all in one cisco ccie lab study guide second edition phần 3 pptx

... STATUS = ACTIVE, INTERFACE = Serial0/0 input pkts 33 output pkts 31 in bytes 32 10 out bytes 31 50 dropped pkts 2 in FECN pkts 0 in BECN pkts 0 out FECN pkts 0 out BECN pkts 0 in DE pkts 0 out ... value for traffic shaping frame−relay mincir 1000 ← Define a minimum CIR value for traffic shaping ! line con 0 line aux 0 line vty 0 4 login ! end Monitoring and Testing the Conf...

Ngày tải lên: 14/08/2014, 13:20

... Se0: 23, Channel (1 31 ) Activated dsl 0 State (0=Idle 1=Propose 2=Busy 3= Reserved 4=Restart 5=Maint) 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 0 3 3 3 3 3 3 3 3 Channel (1 31 ) Service (0=Inservice ... 7 23: 43: 41: BR1/0:1 LCP: MRRU 1524 (0x110405F4) *Mar 7 23: 43: 41: BR1/0:1 LCP: EndpointDisc 1 Local (0x 130 5015 232 ) *Mar 7 23: 43: 41: BR1/0:1 LCP: I CONFACK [ACKsent] id...

Ngày tải lên: 14/08/2014, 13:20

... subinterface type point−to−point. A subinterface is a logical way of defining an interface. The same physical interface can be split into multiple logical interfaces; this was originally created to ... protocols Routing Protocol is "igrp 64" Sending updates every 5 seconds, next due in 1 seconds Invalid after 15 seconds, hold down 15, flushed after 30 Outgoing update filter lis...

Ngày tải lên: 14/08/2014, 13:20

... with neighbor 3. 3 .3. 3 (Backup Designated Router) Suppress hello for 0 neighbor(s) RouterC#show ip ospf int loopback 0 Loopback0 is up, line protocol is up Internet Address 3. 3 .3. 3/24, Area 0 ... variance. RouterA#configure terminal RouterA(config)#router eigrp 64 RouterA(config−router)#no variance From RouterA, display the route to host 3. 3 .3. 3 with the command show ip route 3...

Ngày tải lên: 14/08/2014, 13:20

... exercise: One Cisco router with one serial interface• One Cisco router with an Ethernet interface• One Cisco router with two serial interfaces• One Cisco router with one Ethernet and two serial interfaces• ... Ethernet interface• One Cisco router with two serial interfaces• One Cisco router with one Ethernet and two serial interfaces• One Cisco router with tw...

Ngày tải lên: 14/08/2014, 13:20

... Name/status 1 33 32 232 c3620−i−mz_1 13 8_T1.bin ← Single IOS image in the router's flash [33 32296 bytes used, 134 44920 available, 16777216 total] ← 16MB flash total, 3. 3MB used, 13. 4MB available 1 638 4K ... 1 .3 3.1(1) 3. 1(1) 5 00−10−7b−09−9a−50 thru 00−10−7b−09−9a−5b 1.1 3. 1(1) 3. 1(1) 7 00−10−7b−3d−be−f0 thru 00−10−7b−3d−bf−07 1 .3 3.1(1) 3. 1(1) 10 00−10−7b−3d...

Ngày tải lên: 14/08/2014, 13:20

... remote extension number 33 33 session target ipv4: 135 .25 .3. 1 ← Extension 33 33 is reachable at 135 .25 .3. 1 ! dial−peer voice 3 pots destination−pattern 22 23 ← Extension 33 33 is assigned to physical ... that dialing 33 33 will establish a VoIP call to the target address 135 .25 .3. 1. RouterA#show dialplan number 33 33 Macro Exp.: 33 33 VoiceOverIpPeer2 information ty...

Ngày tải lên: 14/08/2014, 13:20

... 10.1.1.1:4 195.1.1 .3: 4 195.1.1 .3: 4 icmp 195.1.1.1 :3 10.1.1.1 :3 195.1.1 .3: 3 195.1.1 .3: 3 icmp 195.1.1.1:2 10.1.1.1:2 195.1.1 .3: 2 195.1.1 .3: 2 icmp 195.1.1.1:1 10.1.1.1:1 195.1.1 .3: 1 195.1.1 .3: 1 icmp 195.1.1.1:0 ... 10.1.1.1:4 195.1.1 .3: 4 195.1.1 .3: 4 create 00:01 :31 , use 00:00 :31 , left 00:00:28, flags: extended icmp 195.1.1.1 :3 10.1.1.1 :3 195.1.1 .3: 3 195.1.1 .3:...

Ngày tải lên: 14/08/2014, 13:21

... establishes and maintains sessions between an AppleTalk client and a server. • Zone Information Protocol: The Zone Information Protocol maintains network number to zone name mappings in zone information ... appletalk zone accounting ← Define the primary AppleTalk zone to be accounting appletalk zone service ← Define the secondary AppleTalk zone to be service appletalk zone TopSecret ← De...

Ngày tải lên: 14/08/2014, 13:21