seismic design of liquid-containing concrete structures

... 1 - 2 Overview of the Program 1 Overview of the Program SAP2000 is a stand-alone finite-element-based structural program for the analysis and design of civil structures. It offers an intuitive, ... Assign, Analyze, Display and Design. These listed menus contain the commands that will be needed most often when using SAP2000, and many of the most frequently used comman...

Ngày tải lên: 06/09/2012, 15:56

... AAC masonry, in. (mm) K c = coefficient of creep of masonry, per psi (MPa) k e = coefficient of irreversible moisture expansion of clay masonry k t = coefficient of thermal expansion of masonry, ... standard for the design of masonry buildings in seismic areas [1.21]. 1.5 UNREINFORCED AND REINFORCED MASONRY Unreinforced masonry has been in use in the United State...

Ngày tải lên: 17/08/2013, 11:41

Ngày tải lên: 13/02/2014, 20:20

... is one of only two major bridges designed by Lutyens. 1 The nature of design 1.1 Design and analysis The origin of the word design is the Latin ‘designare’, to draw. In classical times, the stability ... spans; the need for a family of columns to cater for other bridges forming part of the same project; the architectural context of the bridge. As th...

Ngày tải lên: 18/02/2014, 18:20

... h1" alt=""

Ngày tải lên: 23/03/2014, 20:34

Ngày tải lên: 28/03/2014, 18:20

... following types of linear analysis are available:  Static: The most common type of analysis. Loads are applied without dynamical effects.  Modal Analysis: Calculation of dynamic modes of the structure ... as data organized in a set of tables with specified table names and column headings. These data include the definition of the model and the results of anal...

Ngày tải lên: 01/04/2014, 03:20

Ngày tải lên: 27/06/2014, 17:20

... ã Design of Joint Shear Reinforcement 38.1 Introduction This chapter provides an overview of the concepts and methods used in modern seismic design of reinforced concrete bridges. Most of ... by CRC Press LLC 38 Seismic Design of Reinforced Concrete Bridges 38.1 Introduction Two-Level Performance-Based Design ã Elastic vs. Ductile Design ã Capaci...

Ngày tải lên: 08/07/2014, 12:20

... Ductile seismic retrofit of steel deck-truss bridges. ΙΙ: design appli- cations, J. Struct. Eng. ASCE, 124 (11), 1263–1271,1998. 56. Sarraf, M. and Bruneau, M., Ductile seismic retrofit of steel ... strength of the brace as determined above. F y F y φ φ λ â 2000 by CRC Press LLC 39 Seismic Design of Steel Bridges 39.1 Introduction Seismic Performance Criteri...

Ngày tải lên: 08/07/2014, 12:20

... w0 h1" alt=""

Ngày tải lên: 07/08/2014, 10:20

... 5) modulus of elasticity of concrete modulus of elasticity of concrete at transfer of stress modulus of elasticity of prestressing strand modulus of elasticity of steel flexural stiffness of compression ... 343 on Concrete Bridge Design, provide currently acceptable guidelinesfor the analysis and design of reinforced, prestressed, and partially prestres...

Ngày tải lên: 24/10/2014, 16:04

... 350 Environmental Engineering Concrete Structures SEISMIC DESIGN OF LIQUID-CONTAINING CONCRETE STRUCTURES 350.3/350.3R-1 Seismic Design of Liquid-Containing Concrete Structures (ACI 350.3-01) and Commentary ... Provi- sions for Seismic Design, ” in order to provide a set of thorough and comprehensive procedures for the seismic analysis and design of all...

Ngày tải lên: 24/10/2014, 22:00

... UNIVERSITY OF CALIFORNIA, SAN DIEGO Development of Load and Resistance Factor Design for FRP Strengthening of Reinforced Concrete Structures A dissertation ... Overview 1 1.2 FRPs for Strengthening of Civil Structures 1 1.2.1 Fiber Reinforced Polymer Composites 1 1.2.2 Strengthening and Repair of Civil Structures 2 1.2....

Ngày tải lên: 14/11/2014, 13:32