presentation design of superstructure
The Secrets of Compelling Presentation Design ppt
... of Compelling Presentation Design sliderocket.com A collection of guides for designing stunning presentations. The Secrets of Compelling Presentation Design SlideRocket eBook: The Secrets of ... of the best ways to gauge how successful it truly was. The Secrets of Compelling Presentation Design SlideRocket eBook: The Secrets of Compelling Presentaon Design 11 T...
Ngày tải lên: 17/03/2014, 12:20
SAP2000® Linear and Nonlinear Static and Dynamic Analysis and Design of Three-Dimensional Structures
... 1 - 2 Overview of the Program 1 Overview of the Program SAP2000 is a stand-alone finite-element-based structural program for the analysis and design of civil structures. It offers an intuitive, ... Property Type for Add area of the form. Scroll down the list of import options until you find Import Double Angle – see Figure 7. Single click on it. D. In the Click to area o...
Ngày tải lên: 06/09/2012, 15:56
SAP2000 Integrated Finite Elements Analysis and Design of Structures
... Select Mode. 24. Click the roof beam at the top of the braced frame to select it. Also click the joint at the top of the chevron brace (center of braced frame roof beam) to select it. 25. From ... C-10 to enter the last roof beam. The model now appears as shown in Figure C-11. Figure C-11: Model After All Roof Level Beams Have Been Drawn 18. Select all of the roof level frame elements...
Ngày tải lên: 06/09/2012, 15:56
The design of mat foundations
... being designed for a small office building with a total live load of 250 kips and dead load of 500 kips. Find: (a) the depth D f for a fully compensated foundation, (b) the depth D f if a soft ... of the clay layer, z/B = 18 ft / 40 ft = 0.45 and L/B = 60 ft / 40 ft = 1.50 2) At the middle of the clay layer, z / B = 22 ft / 40 ft = 0.55 and L/B = 60 ft / 40 ft = 1.50 3) At the botto...
Ngày tải lên: 16/10/2012, 10:43
DESIGN OF REINFORCED MASONRY STRUCTURES
... the strength design philosophy for the design of concrete structures, and load and resistance factor design (LRFD) for the design of steel structures. Readers of the first edition of this book ... inertia of cracked cross-sectional area of member, in. 4 (mm 4 ) I eff = effective moment of inertia of member, in. 4 (mm 4 ) I g = moment of inertia of gross (or unc...
Ngày tải lên: 17/08/2013, 11:41
the presentation secrets of st
... tangible product, find other ways outside of the slide deck to show it off. On October 14, 2008, Steve introduced a new line of MacBooks carved out of one piece of aluminum, a “unibody enclosure.” ... Keynote software in 2002, so what are we to make of the extraordinary presentations Jobs gave dating back to 1984? The software is not the answer. The fact that Steve Jobs uses Key...
Ngày tải lên: 25/08/2013, 22:10
Novel design of a compacted micro-structured air-breathing PEM fuel cell as a power source for mobile phones
... the design and optimization of future fuel cells to improve their lifetime with a much higher power density and lower cost. The analysis offers valuable physical insight towards design of a ... cells in terms of design, materials, effective transport of reactants, and heat management. The development of physically representative models that allow reliable simulation of the...
Ngày tải lên: 05/09/2013, 14:58
Optimal design of PEM fuel cells to generate maximum power: A CFD study
... introduction of cheaper materials and fabrication techniques, and the design and development of novel architectures [3-6]. Comprehensive models rely on the determination of a large number of properties ... However, these disadvantages are typically outweighed by the benefit of being able to assess the influence of a greater number of design parameters and their associated...
Ngày tải lên: 05/09/2013, 14:58
Novel design of a disk-shaped compacted micro-structured air-breathing PEM fuel cell
... Optimal design of PEM fuel cells to generate maximum power: A CFD study. International Journal of Energy and Environment, 2011; 2(6), 953-962. [19] Maher A.R. Sadiq Al-Baghdadi. Novel design of ... cells in terms of design, materials, effective transport of reactants, and heat management. The development of physically representative models that allow reliable simulation...
Ngày tải lên: 05/09/2013, 14:58
A study on oral presentation difficulties of second year english majors of phuong dong university in the speaking lessons and solutions
... of Speaking 6 1.3.2. Types of Classroom Speaking Performance 9 1.4. Oral Presentations 10 1.4.1. Definition and Characteristics 10 1.4.2. The Importance of Oral Presentations 11 1.4.3. Oral presentation ... topics for the fourth term for PDU majors of English Appendix 3: Samples of model presentations Appendix 4: Suggested models of language for an oral presentation Appendix 5...
Ngày tải lên: 07/09/2013, 13:02