... a commercial backup product, you have the option
of putting the stacker into random-access mode and allowing the backup product to control
it. (Control of automated backup hardware is almost ... looked at any single point in time. You
could restore the first file to how it looked at 10:15, and the second file to how it looked at
11:05. However, they need to be restored together. If...
... command is not a backup command used by most people. It is a very low-level
command and is designed for copying bits of information from one place to another. It does not
have any knowledge of ... version of
cpio, as is the ability to use remote devices.
Option: specifying the output mode (o)
The o option is one of the three modes of cpio (o, i, and p) and is the one used for creat...
... the
basic "boot" information. The main part of this block is the location on the disk where the
kernel is stored. This block of boot information, or boot block, is stored outside, or "in ... for your particular version.) This command performs a chroot to /root, then
reads /etc/lilo.conf to determine what to put in the master boot block. It then rebuilds the boot
block for you....
... member from v$logfile ;
To create an ''undo" option, copy each of these files to filename.bak.
After making a backup of the online redolog files, run the following command on a mounted,
closed ... the control files before doing
any of this. That offers an "undo" option that isn't possible otherwise. (Also
make copies of the online redologs as well.)
With the na...
... 95 472.
Editor: Gigi Estabrook
Production Editor: Clairemarie Fisher O& apos;Leary
Printing History:
November 199 9: First Edition.
Nutshell Handbook, the Nutshell Handbook logo, and the O& apos ;Reilly logo ... publisher assumes no
responsibility for errors or omissions, or for damages resulting from the use of the information
their alignment if stored in that position for too long. (C...
... AMANDA
After downloading and unpacking the AMANDA release, read the README, docs/INSTALL,
and docs/SYSTEM.NOTES files. They contain important and up-to-date information about how
to set up AMANDA.
Install ... restore the backup drive normally will be given a
list of instructions like the following:
1. Position to block 1000
2. Read one block of data
3. Position to block 1003
4. Read o...
... Seriously, though, the reason it is so difficult is that you need a
good SA and a good DBA to design a good backup plan. Most people know only one side
well. If you or your people know both sides, ... backups
Configuration Options
Gives the user access to various configuration options for local access, remote services,
etc.
Tape Drives
Then you can reboot to single-user mode by going to t...
... server
VOBS='cleartool lsvob -host $HOST¦sed 's/*//' ¦awk '{print $1}''
case $1 in
lock )
for VOB in $VOBS ; do
# (Lock VOBS)
cleartool lock -c 'VOB backups in progress' ... it for each transaction dump.
load transaction baddbname from '/dev/nrmt0'
For more information on how to load dumps and transaction logs, please refer to
'&apos...