.744 1.041 1.5 02 Table Limiting current densities for oxygen and air operation, and the mass ... shows the gases (H2, O2, air and water vapour) permeability of the different carbon support For its calculation, Equation must be used 24 Heat and Mass Transfer –...

Ngày tải lên: 19/06/2014, 10:20

... / % 73. 9 72.2 72.2 69.2 67 Mean pore diameter / m 36 .69 34 .32 33 . 23 32.10 30 .50 33 Tortuosity 3. 3 63 3.502 3. 717 4.152 4.620 Table Values of the overall porosity, mean pore size diameter and tortuosity ... Applied Electrochemistry, Vol 32 , No 4, pp 38 3 -38 8, ISSN : 0021-891X 38 Heat and Mass Transfer – Modeling and Simulation Appleby, A.J & Foulkes F.R...

Ngày tải lên: 19/06/2014, 10:20

... flow rate (3), heat flow rate (5),fin efficiency (67) Fig The global calculation algorithm for heat and mass transfer models 54 Heat and Mass Transfer – Modeling and Simulation 2.5 Heat performance ... 245 -286 Kazeminejad, H (1995) Analysis of one-dimensional fin assembly heat transfer with dehumidification, Int J of Heat mass transfer, 38-3, 45 5 -46 2 ...

Ngày tải lên: 19/06/2014, 10:20

... that heat and mass transfer is fast on the CuO/ZnO/Al2O3 catalytic coating than the conventional fixed bed catalyst, especially in micro-reactors 78 Heat and Mass Transfer – Modeling and Simulation ... temperature of 453 K, rate of △X changed from fast to slow with inlet velocity; at 453 K, rate of △X represented a linearly variation; however, at 82 Heat and Mass...

Ngày tải lên: 19/06/2014, 10:20