Tài liệu hướng dẫn sử dụng biến tần danfoss 5

... Programming 3 4 5 10 11 12 14 14 14 14 14 14 15 15 15 15 15 16 16 17 17 18 18 18 19 20 21 21 23 24 24 25 26 26 26 26 28 MG.28.A7.22 - VLT is a registered Danfoss trademark VLT® ... 2822-2840 380-480 Volt MG.28.A7.22 - VLT is a registered Danfoss trademark VLT® 2800 Series s Motor coils (19 5N 311 0) s RFI 1B filter (19 5N 310 3) s Terminal cover The drawing below...

Ngày tải lên: 08/08/2014, 03:20

... registered Danfoss trademark 11 VLT® 28 00 Series s Electrical installation VLT 28 22 200 -24 0 V, 28 22- 2840 380-480 V VLT 28 03 -28 15 20 0 -24 0 V, 28 05 -28 15 380-480 V 12 MG .28 .A7 .22 - VLT is a registered Danfoss ... 12 MG .28 .A7 .22 - VLT is a registered Danfoss trademark VLT® 28 00 Series VLT 28 80 -28 82 380-480V Installation VLT 28 40 20 0 -24 0 V, 28 55 -2...

Ngày tải lên: 08/08/2014, 03:20

... jog.) Par 0 13 Local control must be set to [3] or [4] and parameter 2 03 Reference/feedback range to [0]: RefMIN - RefMAX (par 204-205) ✭ 000,000.000 Par 0 13 Local control must be set to [3] or [4] ... parameter 0 13 Local control is set at Local control and open loop [1] or Local control as parameter 100 [3] Parameter 200 Output frequency range is set at Both directions [4] parameter 0...

Ngày tải lên: 08/08/2014, 03:20

... parameter 41 6 Process units Feedback [unit]: Gives the resulting signal value using the unit/scaling selected in parameter 41 4 Minimum feedback, FBLOW, 41 5 Maximum feedback, FBHIGH and 41 6 Process ... value for use in communication via serial communication port 34 MG.28.A7.22 - VLT is a registered Danfoss trademark VLT® 2800 Series 0 24 User-defined Quick Menu (USER QUICK MENU) Va...

Ngày tải lên: 08/08/2014, 03:20

... [0] 2 05 Maximum reference, RefMAX (MAX.REFERENCE) Value: Par 100 Config = Open loop [0] Par 204 RefMIN - 1000.000 Hz ✭ 50 .000 Hz Par 100 Config = Closed loop [1]/[3] Par 204 RefMIN - Par 4 15 Max ... communication via serial communication port 42 MG.28.A7.22 - VLT is a registered Danfoss trademark VLT® 2800 Series 1 35 U/f-ratio (U/F RATIO) Value: 0.00 - 20.00 at Hz Description of cho...

Ngày tải lên: 08/08/2014, 03:20

... [4] [5] [6] ✭[7] [8] [9] [10] [11] [12] [13] [14] [15] [ 16] [17] [19] [20] [21] [22] [23] [24] [25] [ 26] [27] [0] [1] [2] [3] [4] [5] [6] [7] [8] ✭[9] [10] [11] [12] [13] [14] [15] [ 16] [17] [19] ... [25] [ 26] [27] [0] [1] [2] ✭[3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15] [ 16] [17] [19] [20] [21] [22] [23] [24] [25] [0] ✭[0] [1] [1] [2] [2] [3] [3] [4] [4] [5] [5] [6] [6] [7...

Ngày tải lên: 08/08/2014, 03:20

... in communication via serial communication port MG.28.A7.22 - VLT is a registered Danfoss trademark 67 VLT® 2800 Series NOTE Parameters 4 37- 444 are only used if in parameter 100 Configuration ... (GAL/S) Ft3/s (FT3/S) [0] [1] [2] [3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15] [16] [ 17] [18] [19] [20] [21] [22] [23] [24] [25] [26] [ 27] [28] [29] [30] Gal/min (GAL/MIN) Ft3/min...

Ngày tải lên: 08/08/2014, 03:20

... for use in communication via serial communication port 78 MG. 28. A7.22 - VLT is a registered Danfoss trademark VLT® 280 0 Series Parameter 5 38, Alarm word: Gives in Hex code which alarm is on the ... value for use in communication via serial communication port 72 MG. 28. A7.22 - VLT is a registered Danfoss trademark VLT® 280 0 Series Ser port 1 Logic or [3] Dig input 0 1 Function Coast...

