design and construction of drilled piers

... 15 minutes of fire exposure. This may require fireproofing of the control DESIGN AND CONSTRUCTION OF LPG INSTALLATIONS 3 4 Design of LPG Vessels 4.1 APPLICABLE DESIGN CONSTRUCTION ... Standards Body: e API 2510: Design and Construction of LPG Installations 49 CFR 195.205(b)(3) American Petroleum Institute 22 API STANDARD 2510 flexibil...

Ngày tải lên: 27/03/2014, 14:08

... and Subtitle 5. Report Date December 2009 6. Performing Organization Code TECHNICAL MANUAL FOR DESIGN AND CONSTRUCTION OF ROAD TUNNELS – CIVIL ELEMENTS 7. Author(s) 8. Performing ... single-source technical manual providing guidelines for planning, design, construction and rehabilitation of road tunnels, and encompasses various types...

Ngày tải lên: 30/08/2014, 22:32

... Copy, â BSI BS 5588- 4: 1978 ii â BSI 01-1999 Foreword This new code of practice was prepared under the direction of the Fire Standards Committee. In addition to the existing BS 5588- 1.1, BS 5588- 2, ... the release of the pressurizing air. In buildings having an arrangement for the release of the pressurizing air that relies on the automatic op...

Ngày tải lên: 28/09/2014, 23:27

... fire. BS 5588, Fire precautions in the design and construction of buildings. BS 5588- 1, Residential buildings. BS 5588- 1.1, Code of practice for single-family dwelling houses 3) . BS 5588- 1.2, ... use of adhesive tape should not be relied upon for the long-term sealing of ducts. The layout of the ductwork and the sizing of the main duct or...

Ngày tải lên: 28/09/2014, 23:27

... clause38 of BS5 306-1:1976), and inspection of the firefighting lift (seeBS5 655 -10). e) Annually, operational testing of the firefighting lift controls as described inC.1, and verification of the ... recommended in BS5 58 8-1. d) Where the firefighting shaft contains a firefighting lift, the firefighting shaft should contain a fire main. e) Firefig...

Ngày tải lên: 28/09/2014, 23:28

... references American Concrete Institute 307-69 Specification for the Design and Construction of Reinforced Concrete Chimneys 307-88 Standard Practice for the Design and Construc- tion of Cast-in-Place Reinforced ... Reinforced Concrete Chimneys 318 Building Code Requirements for Structural Concrete 505-54 Standard Specification for the Design and Con- struct...

Ngày tải lên: 24/10/2014, 15:45

... 313R-1 This Commentary presents some of the considerations and assumptions of ACI Committee 313 in developing the provisions of the Standard Practice for Design and Construction of Concrete Silos and Stacking ... and curing Chapter 4 Design, p. 313R-4 R4.1—Notation R4.2—General Commentary on Standard Practice for Design and Construction of...

Ngày tải lên: 24/10/2014, 15:45

... 307-1 This standard gives material, construction, and design requirements for cast-in-place and precast reinforced concrete chimneys. It sets forth mini- mum loadings for design and contains ... p. 307-15 Design and Construction of Reinforced Concrete Chimneys (ACI 307-98) Reported by ACI Committee 307 ACI 307-98 David J. Bird Chairman Victor A. Bochicchio...

Ngày tải lên: 24/10/2014, 15:46

... areas and access for delivery vehicles. The design and construction of concrete slabs for parking lots and outside storage areas share many similarities with the design and construction of streets ... Performance and Design of GUIDE FOR DESIGN AND CONSTRUCTION OF CONCRETE PARKING LOTS 330R-21 Plain Concrete Pavement,” Highway Research Re...

Ngày tải lên: 24/10/2014, 15:47

... protection and curing 3.8—Lining and coating Standard Practice for Design and Construction of Concrete Silos and Stacking Tubes for Storing Granular Materials (ACI 313-97) ACI 313-97 Mostafa H. ... con- crete silos and stacking tubes for storing granular materials. Silos for storing of ensilage have different requirements and are no...

Ngày tải lên: 24/10/2014, 16:04

... 2—Materials, p. 373R-97-5 2.1 Concrete 2.2—Shotcrete and filler materials 2.3—Admixtures Design and Construction of Circular Prestressed Concrete Structures with Circumferential Tendons Reported by ... the wall. 1.2—Objective The objective of this report is to provide guidance in the design and construction of circular prestressed concrete structure...

Ngày tải lên: 24/10/2014, 17:26

... A—Recommendations and considerations related to the design and construction of tank foundations, p. 372R-20 CHAPTER 1—GENERAL 1.1—Introduction The design and construction of circular prestressed concrete structures ... concrete and prestressed concrete design and construction given in ACI 318-99, ACI 350-01, and ACI 301. Design and construction...

Ngày tải lên: 24/10/2014, 17:26

... 371R-5 3.1—General 3.2—Concrete 3.3—Formwork 3.4—Reinforcement 3.5—Concrete finishes 3.6—Tolerances 3.7—Foundations 3.8—Grout Guide for the Analysis, Design, and Construction of Concrete-Pedestal Water Towers Reported ... ASTM A 497 are permitted for reinforcement resisting other forces, and for shrinkage and temperature steel. 371R-1 5GUIDE FOR CONCRETE-PED...

Ngày tải lên: 24/10/2014, 17:26

... B.11- Other factors criteria PREFACE Concrete structures have been used in the North Sea and other offshore areas of the world. With the rapid expansion of knowledge of the behavior of concrete structures ... for consideration by the designer. The design of offshore structures requires much creativity of the designer, and it is intended that th...

Ngày tải lên: 24/10/2014, 17:40

... determine construction methods, scope of observation and quality control. The design and installation of drilled piers are multi- phase tasks in which proper quality control and quality assurance in construction ... critical influence on design and construction. Therefore, relevant aspects of soil mechan- ics are also discussed herein. For the successful design a...

Ngày tải lên: 24/10/2014, 21:58