CCNA INTRO Exam Certification Guide - Part 7 PENDIX doc

... commonly treat the network and subnet parts of an address as a single part, leaving only two parts, the subnet and host parts. On the exam, the multiple-choice format should provide extra clues ... instead. 26. Two different IOS files are in a router’s Flash memory: one called c2500-j-l.11 1-3 .bin and one called c2500-j-l.11 2-1 4.bin. Which one does the router use when it boots up?...

Ngày tải lên: 13/08/2014, 13:21

... tftp b. copy tftp running-config c. copy running-config start-up-config d. copy start-up-config running-config e. copy startup-config running-config f. copy running-config startup-config 6. What mode prompts ... IOS Software 191 Figure 7- 7 Getting into Setup Mode Example 7- 5 shows a screen capture of using setup mode after booting a router with no configuration in NVRAM. Example 7- 5 Router Setup...

Ngày tải lên: 13/08/2014, 13:21

... The concepts, protocols, and devices covered on the CCNA exam are used to help build the network cloud shown in Figure 1-1 . However, the CCNA exam focuses on technology that is used to build ... connected to a network via some cable. Figure 1-1 shows the basic end-user perspective of networking. Figure 1-1 End-User Perspective on Networks The top part of the figure shows a...

Ngày tải lên: 13/08/2014, 13:21

... will be on your INTRO exam, a well-prepared CCNA candidate should know, at a minimum, all the details in each “Foundation Summary” section before going to take the exam. Table 2-6 summarizes the ... RJ-45 connector for an Ethernet connection, Ethernet and RJ-45 physical layer specifications are used. Table 2-5 OSI Reference Model—Example Protocols Layer Name Examples Application...

Ngày tải lên: 13/08/2014, 13:21

... 2003 3:53 PM Foundation Summary 71 Figure 3-1 6 Crossover Ethernet Cable Full-duplex Ethernet cards can send and receive concurrently. Figure 3-1 7 shows the full- duplex circuitry used with a ... switch. Figure 3-1 7 10BASE-T Full-Duplex Operation Table 3-9 summarizes some of the key points as they relate to what is covered in this initial section of the chapter. Table 3-9...

Ngày tải lên: 13/08/2014, 13:21

... Speed* OC-1 52 Mbps OC-3 155 Mbps OC-12 622 Mbps OC-48 2.4 Gbps OC-192 9.6 Gbps OC -7 6 8 40 Gbps 0945_01f.book Page 101 Wednesday, July 2, 2003 3:53 PM 82 Chapter 4: Fundamentals of WANs Figure 4-1 Example ... Connector EIA/TIA-232 TIA 25 EIA/TIA-449 TIA 37 EIA/TIA-530 TIA 25 V.35 ITU 34 X.21 ITU 15 Service Provider End User Device DTE DCE Router Connections EIA/TIA-232 EIA/TIA-449 V.35...

Ngày tải lên: 13/08/2014, 13:21

... 16 ,77 7,214 b. 16 ,77 7,216 c. 65,536 d. 65,534 e. 65,532 f. 32 ,76 8 g. 32 ,76 6 h. 32 ,76 4 9. How many valid host IP addresses does each Class C network contain? a. 65,536 b. 65,534 c. 65,532 d. 32 ,76 8 e. ... subnetting. Figure 5-5 illustrates a more realistic example that uses basic subnetting. Figure 5-5 Using Subnets As in Figure 5-4 , the design in Figure 5-5 requires six g...

Ngày tải lên: 13/08/2014, 13:21

... Chapter 6: Fundamentals of TCP and UDP Figure 6-1 4 shows an example of a TCP connection-establishment flow. Figure 6-1 4 TCP Connection Establishment Table 6 -7 contrasts typical transport layer functions ... on your CCNA exam, a well-prepared CCNA candidate should know, at a minimum, all the details in each “Foundation Summary” section before going to take the exam. The terms co...

Ngày tải lên: 13/08/2014, 13:21

... running-config tftp b. copy tftp running-config c. copy running-config start-up-config d. copy start-up-config running-config e. copy startup-config running-config f. copy running-config startup-config 5. ... LAN Switches Figure 8-1 295 0-2 4-EI Switch This particular model comes with 24 built-in 10/100 ports using RJ-45 connectors. Any of the ports can be used to connect to end-user devices or to...

Ngày tải lên: 13/08/2014, 13:21

... interface states, for the INTRO exam. Refer to Chapter 2, “Spanning Tree Protocol,” of the CCNA ICND Exam Certification Guide for a detailed discussion on STP. Table 9-5 STP: Reasons for Forwarding ... 9: Cisco LAN Switching Basics Figure 9-1 3 Broadcast Domains Table 9 -7 summarizes the reasons STP places a port in forwarding or blocking state. Table 9 -7 STP: Reasons for Forw...

Ngày tải lên: 13/08/2014, 13:21