Intro to Marine Engineering 2E Episode 1 ppsx

Intro to Marine Engineering 2E Episode 1 ppsx

Intro to Marine Engineering 2E Episode 1 ppsx

... Burlington, MA 018 03 First published 19 83 Reprinted 19 85 Second edition 19 90 Reprinted 19 92 ,19 93 ,19 94 Revised 19 % Reprinted 19 98 (twice), 19 99,2000 (twice), 20 01, 2002,2003 © 19 96, ... propellers 200 12 Steering gear 211 13 Fire fighting and safety 2 31 14 Electrical equipment 253 15 Instrumentation and control 279 16 Engineering ma...

Ngày tải lên: 13/08/2014, 16:22

30 300 0
Intro to Marine Engineering 2E Episode 12 ppsx

Intro to Marine Engineering 2E Episode 12 ppsx

... in Figure 16 .1. If testing Fracture Strain Figure 16 .1 Stress strain curve Engineering materials 3 31 burning process. The iron ore is reduced to iron and falls to the base ... small amounts to increase strength and resistance to fatigue. Tungsten added at between 12 and 18 %, together with up to 5% chromium, produces high speed steel. .S32...

Ngày tải lên: 13/08/2014, 16:22

30 292 0
Intro to Marine Engineering 2E Episode 2 pot

Intro to Marine Engineering 2E Episode 2 pot

... engines Fuel entry Non return valve Timing / valve To fuel valve Sliding rod Lever Cam Figure 2 .15 Timing valve The fuel injector A typical fuel injector is shown in Figure 2 ,16 , It can be seen to be two basic ... points in the machinery space. A separate piston cooling system is used to limit any contamination from piston cooling glands to the piston...

Ngày tải lên: 13/08/2014, 16:22

30 219 0
Intro to Marine Engineering 2E Episode 3 pptx

Intro to Marine Engineering 2E Episode 3 pptx

... provide one to two hours' notice to enable the turbines to be brought down to manoeuvring revolutions. A diesel alternator will have to be started, the turbo- alternator shut ... provides steam to act on the dummy piston which is mounted on the turbine rotor (Figure 3.7). The rotor casing provides the cylinder to enable the steam pressure t...

Ngày tải lên: 13/08/2014, 16:22

30 230 0
Intro to Marine Engineering 2E Episode 4 pps

Intro to Marine Engineering 2E Episode 4 pps

... failure. Feed systems 10 1 Economiser (Condenser} v, *Alr X and vapour Recirculating line ' "** ~1 -**- -If- ," .« 1 I* ,jr Boiler ^n h\ F 1 71- Air ejector Drains <-<>wP«*sure cooler ... use, e.g. the steam -to- steam generator, the double evaporation boiler and various exhaust gas boiler arrangements. The steam -to- steam generator Steam -to- s...

Ngày tải lên: 13/08/2014, 16:22

30 270 0
Intro to Marine Engineering 2E Episode 5 doc

Intro to Marine Engineering 2E Episode 5 doc

... firemain Carbon steel to BS36 01 — galvanised Bilge and ballast Carbon steel to BS36 01 - galvanised Control air Copper Starting air Carbon steel to BS 3602 Auxiliaries 13 7 and without ... systems Hypochlorinator Figure 6. 21 Domestic water treatment Carbon De-chlorinator Freshwater drain Pumps and pumping systems 11 5 Pump types There are three main classe...

Ngày tải lên: 13/08/2014, 16:22

30 222 0
Intro to Marine Engineering 2E Episode 6 ppt

Intro to Marine Engineering 2E Episode 6 ppt

... pump 11 Sanitary pump 12 Accumulator 13 Control panel 14 Sullage tank 15 Overflow 16 Overboard discharge 17 Deck discharge to shore facility 18 External flushing water supply 19 ... 14 9 Char EfinwMtor Charrad Paper Efcrinator. Rotating Rabbte Shaft Combustion Air Met Liquid Waste Burner Rabbte Hades Contra) Panel Sight Glass Ash Hopper Figure...

Ngày tải lên: 13/08/2014, 16:22

30 243 0
Intro to Marine Engineering 2E Episode 8 docx

Intro to Marine Engineering 2E Episode 8 docx

... arranged to prevent the entry of sea water and also the loss of lubricating oil from the stern bearing. 11 12 13 14 15 IS 17 13 19 20 12 3 4S678&1O ai 22 Figure 11 .7 Controllable 1 ... housing 10 Retracting plate 11 Piston 12 Bridge piece 13 Plunger 14 Spring 15 Case nuts and bolts 16 Shaft sleeve 17 Needle bearing...

Ngày tải lên: 13/08/2014, 16:22

30 174 0
Intro to Marine Engineering 2E Episode 9 pps

Intro to Marine Engineering 2E Episode 9 pps

... element (Figure 13 .3). Heat detectors are used in places such as the galley and laundry where other types of detector would give off false alarms. 11 Figure 13 .3 Heat detector Alarm Associated ... stop valve Drain v valve T Flushing 1 valve Non return valve Strainer f Deck main stop valve Foam hydrants Sea water Automatic inductor unit Fire Foam making solution...

Ngày tải lên: 13/08/2014, 16:22

30 191 0
w