Marine Auxiliary Machinery 7E Episode 12 doc

... on the tank top in the machinery space, or above the machinery and over such vulnerable auxiliaries as the oil fuel plant and any other surface in the machinery compartment over ... been flooded with Halon 1301. In some small machinery spaces Halon 1301 systems may be found in which the Halon is stored in a sphere within the machinery space. In larger...

Ngày tải lên: 13/08/2014, 16:21

... Publication Data Marine Auxiliary Machinery - 7 lh rev. edn I. McGeorge, H. David 0623.8 Library of Congress Cataloguing in Publication Data McCeorge, H. D. Marine Auxiliary Machinery/ H. ... evaporation of sea water. From the outlet of the Figure 1.9 Turbulent flow of a fluid Marine Auxiliary Machinery Main propulsion services and heat exchangers 27...

Ngày tải lên: 13/08/2014, 16:21

... and pipelines 129 The self-regulating valve can be replaced by an automatic process control valve for fluid pressure control as used for control functions in unmanned machinery spaces. ... suction side the type of reducer shown at B, could be used. Valves and pipelines 125 Figure 4 .12 Flap check valve (Blakeborough and Sons Ltd.) 1. Cover 5. Seat...

Ngày tải lên: 13/08/2014, 16:21

... Blade sealing ring 18. End cover auxiliary servomotor 4. Bearing ring 19. Pitch control auxiliary 30. Reducing valve 5. Hub body servomotor assembly (auxiliary servomotor) 6. Servometer ... no-stroke, the auxiliary pumps dischar. to the reservoir via a pressure-limiting valve PC20, set at 20 bar, and to t purnp casings. When the main pumps are on-stroke, the...

Ngày tải lên: 13/08/2014, 16:21

... full flow to the hydraulic Index Actuators, valve, 127 Auxiliary boiler combustion system, 70-3 Aeration plants (sewage), 108-11 Auxiliary diesel engines, 215-30 Aerobic bacteria, ... transmitter, 494-5 cargo handling, 406 12 e-line, 60 cranes, 408 12 Elsan chemical recirculating system, 108, electric drives, 392, 393-5 109 hatch covers, 412- 15 Emergency bilg...

Ngày tải lên: 13/08/2014, 16:21

... be considered necessary or a drier using refrigeration. Figure 2 .12 Centrifuges arranged in series (courtesy Alpha-Laval) Machinery service systems and equipment 55 ignited by a naked ... and Scholes, I .R. (1972) Titanium in marine engineering, Trans I Mar E, 84, paper 16. Conde, ]. F. G. (1985) New materials for the marine and offshore industry, Trans...

Ngày tải lên: 13/08/2014, 16:21

... accumulates in machinery space bilges, the discharge overboard must be via the oily/water separator and usually with the use of the special bilge pump, i.e. the auxiliary bilge ... quantities of raw sewage into restricted waters such as those of inland waterways and enclosed docks, will cause rapid depletion of any oxygen in the water so that aerobic bacteria a...

Ngày tải lên: 13/08/2014, 16:21

... vertically in the pumproom with a turbine, or in some ships, electric motor drive from the machinery space. The drive shaft passes through the engine room bulkhead via a gas seal. Rate ... for condenser circulating duties, especially in conjunction with a scoop injection (Figure 1 ,12) where the motion of the ship under normal steaming conditions is Figure 5...

Ngày tải lên: 13/08/2014, 16:21

... deck. Auxiliary power 227 Figure 7.9 Sleeve-metered fuel injection pump (Caterpillar Tractor Co.) 1. Reverse flow check valve 6. Retainer 11. Lifter 2. Chamber 7. Plunger 12. ... when discharging cargo since the auxiliary boiler will be supplying steam to cargo pumps and perhaps a turbo-alternator. At sea with the oil fired auxiliary boiler shut down,...

Ngày tải lên: 13/08/2014, 16:21

... expansion. New seals are fitted by cutting and vulcanizing in position. 234 Auxiliary power Figure 7.14 Auxiliary condensing turbine (Peter Brotherhood Ltd) 1. Pedestal end bearing ... The permissible wear is in the region of 9 12 mm on large diameter shafts. The examination of the type of tailshaft described above requires removal of Auxiliary power 233 Fi...

Ngày tải lên: 13/08/2014, 16:21