... pound-force (lbf avoirdupois) pound-force-inch pound-force-foot pound-force-foot/inch pound-force-inch/inch pound-force/inch pound-force/foot pound-force/foot2 pound-force/inch2 (psi) pound-force-second/foot2 ... of this title as follows: Standard handbook for mechanical engineers 1st-ed.; 1916– New York, McGraw-Hill v Illus 18–24 cm Title varies: 1916–58; Mechanical engineers h...
Ngày tải lên: 09/03/2014, 00:20
handbook for electrical engineers hu (2)
... case 3.1.8 Instrument Transformers The material that follows is a brief summary of information on instrument transformers as measurement elements For more extensive information, consult American ... C57.13, Requirement for Instrument Transformers; American National Standards Institute; American National Standard C12, Code for Electricity Metering; Electrical Meterman’s Handbook, Edis...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (3)
... unity for vacuum to slightly greater than unity for gases at atmospheric pressure, to for common insulating solids and liquids, 35 for ethyl alcohol and 91 for pure water, and 1000 to 10,000 for ... Fire-refined copper is a lower-purity grade intended for alloying or for fabrication into products for mechanical purposes; it is not intended for electrical purposes Casting...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (4)
... of the nth term Application of Performance Equations The equations of performance for the various portions of the NSSS may be used for mathematical analyses or for development of simulations Simulation ... produced for further fission action For a 1300-MW (electrical) light-water nuclear plant, a representative core assembly might involve 241 fuel assemblies each weighing approximat...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (5)
... Standard Handbook of Powerplant Engineering New York: McGraw-Hill Kiameh, Philip 2003 Power Generation Handbook New York: McGraw-Hill 2003 Marks’ Electronic Standard Handbook for Mechanical Engineers ... often cause a thrust reversal Therefore, it is usually necessary to provide an “active” thrust bearing for normal loading and an “inactive” thrust bearing for reverse loading Th...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (6)
... The constant K is 234.5°C for copper, 242°C for silver-alloyed copper used for hollow conductors, and 225°C for electrical conductivity aluminum Discharge coolant method For directly cooled armature ... phase g ϭ electrical angle between slots qs ϭ electrical angle of skew Here, the relevant angles are stated in electrical terms The electrical angle is p times the physical...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (7)
... coil equal to V for a change of 108 linkages/s (Mx/s) for each turn of the coil, or E ϭ (⌬fT ϫ 10 –8)/t V If the flux lines are deformed by the motion of the coil conductor before they are broken, ... armature-core length, in K1 ϭ 18.5 for noncommutating-pole machines ϭ for machines with commutating-pole length ϭ Lr K2 ϭ 1.0 for machines using nonmagnetic bands ϭ 1.7 for machines u...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (8)
... Civil Engineers, 1995 WRP 1992, International Symposium on Hydrology and Water Resources Education and Training: The Challenges to Meet at the Turn of the XXI Century, (Chihuahua, Chihuahua, Mexico), ... main step-up transformer Smaller plants may only have provision for switching via a switchyard breaker on the high voltage side of the step-up transformer, the generator and transformer be...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (9)
... of K for Eq (10-58) High-voltage winding BIL, kV Self-cooled and water-cooled ratings Forced-air and forcedoil-forced-air-cooled 25% to 35% above self-cooled rating Forced-air and forced-oilforced-air-cooled ... the transformer bank FIGURE 10-31 Exciting transformer with taps in the secondary and a series transformer forming complete isolation for tap-changing equipment Tap-Changer Design...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (10)
... examined Market forecasts are provided for capacity, new projects, and annual revenue for the 2002 to 2008 time frame The forecasts cover national, regional, and world markets for both single-site ... recommended for their high efficiency of lumens per watt Batteries are required for PV lighting systems Deep cycle batteries specifically designed for PV applications should be used...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (11)
... use of each type of fuel Coal, for example, would include track networks for train transportation, river networks for barge transportation, and highway networks for truck transportation There ... solely for secondary heat conversion or for additional fuel combustion Such distributed generation, often called renewable sources, decreases the need for the electric transmission syst...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (12)
... projects qualify for one or more special tax subsidies called tax credits A tax credit can offset a tax otherwise owed to the government; the actual cash required for paying taxes is thus reduced ... owner faces Table 13-7 contains the data for the illustrations of financing effects in the remaining tables The payments for principal and interest are shown for a debt of $1000 to be r...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (13)
... Touch perception for 50% of women Grip perception for 1% of women Touch perception for 50% of men Grip perception for 1% of men Grip perception for 50% of women Grip perception for 50% of men Startle ... 2ഛdഛ6 For each phase, the L5 noise level is given by AN5 ϭ Ϫ665 g ϩ 20 log n ϩ 44 log d Ϫ 10 log D Ϫ 0.02 D ϩ AN0 ϩ K1 ϩ K2 (14-27) with AN0 ϭ ϭ K1 ϭ ϭ 75.2 67.9 7.5 2.6 for n...
Ngày tải lên: 21/03/2014, 12:12
handbook for electrical engineers hu (14)
... in a common tank for each 12-pulse converter bridge For larger converters, three, single-phase transformers with double secondary windings may be used for each 12-pulse bridge For the largest ... developed for communications outages In a bipolar system, a master control is used for coordinated schedule changes and calculation of the current orders for each pole The master contro...
Ngày tải lên: 21/03/2014, 12:12