design and detailing of retaining walls

The Design and Implementation of a Log-Structured File System

The Design and Implementation of a Log-Structured File System

... separate data area is reserved for this purpose. The separate data area of these database systems means that they do not need the segment cleaning mechanisms of the Sprite LFS to reclaim log space. ... again. The bandwidth of each of the five phases is shown separately. Sprite LFS has a higher write bandwidth and the same read bandwidth as SunOS with the exception of...

Ngày tải lên: 12/09/2012, 15:05

15 1,4K 0
Design and development of major balance of plant components in solid oxide fuel cell system

Design and development of major balance of plant components in solid oxide fuel cell system

... Design and development of major balance of plant components in solid oxide fuel cell system Wen-Tang Hong 1 , Tzu-Hsiang Yen 2 , Cheng-Nan Huang 1 , Hsueh-I Tan 1 , Yu Chao 1 1 Institute ... and mass flow rate in the major BOP components so as to identify potential design improvements in the INER SOFC system in the future. In practice...

Ngày tải lên: 05/09/2013, 16:10

12 586 0
Real-Time Digital Signal Processing - Chapter 5: Design and Implementation of FIR Filters

Real-Time Digital Signal Processing - Chapter 5: Design and Implementation of FIR Filters

... filter Figure 5.23 Magnitude responses of the desired and actual FIR filters 220 DESIGN AND IMPLEMENTATION OF FIR FILTERS aligned below it. This flip -and- slide form of linear convolution can be illustrated ... and stopband ripples, the area under 208 DESIGN AND IMPLEMENTATION OF FIR FILTERS 5.2.2 Some Simple FIR Filters A multiband filter has more tha...

Ngày tải lên: 23/10/2013, 22:15

59 591 0
Design and Implementation of a Three-Phase Induction Motor Control Scheme

Design and Implementation of a Three-Phase Induction Motor Control Scheme

... where all parameters, processes and variables are modelled mathematically. Furthermore, the MATLAB program can convert a MATLAB design into a C-code design in a relatively straightforward manner. ... two types of induction motors: “the squirrel cage induction motor and the “wound motor . An explanation of the advantages and disadvantages of each is given. Essen...

Ngày tải lên: 27/10/2013, 23:15

93 695 1
Design and Simulation of A CMOS-MEMS Accelerometer

Design and Simulation of A CMOS-MEMS Accelerometer

... major parameters of the device. Only the ratio of parasitic capacitance and sensing capacitance can be measured, and the estimated value is calculated assuming a total sensing capacitance of 60fF. ... of 60fF. Parasitic capacitance and mismatch of sensing capacitance is measured in a way as shown in Figure 5.4. The capac- itance ratios are derived from the ratios of driv...

Ngày tải lên: 27/10/2013, 23:15

40 589 1
Real-Time Digital Signal Processing - Chapter 6: Design and Implementation of IIR Filters

Real-Time Digital Signal Processing - Chapter 6: Design and Implementation of IIR Filters

... resistor 248 DESIGN AND IMPLEMENTATION OF IIR FILTERS 6.6.3 Software Implementations As discussed in Chapter 1, the implementation of a digital filtering algorithm is often carried out on a general-purpose ... the fourth-order Butterworth IIR Table 6.3 List of floating-point C implementation of IIR filter /* exp6a.c À Direct-form II IIR function implementation...

Ngày tải lên: 28/10/2013, 05:15

62 722 0
Working with the Fogbow Design and reconfiguration of services and participation in e-Government

Working with the Fogbow Design and reconfiguration of services and participation in e-Government

... serve the needs of the visually impaired and children with reading and writing difficulties. I became the co- ordinator of a group of specialist teachers, class 19 teachers and others working with ... be, and is it the task of the investigation to determine the details of such support?’ 31 The accompanying memo also presented ongoing co-operation...

Ngày tải lên: 04/11/2013, 20:15

182 567 0
Tài liệu DESIGN AND DETAILING OF FLAT SLAB ESE SOEDARSONO HS 27 FEBRUARY 2002 pptx

Tài liệu DESIGN AND DETAILING OF FLAT SLAB ESE SOEDARSONO HS 27 FEBRUARY 2002 pptx

... area/ο < 0.25 l x Analysis of flat slab Analysis of flat slab DESIGN FOR BENDING INTERNAL PANELS ã columns and middle strips should be designed to withstand design moments from analysis ... 0.8 STRAIGHTENED DESIGN STRIP DESIGN STRIP IN ELEVATION Step 2 : define design strips in X & Y directions INTRODUCTION Flat slab Flat slab with drop panels Fla...

Ngày tải lên: 12/12/2013, 14:15

76 722 2
Tài liệu Design And Simulation Of A Cmos-Mems Accelerometer doc

Tài liệu Design And Simulation Of A Cmos-Mems Accelerometer doc

... estimated value is calculated assuming a total sensing capacitance of 60fF. Parasitic capacitance and mismatch of sensing capacitance is measured in a way as shown in Figure 5.4. The capac- itance ... first-generation accelerometer were performed on a probe station. Table 1 lists major parameters of the device. Only the ratio of parasitic capacitance and sensing capacitance...

Ngày tải lên: 22/12/2013, 08:16

40 581 0
Tài liệu 78 Rapid Design and Prototyping of DSP Systems docx

Tài liệu 78 Rapid Design and Prototyping of DSP Systems docx

... 64-point FFT and BW transmitting of a single SCI ring is 934.3 MBytes/sec which satisfies Eq. (78. 15). Using 5 i860s, the c  1999 by CRC Press LLC RapidDesignandPrototypingof DSPSystems T.Egolf,M.Pettigrew, J.Debardelaben,R.Hezar, S.Famorzadeh,A.Kavipurapu, M.Khan,Lan-RongDung, K.Balemarthy,N.Desai, Yong-kyuJung ,and V.Madisetti GeorgiaInstituteofTechnology 78. 1Introduction 78. 2Sur...

Ngày tải lên: 25/12/2013, 06:16

39 555 0
Tài liệu Experiences in Design and Implementation of a High Performance Transport Protocol doc

Tài liệu Experiences in Design and Implementation of a High Performance Transport Protocol doc

... Processing ã Memory copy avoidance ã Overlapped IO ã Data scattering/gathering ã Speculation of next packet Protocol Buffer Protocol Buffer User Buffer Data New Data Experiences in Design and Implementation ... if all the flows have the same end-to-end link capacity – Otherwise, any flow will obtain at least half of its fair share ã Does not take more bandwidth than conc...

Ngày tải lên: 15/01/2014, 15:59

32 581 0
Tài liệu Design and optimisation of conformal cooling channels in injection muolding tools docx

Tài liệu Design and optimisation of conformal cooling channels in injection muolding tools docx

... effectiveness of conformal cool- ing channels and selective laser sintering material in injection mould- ing tools, RPD (2002) 1–5. [6] F. Jacobs, High-conductivity Materials and Conformal Cooling Channels, ... produced. The main objective of this study was to determine an optimum and efficient design for conformal cooling/ heating channels in the configuration...

Ngày tải lên: 12/02/2014, 22:20

7 728 0
Tài liệu The Design and Performance of a Real-time CORBA Event Service doc

Tài liệu The Design and Performance of a Real-time CORBA Event Service doc

... event- based, real-time applications. In prac- tice, however, the standard CORBA Event Service specifica- tion lacks other important features required by real-time ap- plications such as real-time event ... program- ming tasks, such as object registration, location, and acti- vation; request demultiplexing; framing and error-handling; parameter marshalling and demarshall...

Ngày tải lên: 19/02/2014, 18:20

20 738 0
w