Ngày tải lên: 08/08/2014, 03:20

... choice: Read out as one value 617 Fault log: Value (F.LOG: VALUE) Value: [Index - 10] Value: - 99 99 Programming Function: In this parameter it is possible to see at which value a trip occurred ... communication port MG.28.A7.22 - VLT is a registered Danfoss trademark 81 VLT® 2800 Series See also the DeviceNet manual MG .90 .BX.YY for further details 6 19 Reset Running Hours Counter (RES...

Ngày tải lên: 08/08/2014, 03:20

... 0.75 1.0 1.5 2.0 3.0 5.0 4 /10 4 /10 4 /10 4 /10 4 /10 4 /10 4 /10 Max cable cross section, [mm2/AWG] 1) motor Input current (1 x 220-240 V) Input current IL,N [A] 5.9 8.3 10. 6 14.5 15.2 - - IL,MAX (60s) ... Max pre-fuses 1) 5.0 7.5 10. 0 15.0 20.0 25.0 4 /10 4 /10 4 /10 16/6 16/6 16/6 37.5 IL,N [A] 8.1 10. 6 14.9 24.0 32.0 IL,MAX(60s)[A] 13.0 17.0 23.8 38.4 51.2 60 4 /10 4 /10...

Ngày tải lên: 08/08/2014, 03:20

... registered Danfoss trademark 11 VLT® 28 00 Series s Electrical installation VLT 28 22 200 -24 0 V, 28 22- 2840 380-480 V VLT 28 03 -28 15 20 0 -24 0 V, 28 05 -28 15 380-480 V 12 MG .28 .A7 .22 - VLT is a registered Danfoss ... 12 MG .28 .A7 .22 - VLT is a registered Danfoss trademark VLT® 28 00 Series VLT 28 80 -28 82 380-480V Installation VLT 28 40 20 0 -24 0 V, 28 55 -2...

Ngày tải lên: 13/05/2015, 20:56

... parameter 41 6 Process units Feedback [unit]: Gives the resulting signal value using the unit/scaling selected in parameter 41 4 Minimum feedback, FBLOW, 41 5 Maximum feedback, FBHIGH and 41 6 Process ... value for use in communication via serial communication port 34 MG.28.A7.22 - VLT is a registered Danfoss trademark VLT® 2800 Series 0 24 User-defined Quick Menu (USER QUICK MENU) Va...

Ngày tải lên: 13/05/2015, 20:56

... parameter 1 05 Motor current is set for rated motor current ✭ = factory setting () = display text [] = value for use in communication via serial communication port MG.28.A7.22 - VLT is a registered Danfoss ... communication via serial communication port 42 MG.28.A7.22 - VLT is a registered Danfoss trademark VLT® 2800 Series 1 35 U/f-ratio (U/F RATIO) Value: 0.00 - 20.00 at Hz Descriptio...

Ngày tải lên: 13/05/2015, 20:56

... [4] [5] [6] ✭[7] [8] [9] [10] [11] [12] [13] [14] [15] [ 16] [17] [19] [20] [21] [22] [23] [24] [25] [ 26] [27] [0] [1] [2] [3] [4] [5] [6] [7] [8] ✭[9] [10] [11] [12] [13] [14] [15] [ 16] [17] [19] ... [25] [ 26] [27] [0] [1] [2] ✭[3] [4] [5] [6] [7] [8] [9] [10] [11] [12] [13] [14] [15] [ 16] [17] [19] [20] [21] [22] [23] [24] [25] [0] ✭[0] [1] [1] [2] [2] [3] [3] [4] [4] [5] [5] [6] [6] [7...

Ngày tải lên: 13/05/2015, 20:56

... 0.75 1.0 1.5 2.0 3.0 5.0 4 /10 4 /10 4 /10 4 /10 4 /10 4 /10 4 /10 Max cable cross section, [mm2/AWG] 1) motor Input current (1 x 220-240 V) Input current IL,N [A] 5.9 8.3 10. 6 14.5 15.2 - - IL,MAX (60s) ... IL,MAX (60s) [A] 4.6 6.4 8.2 11.2 12.2 14.1 23.5 Max cable cross section, [mm2/AWG] 4 /10 4 /10 4 /10 4 /10 4 /10 4 /10 4 /10 1) power Max pre-fuses [A]/UL 2) [A] Efficien...

Ngày tải lên: 13/05/2015, 20:56